MKManjunath Kareppagoudr

Manjunath Kareppagoudr

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Manjunath Kareppagoudr has a total of 16 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Hybrid Continuous-Time Incremental and SAR Two-Step ADC With 90.5-dB DR Over 1-MHz BW

    by Yanchao Wang, Siladitya Dey, Tao He, Lukang Shi, Jiawei Zheng, Manjunath Kareppagoudr, Yi Zhang, Kazuki Sobue, Koichi Hamashita, Koji Tomioka, et al.

    This letter presents a hybrid continuous-time (CT) incremental and SAR two step ADC to provide high resolution with low oversampling ratio (OSR) and Nyquist conversion rate. The first CT incremental ADC (IADC) stage achieves large bandwidth, low thermal noise, and power consumption. The residual error of the CT IADC is extracted at the last integrator output and transferred to the 2nd SAR for further conversion. In this architecture, only the mismatch between the cascade of analog integrators (CoIs) and digital decimation filter transfer functions causes 1st stage quantization noise leakage, which is much smaller than that in the multistage noise-shaping (MASH) architecture. The ADC is fabricated in the AKM 180-nm CMOS process with 1.8-V supply voltage. It achieves a DR of 90.5 dB, SNR/SFDR/SNDR of 82.5/85/80.5 dB, and Schreier figure of merit (FoMs) of 165.5 dB over 1-MHz bandwidth (BW).


  • Slewing Mitigation Technique for Switched Capacitor Circuits

    by Manjunath Kareppagoudr, Jyotindra Shakya, Emanuel Caceres, Yu-Wen Kuo, Gabor C. Temes

    Slewing in switched capacitor (SC) circuits reduces the available time for linear settling, and hence increases the nonlinear settling error. This transient demand in current can be supplied by making the bias currents larger in the operational transconductance amplifier (OTA). However, this increases the static power consumption significantly. In this paper a slewing mitigation technique is presented where just the right amount of charge is provided at the switching instant to the SC circuit so that OTA does not need to provide high peak current. This may eliminate slewing altogether, and allows using OTAs with less static current for the same settling accuracy. The operation of the proposed technique is illustrated by incorporating it in a second-order delta-sigma modulator (DSM). The modulator was designed and simulated in a 65nm CMOS process. Post-layout extracted simulations with optimized design show more than 12 dB improvement in signal to noise and distortion ratio (SNDR) for the same static power. Alternatively, compared to a DSM without such technique, the same performance can be achieved with 30% less power.


  • Open Access

    Passive switched‐capacitor filter with complex poles for high‐speed applications

    by P. Payandehnia, H. Maghami, M. Kareppagoudr, G.C. Temes

    A novel complex‐pole switched‐capacitor lowpass filter topology is presented. The proposed scheme features sharper roll‐off in the frequency response and reduced in‐band loss compared with a real‐pole filter. It provides higher stop‐band rejection for the same bandwidth. Hence, the required filter order and chip area are reduced. These improvements are achieved without adding more active blocks to the real‐pole filter, and with minimal added complexity. The proposed filter has the same low‐output thermal noise level as the real‐pole filter. These features, combined with a wide‐frequency tuning range, make the filter suitable for high‐speed, low‐noise, and low‐power applications. A fourth‐order 200 MS/s filter prototype was designed in 0.18 µm Asahi Kasei Microdevices Corporation CMOS technology. Simulations verify that the average in‐band loss is reduced by 3.2 dB compared with the real‐pole filter. The 3 dB cut‐off frequency can be tuned from 470 kHz to 17.5 MHz with 100 dB maximum stop‐band rejection.