Asif Mahmood
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Asif Mahmood has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Saira Bano
Advanced Materials Division, Center for Membranes Korea Research Institute of Chemical Technology Yuseong‐Gu Daejeon 305‐606 Republic of Korea
7 shared publications - Kew-Ho Lee
Korea Research Institute of Chemical Technology (KRICT)
4 shared publications Ji Haeng Yu
3 shared publicationsKew-Ho Lee
3 shared publications- Muhammad Zaman
Faculty of Pharmacy, University of Central Punjab, Lahore, Pakistan
3 shared publications - Amr. M. Elbasiony
Department of Chemistry, College of Science Northern Border University (NBU) Arar Saudi Arabia
2 shared publications
Latest Publications
- 21 April 2026
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 23 (5) , 408
Performance evaluation of single and mixed draw solutes in the forward osmosis membrane
- 21 April 2026
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 23 (5) , 408
Performance evaluation of single and mixed draw solutes in the forward osmosis membrane
- 28 March 2026
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 237 (12) , 710
Correlating the Performance of Forward Osmosis Process to the Characteristics of Inorganic Draw Solutions
- 28 March 2026
- Published by Springer Nature in Water, Air, & Soil Pollution
- Vol. 237 (12) , 710
Correlating the Performance of Forward Osmosis Process to the Characteristics of Inorganic Draw Solutions
- Open Access
Thermo-Economic Analysis of Integrated Hydrogen, Methanol and Dimethyl Ether Production Using Water Electrolyzed Hydrogen
Carbon capture and utilization is an attractive technique to mitigate the damage to the environment. The aim of this study was to techno-economically investigate the hydrogenation of CO2 to methanol and then conversion of methanol to dimethyl ether using Aspen Plus® (V.11, Aspen Technology, Inc., Bedford, Massachusetts 01730, USA). Hydrogen was obtained from alkaline water electrolysis, proton exchange membrane and solid oxide electrolysis processes for methanol production. The major cost contributing factor in the methanol production was the cost of hydrogen production; therefore, the cost per ton of methanol was highest for alkaline water electrolysis and lowest for solid oxide electrolysis. The specific cost of methanol for solid oxide electrolysis, proton exchange membrane and alkaline water electrolysis was estimated to be 701 $/ton, 760 $/ton and 920 $/ton, respectively. Similarly, the specific cost of dimethyl ether was estimated to be 1141 $/ton, 1230 $/ton and 1471 $/ton, using solid oxide electrolysis, proton exchange membrane and alkaline water electrolysis based hydrogen production, respectively. The cost for methanol and dimethyl ether production by proton exchange membrane was slightly higher than for the solid oxide electrolysis process. However, the proton exchange membrane operates at a lower temperature, consequently leading to less operational issues.
Open AccessThermo-Economic Analysis of Integrated Hydrogen, Methanol and Dimethyl Ether Production Using Water Electrolyzed Hydrogen
Carbon capture and utilization is an attractive technique to mitigate the damage to the environment. The aim of this study was to techno-economically investigate the hydrogenation of CO2 to methanol and then conversion of methanol to dimethyl ether using Aspen Plus® (V.11, Aspen Technology, Inc., Bedford, Massachusetts 01730, USA). Hydrogen was obtained from alkaline water electrolysis, proton exchange membrane and solid oxide electrolysis processes for methanol production. The major cost contributing factor in the methanol production was the cost of hydrogen production; therefore, the cost per ton of methanol was highest for alkaline water electrolysis and lowest for solid oxide electrolysis. The specific cost of methanol for solid oxide electrolysis, proton exchange membrane and alkaline water electrolysis was estimated to be 701 $/ton, 760 $/ton and 920 $/ton, respectively. Similarly, the specific cost of dimethyl ether was estimated to be 1141 $/ton, 1230 $/ton and 1471 $/ton, using solid oxide electrolysis, proton exchange membrane and alkaline water electrolysis based hydrogen production, respectively. The cost for methanol and dimethyl ether production by proton exchange membrane was slightly higher than for the solid oxide electrolysis process. However, the proton exchange membrane operates at a lower temperature, consequently leading to less operational issues.
- Open Access
- 26 June 2020
- Published by Pakistan Atomic Energy Commission in The Nucleus
- Vol. 46 (3) , 205-211
ASSESSMENT AND IDENTIFICATION OF SOME NOVEL NOX REDUCING REAGENTS FOR SNCR PROCESS
Nitrogen oxides (NOx) are one of the most hazardous air pollutants arising from the combustion processes. Because of the implementation of strict emission limits many NOx removal technologies have been developed. In the present work post combustion NOx removal technique that is Selective Non-Catalytic Reduction (SNCR) has been investigated in a pilot scale 150 kW combustion rig facility. Investigation has been performed using some novel NOx reducing reagents like urea, ammonium carbonate and mixture of their 50%-50% aqueous solution within the temperature range of 700 to 1200 o C, at 1.1% excess oxygen and background NOx level of 500 ppm. The effects of these reagents were determined in term of their temperature characteristics and molar ratio. Among the reducing reagents used urea solution gave the highest NOx removal efficiency (81%) and was attractive due to its superior high temperature (1000 to 1150 o C) performance, ammonium carbonate was more effective at lower temperature range (850 to 950 o C) though its efficiency (32%) was lower than urea, while 50-50% solution of urea and ammonium carbonate gave higher efficiency than ammonium carbonate but slightly lesser than urea within a wide temperature range (875 to 1125 o C). It was also observed that the NOx removal efficiency was increased with increasing the molar ratio.
- 26 June 2020
- Published by Pakistan Atomic Energy Commission in The Nucleus
- Vol. 46 (3) , 205-211
Open AccessASSESSMENT AND IDENTIFICATION OF SOME NOVEL NOX REDUCING REAGENTS FOR SNCR PROCESS
Nitrogen oxides (NOx) are one of the most hazardous air pollutants arising from the combustion processes. Because of the implementation of strict emission limits many NOx removal technologies have been developed. In the present work post combustion NOx removal technique that is Selective Non-Catalytic Reduction (SNCR) has been investigated in a pilot scale 150 kW combustion rig facility. Investigation has been performed using some novel NOx reducing reagents like urea, ammonium carbonate and mixture of their 50%-50% aqueous solution within the temperature range of 700 to 1200 o C, at 1.1% excess oxygen and background NOx level of 500 ppm. The effects of these reagents were determined in term of their temperature characteristics and molar ratio. Among the reducing reagents used urea solution gave the highest NOx removal efficiency (81%) and was attractive due to its superior high temperature (1000 to 1150 o C) performance, ammonium carbonate was more effective at lower temperature range (850 to 950 o C) though its efficiency (32%) was lower than urea, while 50-50% solution of urea and ammonium carbonate gave higher efficiency than ammonium carbonate but slightly lesser than urea within a wide temperature range (875 to 1125 o C). It was also observed that the NOx removal efficiency was increased with increasing the molar ratio.
- 1 October 2019
- Published by Elsevier in Journal of CO2 Utilization
- Vol. 33, 114-120
Performance evaluation of SOEC for CO2/H2O co-electrolysis: Considering the effect of cathode thickness
- 1 October 2019
- Published by Elsevier in Journal of CO2 Utilization
- Vol. 33, 114-120
Performance evaluation of SOEC for CO2/H2O co-electrolysis: Considering the effect of cathode thickness
- 1 January 2015
- Published by Elsevier in Journal of Membrane Science
- Vol. 473, 8-15
Effect of operating conditions on the performance of solid electrolyte membrane reactor for steam and CO2 electrolysis
- 1 January 2015
- Published by Elsevier in Journal of Membrane Science
- Vol. 473, 8-15
Effect of operating conditions on the performance of solid electrolyte membrane reactor for steam and CO2 electrolysis
- Top Cited Papers
- 9 December 2014
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 3 (5) , 2065-2071
Graphene oxide modified polyamide nanofiltration membrane with improved flux and antifouling properties
Conceptual visualization of GO effect on fouling.
- 9 December 2014
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 3 (5) , 2065-2071
Top Cited PapersGraphene oxide modified polyamide nanofiltration membrane with improved flux and antifouling properties
Conceptual visualization of GO effect on fouling.
- 1 November 2014
- Published by Elsevier in Separation and Purification Technology
- Vol. 137, 21-27
Chlorine resistant binary complexed NaAlg/PVA composite membrane for nanofiltration
- 1 November 2014
- Published by Elsevier in Separation and Purification Technology
- Vol. 137, 21-27
Chlorine resistant binary complexed NaAlg/PVA composite membrane for nanofiltration
- 25 February 2013
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 52 (31) , 10450-10459
Vapor Permeation Separation of Methanol–Water Mixtures: Effect of Experimental Conditions
- 25 February 2013
- Published by American Chemical Society (ACS) in Industrial & Engineering Chemistry Research
- Vol. 52 (31) , 10450-10459
Vapor Permeation Separation of Methanol–Water Mixtures: Effect of Experimental Conditions