Passive switched‐capacitor filter with complex poles for high‐speed applications
Open Access
- 1 September 2016
- journal article
- circuits and-systems
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 52 (19) , 1592-1594
Abstract
A novel complex‐pole switched‐capacitor lowpass filter topology is presented. The proposed scheme features sharper roll‐off in the frequency response and reduced in‐band loss compared with a real‐pole filter. It provides higher stop‐band rejection for the same bandwidth. Hence, the required filter order and chip area are reduced. These improvements are achieved without adding more active blocks to the real‐pole filter, and with minimal added complexity. The proposed filter has the same low‐output thermal noise level as the real‐pole filter. These features, combined with a wide‐frequency tuning range, make the filter suitable for high‐speed, low‐noise, and low‐power applications. A fourth‐order 200 MS/s filter prototype was designed in 0.18 µm Asahi Kasei Microdevices Corporation CMOS technology. Simulations verify that the average in‐band loss is reduced by 3.2 dB compared with the real‐pole filter. The 3 dB cut‐off frequency can be tuned from 470 kHz to 17.5 MHz with 100 dB maximum stop‐band rejection.Keywords
This publication has 4 references indexed in Scilit:
- A Simplified Model for Passive-Switched-Capacitor Filters With Complex PolesIEEE Transactions on Circuits and Systems II: Express Briefs, 2016
- Analysis and Design of a High-Order Discrete-Time Passive IIR Low-Pass FilterIEEE Journal of Solid-State Circuits, 2014
- Active-RC Filters Using the Gm-Assisted OTA-RC TechniqueIEEE Journal of Solid-State Circuits, 2011
- A CMOS 4.35-mW +22-dBm IIP3 Continuously Tunable Channel Select Filter for WLAN/WiMAX ReceiversIEEE Journal of Solid-State Circuits, 2011