Mohamed Hachemi Chahbani
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mohamed Hachemi Chahbani has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
D. Tondeur
4 shared publications- Amenallah Guizani
Center for Energy Research and Technology (CRTEn)
3 shared publications Imed Houcine
2 shared publicationsJ. Paris
2 shared publications- Jalel Labidi
Chemical and Environmental Engineering Department, University of the Basque Country UPV/EHU, Donostia-San Sebastián, Spain
2 shared publications M. Balghouthi
2 shared publications
Latest Publications
- Open Access
Preparation and Evaluation of a Coconut Shell-Based Activated Carbon for CO2/CH4 Separation
Biomass is a widely distributed and renewable source of carbon. The main objective of this work is to produce an activated carbon from coconut shells with suitable characteristics to separate CO2 from biogas. The textural characterization of the adsorbent has been determined. Pure component adsorption isotherms of CO2 and CH4 at 30, 50 and 70 °C have been measured. The results reveal that the activated carbon had high CO2 adsorption capacity. Equilibrium of adsorption of CO2 and CH4 adsorption on the produced activated carbon reached 8.36 mmol/g and 4.63 mmol/g, respectively, at 30 °C and 10 bars. Moreover, the performance of the produced activated carbon, as a potential adsorbent for CO2 capture from a CO2/CH4 gas mixture, has been evaluated under dynamic conditions in a dedicated fixed-bed setup. The CO2 and CH4 adsorption capacities of the produced activated carbon are estimated to be 1.86 and 0.52 mol/kg, respectively, at 30 °C and 1 bar.
Open AccessPreparation and Evaluation of a Coconut Shell-Based Activated Carbon for CO2/CH4 Separation
Biomass is a widely distributed and renewable source of carbon. The main objective of this work is to produce an activated carbon from coconut shells with suitable characteristics to separate CO2 from biogas. The textural characterization of the adsorbent has been determined. Pure component adsorption isotherms of CO2 and CH4 at 30, 50 and 70 °C have been measured. The results reveal that the activated carbon had high CO2 adsorption capacity. Equilibrium of adsorption of CO2 and CH4 adsorption on the produced activated carbon reached 8.36 mmol/g and 4.63 mmol/g, respectively, at 30 °C and 10 bars. Moreover, the performance of the produced activated carbon, as a potential adsorbent for CO2 capture from a CO2/CH4 gas mixture, has been evaluated under dynamic conditions in a dedicated fixed-bed setup. The CO2 and CH4 adsorption capacities of the produced activated carbon are estimated to be 1.86 and 0.52 mol/kg, respectively, at 30 °C and 1 bar.
- 1 February 2018
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 6 (1) , 338-355
Simulation and experimental results of a PSA process for production of hydrogen used in fuel cells
- 1 February 2018
- Published by Elsevier in Journal of Environmental Chemical Engineering
- Vol. 6 (1) , 338-355
Simulation and experimental results of a PSA process for production of hydrogen used in fuel cells
- Open Access
- 12 October 2017
- Published by Bentham Science Publishers Ltd. in The Open Chemical Engineering Journal
- Vol. 11 (1) , 33-52
Modeling and Simulation of Pressure Equalization Step Between a Packed Bed and an Empty Tank in Pressure Swing Adsorption Cycles
Background: : It is of paramount importance to pay a great attention when modeling pressure equalization step of pressure swing adsorption cycles for its notable effect on the accurate prediction of the whole cycle performances. Studies devoted to pressure equalization between an adsorption bed and a tank have been lacking in the literature. Many factors could affect the accuracy of the dynamic simulation of pressure equalization between a bed and an empty tank. Methods: : The method used for the equilibrium pressure evaluation has a significant impact on simulation results. The exact equilibrium pressure (Peq) obtained when connecting an adsorption column and an empty tank could only be obtained by numerical simulation given the complexity of the set of partial differential equations. Results: : It has been shown that, with some simplifying assumptions, one can analytically determine Peq with satisfactory precision. The analytical solution proposed permits to assess rapidly the equilibrium pressure and the equilibrium mole fraction of the adsorbable species in the tank (Yeq) and without the need to resort to a cubersome modeling. Conclusion: : Based on the comparisons presented, one can conclude that the agreement between the experimental and numerical results relative to Peq and Yeq is very satisfactory.
- 12 October 2017
- Published by Bentham Science Publishers Ltd. in The Open Chemical Engineering Journal
- Vol. 11 (1) , 33-52
Open AccessModeling and Simulation of Pressure Equalization Step Between a Packed Bed and an Empty Tank in Pressure Swing Adsorption Cycles
Background: : It is of paramount importance to pay a great attention when modeling pressure equalization step of pressure swing adsorption cycles for its notable effect on the accurate prediction of the whole cycle performances. Studies devoted to pressure equalization between an adsorption bed and a tank have been lacking in the literature. Many factors could affect the accuracy of the dynamic simulation of pressure equalization between a bed and an empty tank. Methods: : The method used for the equilibrium pressure evaluation has a significant impact on simulation results. The exact equilibrium pressure (Peq) obtained when connecting an adsorption column and an empty tank could only be obtained by numerical simulation given the complexity of the set of partial differential equations. Results: : It has been shown that, with some simplifying assumptions, one can analytically determine Peq with satisfactory precision. The analytical solution proposed permits to assess rapidly the equilibrium pressure and the equilibrium mole fraction of the adsorbable species in the tank (Yeq) and without the need to resort to a cubersome modeling. Conclusion: : Based on the comparisons presented, one can conclude that the agreement between the experimental and numerical results relative to Peq and Yeq is very satisfactory.
- 1 October 2012
- Published by Elsevier in Applied Energy
- Vol. 98, 138-148
Investigation of a solar cooling installation in Tunisia
- 1 October 2012
- Published by Elsevier in Applied Energy
- Vol. 98, 138-148
Investigation of a solar cooling installation in Tunisia
- 18 February 2010
- Published by Elsevier in Separation and Purification Technology
- Vol. 71 (2) , 225-232
Predicting the final pressure in the equalization step of PSA cycles
- 18 February 2010
- Published by Elsevier in Separation and Purification Technology
- Vol. 71 (2) , 225-232
Predicting the final pressure in the equalization step of PSA cycles
- 1 September 2008
- Published by Elsevier in Building and Environment
- Vol. 43 (9) , 1459-1470
Feasibility of solar absorption air conditioning in Tunisia
- 1 September 2008
- Published by Elsevier in Building and Environment
- Vol. 43 (9) , 1459-1470
Feasibility of solar absorption air conditioning in Tunisia
- 1 November 2005
- Published by Elsevier in Desalination
- Vol. 185 (1-3) , 105-110
Solar Powered air conditioning as a solution to reduce environmental pollution in Tunisia
- 1 November 2005
- Published by Elsevier in Desalination
- Vol. 185 (1-3) , 105-110
Solar Powered air conditioning as a solution to reduce environmental pollution in Tunisia
- 1 February 2004
- Published by Elsevier in Applied Thermal Engineering
- Vol. 24 (2-3) , 431-447
Modeling of adsorption heat pumps with heat regeneration
- 1 February 2004
- Published by Elsevier in Applied Thermal Engineering
- Vol. 24 (2-3) , 431-447
Modeling of adsorption heat pumps with heat regeneration
- 1 January 2002
- Published by Elsevier in Applied Thermal Engineering
- Vol. 22 (1) , 23-40
Effect of mass transfer kinetics on the performance of adsorptive heat pump systems
- 1 January 2002
- Published by Elsevier in Applied Thermal Engineering
- Vol. 22 (1) , 23-40
Effect of mass transfer kinetics on the performance of adsorptive heat pump systems
- 1 January 2001
- Published by Elsevier in Chemical Engineering Journal
- Vol. 81 (1-3) , 23-34
Pressure drop in fixed-bed adsorbers
- 1 January 2001
- Published by Elsevier in Chemical Engineering Journal
- Vol. 81 (1-3) , 23-34
Pressure drop in fixed-bed adsorbers