Mikhail S. Stepanov
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Mikhail S. Stepanov has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
A V Bunyakin
Kuban State Technological University, 2, Moskovskaya Street, Krasnodar, 350072, Russia
2 shared publications- Alexey Vadimovich Bunyakin
Кубанский государственный университет
2 shared publications - Vladislav I. Dunaev
Кубанский государственный технологический университет, Краснодар, Россия
2 shared publications E I Velichko
Kuban State Technological University, 2, Moskovskaya Street, Krasnodar, 350072, Russia
1 shared publication- Gani G. Gilaev
Kuban State Technological University
1 shared publication
Latest Publications
- 18 September 2025
- Published by Tyumen State University in Tyumen State University Herald Physical and Mathematical Modeling Oil Gas Energy
- Vol. 11 (2(42))
Моделирование дисбаланса ротора нагнетателя, обусловленного отложениями в его проточной части
В работе рассматривается математическая модель, описывающая дисбаланс ротора центробежного нагнетателя, обусловленный неравномерным распределением отложений в проточной части его первой ступени. Целью исследования является количественная оценка величины этого дисбаланса в зависимости от эксплуатационных данных агрегата, допускающих непосредственное измерение. Получено аналитическое выражение для момента силы на роторе нагнетателя, учитывающее зависимости между перераспределенным расходом, динамической вязкостью газа и толщиной слоя отложений, позволяющее оценить величину силы, создающей динамический дисбаланс ротора. Результаты исследования могут быть использованы для диагностики наличия отложений в межлопаточных каналах центробежного нагнетателя природного газа, указывающей на необходимость проведение мероприятий по обслуживанию проточной части агрегата непосредственно по ее техническому состоянию. The paper analyses a mathematical model describing the imbalance of a centrifugal supercharger rotor caused by uneven distribution of deposits in the flow part of its first stage. The aim of the study is to quantitatively estimate the magnitude of this imbalance, depending on the operating data of the unit, allowing direct measurement. An analytical expression for the torque on the supercharger rotor is obtained, taking into account the relations between the redistributed flow rate, dynamic viscosity of the gas and the thickness of the deposit layer, allowing us to estimate the magnitude of the force that creates a dynamic imbalance of the rotor. The results of the study can be used to diagnose the presence of deposits in the interblade channels of a centrifugal supercharger of natural gas, indicating the need for maintenance of the flow part of the unit directly based on its technical condition.
- 18 September 2025
- Published by Tyumen State University in Tyumen State University Herald Physical and Mathematical Modeling Oil Gas Energy
- Vol. 11 (2(42))
Моделирование дисбаланса ротора нагнетателя, обусловленного отложениями в его проточной части
В работе рассматривается математическая модель, описывающая дисбаланс ротора центробежного нагнетателя, обусловленный неравномерным распределением отложений в проточной части его первой ступени. Целью исследования является количественная оценка величины этого дисбаланса в зависимости от эксплуатационных данных агрегата, допускающих непосредственное измерение. Получено аналитическое выражение для момента силы на роторе нагнетателя, учитывающее зависимости между перераспределенным расходом, динамической вязкостью газа и толщиной слоя отложений, позволяющее оценить величину силы, создающей динамический дисбаланс ротора. Результаты исследования могут быть использованы для диагностики наличия отложений в межлопаточных каналах центробежного нагнетателя природного газа, указывающей на необходимость проведение мероприятий по обслуживанию проточной части агрегата непосредственно по ее техническому состоянию. The paper analyses a mathematical model describing the imbalance of a centrifugal supercharger rotor caused by uneven distribution of deposits in the flow part of its first stage. The aim of the study is to quantitatively estimate the magnitude of this imbalance, depending on the operating data of the unit, allowing direct measurement. An analytical expression for the torque on the supercharger rotor is obtained, taking into account the relations between the redistributed flow rate, dynamic viscosity of the gas and the thickness of the deposit layer, allowing us to estimate the magnitude of the force that creates a dynamic imbalance of the rotor. The results of the study can be used to diagnose the presence of deposits in the interblade channels of a centrifugal supercharger of natural gas, indicating the need for maintenance of the flow part of the unit directly based on its technical condition.
- 1 January 2024
- Published by Tyumen State University in Tyumen State University Herald Physical and Mathematical Modeling Oil Gas Energy
- p. 79-84
The influence of the uneven distribution of deposits in the flow part of the centrifugal blower on the precession of its rotor
This article considers a dynamic precession model of the shaft in a centrifugal supercharger of a gas pumping unit with two compression stages and sliding bearings. Precession is characterized by the trajectory of the shaft floating on one of the supporting bearing units or on two nodes synchronously. The authors have assessed the imbalance force resulting from uneven deposits at two compression stages (two impellers of natural gas supercharger). The calculated characteristics are compared with the measurement data on the gas pumping unit during its operation. This article provides analytical expressions for estimating the force causing the precession of the shaft and creating its imbalance. The results can be used to diagnose the presence of deposits on the impellers of the supercharger.
- 1 January 2024
- Published by Tyumen State University in Tyumen State University Herald Physical and Mathematical Modeling Oil Gas Energy
- p. 79-84
The influence of the uneven distribution of deposits in the flow part of the centrifugal blower on the precession of its rotor
This article considers a dynamic precession model of the shaft in a centrifugal supercharger of a gas pumping unit with two compression stages and sliding bearings. Precession is characterized by the trajectory of the shaft floating on one of the supporting bearing units or on two nodes synchronously. The authors have assessed the imbalance force resulting from uneven deposits at two compression stages (two impellers of natural gas supercharger). The calculated characteristics are compared with the measurement data on the gas pumping unit during its operation. This article provides analytical expressions for estimating the force causing the precession of the shaft and creating its imbalance. The results can be used to diagnose the presence of deposits on the impellers of the supercharger.
- Open Access
- 1 July 2021
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 808 (1) , 012023
Influence of deposits on rotor impellers of a centrifugal blower of a gas-pumping unit on static imbalance
Compressor station equipment undergoes a sensitive adjustment process before commissioning. One of its most important tasks is balancing the blower rotor, as a result of which the forces acting in the system are balanced. Unbalance is the imbalance of the rotor, leading to the occurrence of forces and moments that cause vibration, both of the rotor itself and of the entire machine as a whole. Currently, there is no absolutely effective method for gas purification, which negatively affects the flow path of the equipment. This is especially true for gas pumping units that compress associated petroleum gas, as well as for GPUs operating in underground gas storage facilities and used in cases where the pressure of the sampled gas is lower than the pressure in the pipeline and must be raised. All this contributes to the emergence of an imbalance in the system. The work mathematically simulates the effect of deposits on the static balance of the rotor of a centrifugal blower.
- 1 July 2021
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 808 (1) , 012023
Open AccessInfluence of deposits on rotor impellers of a centrifugal blower of a gas-pumping unit on static imbalance
Compressor station equipment undergoes a sensitive adjustment process before commissioning. One of its most important tasks is balancing the blower rotor, as a result of which the forces acting in the system are balanced. Unbalance is the imbalance of the rotor, leading to the occurrence of forces and moments that cause vibration, both of the rotor itself and of the entire machine as a whole. Currently, there is no absolutely effective method for gas purification, which negatively affects the flow path of the equipment. This is especially true for gas pumping units that compress associated petroleum gas, as well as for GPUs operating in underground gas storage facilities and used in cases where the pressure of the sampled gas is lower than the pressure in the pipeline and must be raised. All this contributes to the emergence of an imbalance in the system. The work mathematically simulates the effect of deposits on the static balance of the rotor of a centrifugal blower.
- Open Access
- 1 April 2020
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 459 (5)
Diagnostics of Sediment Occurrence in Interblade Channel of Injector Impeller of Gas Compressing Station by Changes of Gas Flow and Torque
Today no gas purification method exists which can be considered absolutely efficient. Thus, when gas compilation in conducted a problem of sediment formation occurs in a flow passage of the gas compression station (GCS) injector. The paper considers the mathematical simulation of the force moment change at the injector impeller of GCS caused by sediment occurrence in the interblade channel of impellers. In addition, the authors study the change of force moment in relation to the thickness of a sediment layer. Also, the research concentrates on the change of circumferential force at the impeller due to the change of force moment.
- 1 April 2020
- Published by IOP Publishing in IOP Conference Series: Earth and Environmental Science
- Vol. 459 (5)
Open AccessDiagnostics of Sediment Occurrence in Interblade Channel of Injector Impeller of Gas Compressing Station by Changes of Gas Flow and Torque
Today no gas purification method exists which can be considered absolutely efficient. Thus, when gas compilation in conducted a problem of sediment formation occurs in a flow passage of the gas compression station (GCS) injector. The paper considers the mathematical simulation of the force moment change at the injector impeller of GCS caused by sediment occurrence in the interblade channel of impellers. In addition, the authors study the change of force moment in relation to the thickness of a sediment layer. Also, the research concentrates on the change of circumferential force at the impeller due to the change of force moment.