Sonam Acharya
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Sonam Acharya has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Santanu Kumar Mishra
Indian Institute of Technology Delhi, Delhi, India
3 shared publications - Ayan Mallik
Arizona State University
1 shared publication
Latest Publications
- 16 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 37 (6) , 7354-7369
PWM Control of N-Phase Interleaved Active Front-End Boost Stage-Based Impedance Source Inverter
Non-isolated high gain inverters, such as impedance source inverters (ZSI), are suitable for applications with limited input dc source voltage, e.g., microinverters. High gain in these inverters is attributed to the front-end boost stage (FBS). High step-up ratio results in very high input current as the power rating of the inverter goes up. This leads to significant conduction loss in the non ideal elements of the inverter, specifically in the FBS, thereby degrading the efficiency. Paralleling and interleaving the FBS is a feasible solution to achieve higher efficiency. This demands for a generalized pulsewidth modulation (PWM) scheme, which can enable paralleling of multiple interleaved FBSs. In this article, a novel PWM scheme is proposed to implement n -phase interleaving of active FBS-based ZSIs. The PWM scheme ensures synchronized operation between the “ n ” interleaved FBS and the single inverter stage. As case studies, the PWM scheme is implemented in n -phase interleaved current fed switched inverter, switched boost inverter, and quasi switched boost inverter. Steady-state operation of these topologies with three interleaved phases is verified using PLECS simulation. Operation of an interleaved current fed switched inverter with three interleaved phases is verified experimentally using a 200-W proof of concept prototype.
- 16 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 37 (6) , 7354-7369
PWM Control of N-Phase Interleaved Active Front-End Boost Stage-Based Impedance Source Inverter
Non-isolated high gain inverters, such as impedance source inverters (ZSI), are suitable for applications with limited input dc source voltage, e.g., microinverters. High gain in these inverters is attributed to the front-end boost stage (FBS). High step-up ratio results in very high input current as the power rating of the inverter goes up. This leads to significant conduction loss in the non ideal elements of the inverter, specifically in the FBS, thereby degrading the efficiency. Paralleling and interleaving the FBS is a feasible solution to achieve higher efficiency. This demands for a generalized pulsewidth modulation (PWM) scheme, which can enable paralleling of multiple interleaved FBSs. In this article, a novel PWM scheme is proposed to implement n -phase interleaving of active FBS-based ZSIs. The PWM scheme ensures synchronized operation between the “ n ” interleaved FBS and the single inverter stage. As case studies, the PWM scheme is implemented in n -phase interleaved current fed switched inverter, switched boost inverter, and quasi switched boost inverter. Steady-state operation of these topologies with three interleaved phases is verified using PLECS simulation. Operation of an interleaved current fed switched inverter with three interleaved phases is verified experimentally using a 200-W proof of concept prototype.
- 19 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 69 (7) , 6461-6470
PWM Control of a High-Gain N-Phase Interleaved Current-Fed Topology
Non-isolated high-gain dc–dc converters are essential for applications with low input voltage, such as solar PV modules and fuel-cells. Due to the high step-up conversion ratio, the input current increases significantly with increase in power rating. This leads to considerable conduction loss in the non-ideal elements of the converter, degrading the efficiency. Moreover, peak-to-peak ripple of the input current also increases with an increase in power rating. This increases the size of the passive elements, thereby limiting the power density. An n -phase Interleaved Complementary Current-fed Topology ( n -phase ICCFT) is proposed in this article to address the aforementioned limitations. Two pulse width modulated (PWM) schemes are proposed to implement the interleaving of the n -phases. Detailed steady-state analysis with various operating modes and the gain characteristics of the proposed converter are analyzed in the article. A comparative analysis of the two PWM schemes in terms of ripple characteristics, capacitor current stress, and power loss is reported. Operation of a two-phase ICCFT with the proposed PWM schemes is verified using PLECS simulation and experiments using a proof-of-concept hardware.
- 19 July 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 69 (7) , 6461-6470
PWM Control of a High-Gain N-Phase Interleaved Current-Fed Topology
Non-isolated high-gain dc–dc converters are essential for applications with low input voltage, such as solar PV modules and fuel-cells. Due to the high step-up conversion ratio, the input current increases significantly with increase in power rating. This leads to considerable conduction loss in the non-ideal elements of the converter, degrading the efficiency. Moreover, peak-to-peak ripple of the input current also increases with an increase in power rating. This increases the size of the passive elements, thereby limiting the power density. An n -phase Interleaved Complementary Current-fed Topology ( n -phase ICCFT) is proposed in this article to address the aforementioned limitations. Two pulse width modulated (PWM) schemes are proposed to implement the interleaving of the n -phases. Detailed steady-state analysis with various operating modes and the gain characteristics of the proposed converter are analyzed in the article. A comparative analysis of the two PWM schemes in terms of ripple characteristics, capacitor current stress, and power loss is reported. Operation of a two-phase ICCFT with the proposed PWM schemes is verified using PLECS simulation and experiments using a proof-of-concept hardware.
- 20 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (7) , 7015-7030
Interleaved Current-Fed Switched Inverter
Current-Fed Switched Inverter (CFSI) is a high gain inverter topology suitable for applications which have limited input DC source voltage, e.g., roof-top solar applications. A very high step-up ratio between AC output and DC input along with inherent shoot-through protection makes it suitable for low-power stand-alone inverter applications. In this paper, a novel interleaved topology for CFSI (ICFSI) is proposed to augment its power rating. A PWM scheme is also proposed to drive the interleaved topology. Various modes of operation of ICFSI, along with the steady state model and dynamic analysis, with the proposed PWM scheme, is reported. ICFSI, with the PWM scheme, results in a 33% increase in AC gain as compared to CFSI. In this paper, the small signal model of ICFSI is also derived and verified. An analysis comparing the losses in CFSI and ICFSI is carried out. It is observed that interleaved operation improves the efficiency by 4% at 600 W. The proposed topology and analysis are verified with the experimental results obtained from a 600 W laboratory developed prototype.
- 20 November 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (7) , 7015-7030
Interleaved Current-Fed Switched Inverter
Current-Fed Switched Inverter (CFSI) is a high gain inverter topology suitable for applications which have limited input DC source voltage, e.g., roof-top solar applications. A very high step-up ratio between AC output and DC input along with inherent shoot-through protection makes it suitable for low-power stand-alone inverter applications. In this paper, a novel interleaved topology for CFSI (ICFSI) is proposed to augment its power rating. A PWM scheme is also proposed to drive the interleaved topology. Various modes of operation of ICFSI, along with the steady state model and dynamic analysis, with the proposed PWM scheme, is reported. ICFSI, with the PWM scheme, results in a 33% increase in AC gain as compared to CFSI. In this paper, the small signal model of ICFSI is also derived and verified. An analysis comparing the losses in CFSI and ICFSI is carried out. It is observed that interleaved operation improves the efficiency by 4% at 600 W. The proposed topology and analysis are verified with the experimental results obtained from a 600 W laboratory developed prototype.