Anna I. Vershinina
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Anna I. Vershinina has a total of 28 co-authors. Here are the top co-authors by number of shared publications:
- Sergey D. Shandakov
Kemerovo State University
7 shared publications - Maksim V. Lomakin
Kemerovo State University
5 shared publications - Alexey V. Kosobutsky
Kemerovo State University, Kemerovo, Russia
3 shared publications D. M. Russakov
Kemerovo State University
2 shared publications- Dmitriy M. Russakov
Kemerovo State University
2 shared publications - Natalia V. Ivanova
Kemerovo State University
2 shared publications
Latest Publications
- Open Access
- 14 July 2026
- Published by Elsevier in SSRN Electronic Journal
Free-Standing SWCNT Fiber Sensors for Dopamine Detection: Effect of Heat and Chemical Pretreatment
Novel sensors from single walled carbon nanotube (SWCNT) free-standing fibers with almost entire surface accessible to analyte were used for electrochemical investigations and analysis of dopamine. The SWCNTs were synthesized using carbon monoxide or ethanol as precursors. By assembling SWCNT bundles in the form of a fiber, we are able to avoid the interference of substrate and improve detection efficiency. We examined the influence of heat and chemical pretreatments of the electrode SWCNT material on its properties. Transmission and scanning electron microscopy, Raman spectroscopy and cyclic voltammetry were used to characterize the SWCNT fibers. The pretreated free-standing SWCNT fiber sensors exhibited necessary analytical performance for dopamine determination by anodic voltammetry, including high sensitivity, repeatability, and a low limit of detection (9 – 120 µg L⁻¹). The electrochemical oxidation of dopamine on all five types of SWCNT fibers was reversible and involved dopamine adsorption onto the SWCNT surface. The heat and chemically pretreated SWCNT fiber sensors showed a linear response over a wide concentration range (0.07–150 mg L⁻¹). The developed SWCNT sensors enable rapid determination of dopamine in real samples and are characterized by high durability and a long service life.
- 14 July 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessFree-Standing SWCNT Fiber Sensors for Dopamine Detection: Effect of Heat and Chemical Pretreatment
Novel sensors from single walled carbon nanotube (SWCNT) free-standing fibers with almost entire surface accessible to analyte were used for electrochemical investigations and analysis of dopamine. The SWCNTs were synthesized using carbon monoxide or ethanol as precursors. By assembling SWCNT bundles in the form of a fiber, we are able to avoid the interference of substrate and improve detection efficiency. We examined the influence of heat and chemical pretreatments of the electrode SWCNT material on its properties. Transmission and scanning electron microscopy, Raman spectroscopy and cyclic voltammetry were used to characterize the SWCNT fibers. The pretreated free-standing SWCNT fiber sensors exhibited necessary analytical performance for dopamine determination by anodic voltammetry, including high sensitivity, repeatability, and a low limit of detection (9 – 120 µg L⁻¹). The electrochemical oxidation of dopamine on all five types of SWCNT fibers was reversible and involved dopamine adsorption onto the SWCNT surface. The heat and chemically pretreated SWCNT fiber sensors showed a linear response over a wide concentration range (0.07–150 mg L⁻¹). The developed SWCNT sensors enable rapid determination of dopamine in real samples and are characterized by high durability and a long service life.
- Open Access
- 30 December 2023
- Published by Kemerovo State University in Food Processing: Techniques and Technology
- Vol. 53 (4) , 824-831
Electrochemical Sensors Based on Single-Wall Carbon Nanotubes in Voltammetric Ascorbic Acid Tests
Modern highly sensitive and selective sensors are able to determine biologically active substances, which makes this direction one of the most popular areas of analytical chemistry. The study featured the electrochemical properties of new fiber materials based on single-wall carbon nanotubes with prospects of using them in the voltammetry of ascorbic acid. The authors developed a new technology to synthesize films from disordered single-wall carbon nanotubes by chemical vapor deposition. Fibers were produced from a solvent by wet-pulling of single-wall carbon nanotubes networks. Thin films of randomly oriented single-wall carbon nanotube bundles were deposited downstream of a floating aerosol CVD reactor, which included a high temperature furnace with a quartz tube. The synthesis of the single-wall carbon nanotube samples was performed at 825°C. Ethanol served as carbon source while ferrocene was used as catalyst precursor. The single-wall carbon nanotubes were collected on a nitrocellulose filter in the form of films with transmittances of 10% in the middle of the visible wavelength (550 nm). The method was optimized to involve air annealing at 300–320°C and a treatment with strong inorganic acids, i.e., HCl, HNO3 + H2SO4. The voltammetric curves recording included background electrolyte, scan rate, and preconditioning. These parameters were selected experimentally to obtain the maximal sensor response to ascorbic acid content. The anodic peak of ascorbic acid in the phosphate buffer electrolyte (pH 6.86) was observed at a potential of +0.2 V. The current and peak area of ascorbic acid oxidation depended neither on the time nor on the conditioning potential of the sensor. The linear dependences of these parameters on the concentration of ascorbic acid stayed within 50–500 μmol/L (8.8–90 mg/L) at a scan rate of 0.1 mV/s. The single-wall carbon nanotube microsensor had a length of 0.5 cm and an average width of 400 μm. Its sensitivity was two times as high as that of a disk glassy carbon electrode with a diameter of 5 mm. The experimental sensors proved effective in determining ascorbic acid in food products, pharmaceuticals, and biological fluids.
- 30 December 2023
- Published by Kemerovo State University in Food Processing: Techniques and Technology
- Vol. 53 (4) , 824-831
Open AccessElectrochemical Sensors Based on Single-Wall Carbon Nanotubes in Voltammetric Ascorbic Acid Tests
Modern highly sensitive and selective sensors are able to determine biologically active substances, which makes this direction one of the most popular areas of analytical chemistry. The study featured the electrochemical properties of new fiber materials based on single-wall carbon nanotubes with prospects of using them in the voltammetry of ascorbic acid. The authors developed a new technology to synthesize films from disordered single-wall carbon nanotubes by chemical vapor deposition. Fibers were produced from a solvent by wet-pulling of single-wall carbon nanotubes networks. Thin films of randomly oriented single-wall carbon nanotube bundles were deposited downstream of a floating aerosol CVD reactor, which included a high temperature furnace with a quartz tube. The synthesis of the single-wall carbon nanotube samples was performed at 825°C. Ethanol served as carbon source while ferrocene was used as catalyst precursor. The single-wall carbon nanotubes were collected on a nitrocellulose filter in the form of films with transmittances of 10% in the middle of the visible wavelength (550 nm). The method was optimized to involve air annealing at 300–320°C and a treatment with strong inorganic acids, i.e., HCl, HNO3 + H2SO4. The voltammetric curves recording included background electrolyte, scan rate, and preconditioning. These parameters were selected experimentally to obtain the maximal sensor response to ascorbic acid content. The anodic peak of ascorbic acid in the phosphate buffer electrolyte (pH 6.86) was observed at a potential of +0.2 V. The current and peak area of ascorbic acid oxidation depended neither on the time nor on the conditioning potential of the sensor. The linear dependences of these parameters on the concentration of ascorbic acid stayed within 50–500 μmol/L (8.8–90 mg/L) at a scan rate of 0.1 mV/s. The single-wall carbon nanotube microsensor had a length of 0.5 cm and an average width of 400 μm. Its sensitivity was two times as high as that of a disk glassy carbon electrode with a diameter of 5 mm. The experimental sensors proved effective in determining ascorbic acid in food products, pharmaceuticals, and biological fluids.
- 1 September 2017
- Published by Springer Nature in Russian Physics Journal
- Vol. 60 (5) , 915-918
Decoration of Carbon Nanotubes with MnO2 Nanoparticles Under Potassium Permanganate Treatment
- 1 September 2017
- Published by Springer Nature in Russian Physics Journal
- Vol. 60 (5) , 915-918
Decoration of Carbon Nanotubes with MnO2 Nanoparticles Under Potassium Permanganate Treatment
- 1 September 2017
- Published by Springer Nature in Russian Physics Journal
- Vol. 60 (5) , 919-921
Treatment of Carbon Nanotubes in a Gaseous Medium to Improve the Characteristics of Supercapacitor Electrodes
- 1 September 2017
- Published by Springer Nature in Russian Physics Journal
- Vol. 60 (5) , 919-921
Treatment of Carbon Nanotubes in a Gaseous Medium to Improve the Characteristics of Supercapacitor Electrodes
- 20 October 2016
- Published by Springer Nature in Russian Physics Journal
- Vol. 59 (6) , 907-910
Filters Based on Carbon Nanotube Networks for Nanoparticle Deposition
- 20 October 2016
- Published by Springer Nature in Russian Physics Journal
- Vol. 59 (6) , 907-910
Filters Based on Carbon Nanotube Networks for Nanoparticle Deposition