Hui Xie
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Hui Xie has a total of 63 co-authors. Here are the top co-authors by number of shared publications:
- Xixi Luo
School of Materials Engineering, Xi'an Aeronautical University, Xi'an 710077, China
6 shared publications Bin Yang
Inst China North Ind Grp, Yantai 264003, Shandong, Peoples R China
4 shared publications- Xin Li
Xian Aeronaut Univ, Sch Mat Engn, Xian 710077, Peoples R China
4 shared publications Hong Zhong
Northwestern Polytech Univ, State Key Lab Solidificat Proc, Xian 710072, Peoples R China
3 shared publicationsJing Cao
School of Materials Engineering, Xi'an Aeronautical University, Xi'an 710077, China
3 shared publicationsKaikai Zhang
School of Materials Engineering, Xi’an Aeronautical University, Xi’an, China
3 shared publications
Latest Publications
- 15 December 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (36) , 2282
Effect of AB-site co-doping on the electromagnetic wave absorption properties and mechanism of LaCoO3 perovskite oxides
- 15 December 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (36) , 2282
Effect of AB-site co-doping on the electromagnetic wave absorption properties and mechanism of LaCoO3 perovskite oxides
- 14 June 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (17) , 1-17
Preparation of high-performance EMW absorbing materials by the HCCs at different temperatures
- 14 June 2025
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 36 (17) , 1-17
Preparation of high-performance EMW absorbing materials by the HCCs at different temperatures
- 13 May 2024
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 305
Influence of group Ш elements doping on thermoelectric properties of Mg3Sb1.5Bi0.5 alloy
- 13 May 2024
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 305
Influence of group Ш elements doping on thermoelectric properties of Mg3Sb1.5Bi0.5 alloy
- 16 April 2024
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 35 (11) , 1-19
The impact of carbonization temperature on the microwave-absorbing properties of hollow porous carbon spheres
- 16 April 2024
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 35 (11) , 1-19
The impact of carbonization temperature on the microwave-absorbing properties of hollow porous carbon spheres
- Open Access
- 26 March 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (15) , 10687-10696
Enhanced microwave absorption performance of Fe3Al flakes by optimizing the carbon nanotube coatings
Fe3Al is a good magnetic loss absorber for microwave absorption.
- 26 March 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (15) , 10687-10696
Open AccessEnhanced microwave absorption performance of Fe3Al flakes by optimizing the carbon nanotube coatings
Fe3Al is a good magnetic loss absorber for microwave absorption.
- 23 October 2023
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 34 (30) , 1-11
Optimizing the order degree of plate-like Fe3Al for high-performance electromagnetic wave absorption
- 23 October 2023
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 34 (30) , 1-11
Optimizing the order degree of plate-like Fe3Al for high-performance electromagnetic wave absorption
- 3 April 2023
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 293
Influence of N-type doping sites on electronic transport properties of Mg3Sb1.5Bi0.5 alloys
- 3 April 2023
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 293
Influence of N-type doping sites on electronic transport properties of Mg3Sb1.5Bi0.5 alloys
- Open Access
Characterizations on Precipitations in the Cu-Rich Corner of Cu-Ni-Al Ternary Phase Diagram
Three kinds of Cu-Ni-Al alloys, whose chemical compositions are located in the Cu-rich corner of the isothermal section of the Cu-Ni-Al ternary phase diagram, were prepared by melting and casting firstly, and then solution and aging treatments were carried out. The microstructure was characterized and the competitive formation process of Ni-Al intermetallics were discussed. The results show that there are little amounts of NiAl phase at the grain boundary and needle- or particle-like Ni3Al phase inside the Cu matrix in all the as-cast alloys, although they are in the single-phase area. Solution and aging treatments mainly result in the disappearance and precipitation of Ni3Al phase, but the precipitations during aging are much smaller than those in the as-cast alloys. Thermodynamics and kinetics calculation indicate that the NiAl intermetallic wins out in the solidification process because of its lower change in Gibbs free energy, while Ni3Al phase is first to precipitate during aging due to its lower formation enthalpy and required Al concentration. The most important contribution of this work is that it proves that intermetallics can precipitate from the so-called single-phase zone in the Cu-rich corner of the Cu-Ni-Al phase diagram, which is the necessary prerequisite for the realization of high strength and high electrical conductivity.
Open AccessCharacterizations on Precipitations in the Cu-Rich Corner of Cu-Ni-Al Ternary Phase Diagram
Three kinds of Cu-Ni-Al alloys, whose chemical compositions are located in the Cu-rich corner of the isothermal section of the Cu-Ni-Al ternary phase diagram, were prepared by melting and casting firstly, and then solution and aging treatments were carried out. The microstructure was characterized and the competitive formation process of Ni-Al intermetallics were discussed. The results show that there are little amounts of NiAl phase at the grain boundary and needle- or particle-like Ni3Al phase inside the Cu matrix in all the as-cast alloys, although they are in the single-phase area. Solution and aging treatments mainly result in the disappearance and precipitation of Ni3Al phase, but the precipitations during aging are much smaller than those in the as-cast alloys. Thermodynamics and kinetics calculation indicate that the NiAl intermetallic wins out in the solidification process because of its lower change in Gibbs free energy, while Ni3Al phase is first to precipitate during aging due to its lower formation enthalpy and required Al concentration. The most important contribution of this work is that it proves that intermetallics can precipitate from the so-called single-phase zone in the Cu-rich corner of the Cu-Ni-Al phase diagram, which is the necessary prerequisite for the realization of high strength and high electrical conductivity.
- 3 May 2022
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 33 (16) , 13290-13302
Tuning the Al content for flake Fe3Al powder to achieve wideband electromagnetic wave absorption
- 3 May 2022
- Published by Springer Nature in Journal of Materials Science: Materials in Electronics
- Vol. 33 (16) , 13290-13302
Tuning the Al content for flake Fe3Al powder to achieve wideband electromagnetic wave absorption
- 1 April 2022
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 611, 306-316
In situ construction of Fe3Al@Al2O3 core-shell particles with excellent electromagnetic absorption
- 1 April 2022
- Published by Elsevier in Journal of Colloid and Interface Science
- Vol. 611, 306-316
In situ construction of Fe3Al@Al2O3 core-shell particles with excellent electromagnetic absorption