G. V. Ravi Prasad
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
G. V. Ravi Prasad has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
Alexander Cherkinsky
Univ Georgia, Ctr Appl Isotope Studies, 120 Riverbend Rd, Athens, GA 30602 USA
4 shared publicationsDoug Dvoracek
Center for Applied Isotope Studies, University of Georgia, Athens, GA, USA
3 shared publications- Koushik Dutta
Institute of Physics
3 shared publications Randy Culp
Center for Applied Isotope Studies, University of Georgia, 120 Riverbend Rd., Athens, GA 30602, USA
3 shared publicationsJohn E Noakes
2 shared publications- Randy Culp
University of Georgia
2 shared publications
Latest Publications
- 21 December 2022
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 535, 221-226
Identifying the sources of beam transmission loss of carbon isotopes
- 21 December 2022
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 535, 221-226
Identifying the sources of beam transmission loss of carbon isotopes
- 23 July 2019
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 61 (5) , 1573-1579
Effect of Beam Transmission of Stable Isotopes on Online δ13C for SSAMS
It is known that 12C beam transmission through the accelerator decreases at high beam currents. This effect depends on machine design and varies across different types of AMS instruments. For beam currents of about 100 μA, the effect is small on the 500 kV tandem CAMS unit, whereas beam saturation is observed for similar high beam currents on the 250 kV SSAMS unit. While this effect is very evident for high 12C beam currents, we have also observed that even the 13C beam is found to suffer modest transmission loss with beam current. As a result, the 13C/12C ratio does not remain constant with beam current. By correcting for the effects of 12C beam saturation and decreased 13C transmission, we have obtained online δ13C values that are more accurate and precise at moderately high beam currents for SSAMS.
- 23 July 2019
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 61 (5) , 1573-1579
Effect of Beam Transmission of Stable Isotopes on Online δ13C for SSAMS
It is known that 12C beam transmission through the accelerator decreases at high beam currents. This effect depends on machine design and varies across different types of AMS instruments. For beam currents of about 100 μA, the effect is small on the 500 kV tandem CAMS unit, whereas beam saturation is observed for similar high beam currents on the 250 kV SSAMS unit. While this effect is very evident for high 12C beam currents, we have also observed that even the 13C beam is found to suffer modest transmission loss with beam current. As a result, the 13C/12C ratio does not remain constant with beam current. By correcting for the effects of 12C beam saturation and decreased 13C transmission, we have obtained online δ13C values that are more accurate and precise at moderately high beam currents for SSAMS.
- Open Access
- 12 February 2013
- Published by Springer Nature in Journal of Earth System Science
- Vol. 122 (1) , 173-185
Paleoenvironmental significance of clay mineral assemblages in the southeastern Arabian Sea during last 30 kyr
- 12 February 2013
- Published by Springer Nature in Journal of Earth System Science
- Vol. 122 (1) , 173-185
Open AccessPaleoenvironmental significance of clay mineral assemblages in the southeastern Arabian Sea during last 30 kyr
- 1 January 2013
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 55 (2) , 319-324
The New 250kV Single Stage AMS System at CAIS, University of Georgia: Performance Comparison with a 500kV Compact Tandem Machine
A new 250kV single stage AMS accelerator (SSAMS) was installed at the Center for Applied Isotope Studies, University of Georgia. The accelerator is intended to be used primarily for radiocarbon measurements of natural and biobased samples, while all other samples such as marine, geological, atmospheric and archaeological samples are measured on the decade-old 500kV compact tandem accelerator (CAMS). The new AMS system is equipped with a 134-cathode MC-SNICS ion source. In this article, we show the results of the tests carried out on standards and blanks and compare the performance of the new machine with that of the CAMS unit. We have also compared the stable isotope data from AMS measurements to the conventional isotope ratio mass spectrometers (IRMS) data.
- 1 January 2013
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 55 (2) , 319-324
The New 250kV Single Stage AMS System at CAIS, University of Georgia: Performance Comparison with a 500kV Compact Tandem Machine
A new 250kV single stage AMS accelerator (SSAMS) was installed at the Center for Applied Isotope Studies, University of Georgia. The accelerator is intended to be used primarily for radiocarbon measurements of natural and biobased samples, while all other samples such as marine, geological, atmospheric and archaeological samples are measured on the decade-old 500kV compact tandem accelerator (CAMS). The new AMS system is equipped with a 134-cathode MC-SNICS ion source. In this article, we show the results of the tests carried out on standards and blanks and compare the performance of the new machine with that of the CAMS unit. We have also compared the stable isotope data from AMS measurements to the conventional isotope ratio mass spectrometers (IRMS) data.
- 1 January 2013
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 294, 46-49
A decade of AMS at the University of Georgia
- 1 January 2013
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 294, 46-49
A decade of AMS at the University of Georgia
- Open Access
- 1 January 2013
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 55 (3–4) , 1819-1826
Present-Day Radiocarbon Content of Select Flavoring Compounds Reveals Vanillin Production Pathway
Radiocarbon and stable isotope determination in foods, flavors, and beverages, for the authentication of source material and process of formation, is a well-established method of identity used in industry. New methods of provenance determination, using stable isotopes of oxygen and hydrogen, have added to the host of other isotopic methods used for characterizing natural or botanically derived products. The unambiguous determinant of a product’s fossil fuel origin be it from petroleum, natural gas, or coal, is through the measurement of its 14C content. The 14C content can also be used to determine the fraction dilution of recently grown and harvested material with that derived from fossil fuel, and even confirms the vintage of agricultural products based on the well-established decrease of bomb-produced atmospheric 14C. This paper documents 14C measurements at the University of Georgia’s Center for Applied Isotope Studies accelerator mass spectrometry and stable isotope laboratories, over the last 3 yr, for 10 important flavoring compounds. By establishing an accurate and current level of 14C in botanically derived products, we were able to confirm a particular source for vanilla production, the most popular consumer flavor in the marketplace. Over the years, vanilla extract has been produced less and less from vanilla beans (Vanilla planifolia), particularly those from Madagascar and the Comoros Islands, and more from other botanical precursors such as ferulic acid, clove oil, and guaiacol. We report isotopic data to support this precursor for vanilla production based on high 14C levels accumulated during the tree’s life, incorporated in the tree rings and their associated stable isotope abundances. DOI: 10.2458/azu_js_rc.55.16302
- 1 January 2013
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 55 (3–4) , 1819-1826
Open AccessPresent-Day Radiocarbon Content of Select Flavoring Compounds Reveals Vanillin Production Pathway
Radiocarbon and stable isotope determination in foods, flavors, and beverages, for the authentication of source material and process of formation, is a well-established method of identity used in industry. New methods of provenance determination, using stable isotopes of oxygen and hydrogen, have added to the host of other isotopic methods used for characterizing natural or botanically derived products. The unambiguous determinant of a product’s fossil fuel origin be it from petroleum, natural gas, or coal, is through the measurement of its 14C content. The 14C content can also be used to determine the fraction dilution of recently grown and harvested material with that derived from fossil fuel, and even confirms the vintage of agricultural products based on the well-established decrease of bomb-produced atmospheric 14C. This paper documents 14C measurements at the University of Georgia’s Center for Applied Isotope Studies accelerator mass spectrometry and stable isotope laboratories, over the last 3 yr, for 10 important flavoring compounds. By establishing an accurate and current level of 14C in botanically derived products, we were able to confirm a particular source for vanilla production, the most popular consumer flavor in the marketplace. Over the years, vanilla extract has been produced less and less from vanilla beans (Vanilla planifolia), particularly those from Madagascar and the Comoros Islands, and more from other botanical precursors such as ferulic acid, clove oil, and guaiacol. We report isotopic data to support this precursor for vanilla production based on high 14C levels accumulated during the tree’s life, incorporated in the tree rings and their associated stable isotope abundances. DOI: 10.2458/azu_js_rc.55.16302
- Open Access
- 1 January 2013
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 55 (3)
The New 250kV Single Stage AMS System at CAIS, University of Georgia: Performance Comparison with a 500kV Compact Tandem Machine
A new 250kV single stage AMS accelerator (SSAMS) was installed at the Center for Applied Isotope Studies, University of Georgia. The accelerator is intended to be used primarily for radiocarbon measurements of natural and bio-based samples, while all other samples such as marine, geological, atmospheric and archaeological samples are measured on the decade-old 500kV compact tandem accelerator (CAMS). The new AMS system is equipped with a 134-cathode MC-SNICS ion source. In this article, we show the results of the tests carried out on standards and blanks and compare the performance of the new machine with that of the CAMS unit. We have also compared the stable isotope data from AMS measurements to the conventional isotope ratio mass spectrometers (IRMS) data.DOI: 10.2458/azu_js_rc.55.16292
- 1 January 2013
- Published by Cambridge University Press (CUP) in Radiocarbon
- Vol. 55 (3)
Open AccessThe New 250kV Single Stage AMS System at CAIS, University of Georgia: Performance Comparison with a 500kV Compact Tandem Machine
A new 250kV single stage AMS accelerator (SSAMS) was installed at the Center for Applied Isotope Studies, University of Georgia. The accelerator is intended to be used primarily for radiocarbon measurements of natural and bio-based samples, while all other samples such as marine, geological, atmospheric and archaeological samples are measured on the decade-old 500kV compact tandem accelerator (CAMS). The new AMS system is equipped with a 134-cathode MC-SNICS ion source. In this article, we show the results of the tests carried out on standards and blanks and compare the performance of the new machine with that of the CAMS unit. We have also compared the stable isotope data from AMS measurements to the conventional isotope ratio mass spectrometers (IRMS) data.DOI: 10.2458/azu_js_rc.55.16292
- 1 June 2010
- Published by Springer Nature in Journal of Earth System Science
- Vol. 119 (3) , 285-295
Shift in detrital sedimentation in the eastern Bay of Bengal during the late Quaternary
- 1 June 2010
- Published by Springer Nature in Journal of Earth System Science
- Vol. 119 (3) , 285-295
Shift in detrital sedimentation in the eastern Bay of Bengal during the late Quaternary
- 1 December 2008
- Published by Elsevier in Atmospheric Environment
- Vol. 42 (40) , 9123-9127
Retrospective assessment of indoor radon exposure by measurements of embedded 210Po activity in glass objects
- 1 December 2008
- Published by Elsevier in Atmospheric Environment
- Vol. 42 (40) , 9123-9127
Retrospective assessment of indoor radon exposure by measurements of embedded 210Po activity in glass objects
- 1 April 2008
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 266 (8) , 1833-1836
Radiocarbon AMS at IOP: System improvements and dating of groundwater from Bhadrak district, Orissa
- 1 April 2008
- Published by Elsevier in Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms
- Vol. 266 (8) , 1833-1836
Radiocarbon AMS at IOP: System improvements and dating of groundwater from Bhadrak district, Orissa