Harold J. Fu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Harold J. Fu has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Bruce S. Brunschwig
Beckman Institute, California Institute of Technology, Pasadena, California 91125, United States
4 shared publications - Nathan S. Lewis
California Institute of Technology
4 shared publications - Ivan A. Moreno-Hernandez
Duke University
2 shared publications - Pakpoom Buabthong
Faculty of Science and Technology, Nakhon Ratchasima Rajabhat University, Nakhon Ratchasima, Thailand
2 shared publications - Weilai Yu
Department of Chemical Engineering and Applied Chemistry University of Toronto Toronto Ontario Canada
2 shared publications Harry A. Atwater
Division of Engineering and Applied Sciences
1 shared publication
Latest Publications
- 29 November 2021
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 15 (1) , 334-345
Catalytic open-circuit passivation by thin metal oxide films of p-Si anodes in aqueous alkaline electrolytes
Ni and NiOx-based protective thin films catalyze the oxidation of Si in the presence of O2 in strongly alkaline KOH(aq) even in the absence of illumination.
- 29 November 2021
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 15 (1) , 334-345
Catalytic open-circuit passivation by thin metal oxide films of p-Si anodes in aqueous alkaline electrolytes
Ni and NiOx-based protective thin films catalyze the oxidation of Si in the presence of O2 in strongly alkaline KOH(aq) even in the absence of illumination.
- 6 October 2020
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 13 (11) , 4132-4141
Enhanced stability of silicon for photoelectrochemical water oxidation through self-healing enabled by an alkaline protective electrolyte
The addition of [Fe(CN)6]3− to alkaline electrolytes impede the corrosion of Si photoanodes at open circuit due to the formation of a SiOx layer.
- 6 October 2020
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 13 (11) , 4132-4141
Enhanced stability of silicon for photoelectrochemical water oxidation through self-healing enabled by an alkaline protective electrolyte
The addition of [Fe(CN)6]3− to alkaline electrolytes impede the corrosion of Si photoanodes at open circuit due to the formation of a SiOx layer.
- Open Access
- 10 July 2020
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 153 (2) , 020902
Atomic force microscopy: Emerging illuminated and operando techniques for solar fuel research
Integrated photoelectrochemical devices rely on the synergy between components to efficiently generate sustainable fuels from sunlight. The micro- and/or nanoscale characteristics of the components and their interfaces often control critical processes of the device, such as charge-carrier generation, electron and ion transport, surface potentials, and electrocatalysis. Understanding the spatial properties and structure–property relationships of these components can provide insight into designing scalable and efficient solar fuel components and systems. These processes can be probed ex situ or in situ with nanometer-scale spatial resolution using emerging scanning-probe techniques based on atomic force microscopy (AFM). In this Perspective, we summarize recent developments of AFM-based techniques relevant to solar fuel research. We review recent progress in AFM for (1) steady-state and dynamic light-induced surface photovoltage measurements; (2) nanoelectrical conductive measurements to resolve charge-carrier heterogeneity and junction energetics; (3) operando investigations of morphological changes, as well as surface electrochemical potentials, currents, and photovoltages in liquids. Opportunities for research include: (1) control of ambient conditions for performing AFM measurements; (2) in situ visualization of corrosion and morphological evolution of electrodes; (3) operando AFM techniques to allow nanoscale mapping of local catalytic activities and photo-induced currents and potentials.
- 10 July 2020
- Published by AIP Publishing in The Journal of Chemical Physics
- Vol. 153 (2) , 020902
Open AccessAtomic force microscopy: Emerging illuminated and operando techniques for solar fuel research
Integrated photoelectrochemical devices rely on the synergy between components to efficiently generate sustainable fuels from sunlight. The micro- and/or nanoscale characteristics of the components and their interfaces often control critical processes of the device, such as charge-carrier generation, electron and ion transport, surface potentials, and electrocatalysis. Understanding the spatial properties and structure–property relationships of these components can provide insight into designing scalable and efficient solar fuel components and systems. These processes can be probed ex situ or in situ with nanometer-scale spatial resolution using emerging scanning-probe techniques based on atomic force microscopy (AFM). In this Perspective, we summarize recent developments of AFM-based techniques relevant to solar fuel research. We review recent progress in AFM for (1) steady-state and dynamic light-induced surface photovoltage measurements; (2) nanoelectrical conductive measurements to resolve charge-carrier heterogeneity and junction energetics; (3) operando investigations of morphological changes, as well as surface electrochemical potentials, currents, and photovoltages in liquids. Opportunities for research include: (1) control of ambient conditions for performing AFM measurements; (2) in situ visualization of corrosion and morphological evolution of electrodes; (3) operando AFM techniques to allow nanoscale mapping of local catalytic activities and photo-induced currents and potentials.
- 30 April 2020
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 8 (18) , 9292-9301
Conformal SnOx heterojunction coatings for stabilized photoelectrochemical water oxidation using arrays of silicon microcones
The efficiency of photoelectrodes towards fuel-forming reactions is strongly affected by surface-based charge recombination, charge-transfer losses, and parasitic light absorption by electrocatalysts. We report a protective tin oxide (SnOx) layer formed by atomic-layer deposition that limits surface recombination at n-Si/SnOx heterojunctions and produces ∼620 mV of photovoltage on planar n-Si photoanodes. The SnOx layer can be deposited conformally on high aspect-ratio three-dimensional structures such as Si microcone arrays. Atomic-level control of the SnOx thickness enabled highly conductive contacts to electrolytes, allowing the direct electrodeposition of NiFeOOH, CoOx, and IrOx electrocatalysts for photoelectrochemical water oxidation with minimal parasitic absorption losses. SnOx-coated n-Si microcone arrays coupled to electrodeposited catalysts exhibited photocurrent densities of ∼42 mA cm−2 and a photovoltage of ∼490 mV under 100 mW cm−2 of simulated solar illumination. The SnOx layer can be integrated with amorphous TiO2 to form a protective SnOx/TiO2 bilayer that exhibits the beneficial properties of both materials. Photoanodes coated with SnOx/TiO2 exhibited a similar photovoltage to that of SnOx-coated photoanodes, and showed >480 h of stable photocurrent for planar photoelectrodes and >140 h of stable photocurrent for n-Si microcone arrays under continuous simulated solar illumination in alkaline electrolytes.
- 30 April 2020
- Published by Royal Society of Chemistry (RSC) in Journal of Materials Chemistry A
- Vol. 8 (18) , 9292-9301
Conformal SnOx heterojunction coatings for stabilized photoelectrochemical water oxidation using arrays of silicon microcones
The efficiency of photoelectrodes towards fuel-forming reactions is strongly affected by surface-based charge recombination, charge-transfer losses, and parasitic light absorption by electrocatalysts. We report a protective tin oxide (SnOx) layer formed by atomic-layer deposition that limits surface recombination at n-Si/SnOx heterojunctions and produces ∼620 mV of photovoltage on planar n-Si photoanodes. The SnOx layer can be deposited conformally on high aspect-ratio three-dimensional structures such as Si microcone arrays. Atomic-level control of the SnOx thickness enabled highly conductive contacts to electrolytes, allowing the direct electrodeposition of NiFeOOH, CoOx, and IrOx electrocatalysts for photoelectrochemical water oxidation with minimal parasitic absorption losses. SnOx-coated n-Si microcone arrays coupled to electrodeposited catalysts exhibited photocurrent densities of ∼42 mA cm−2 and a photovoltage of ∼490 mV under 100 mW cm−2 of simulated solar illumination. The SnOx layer can be integrated with amorphous TiO2 to form a protective SnOx/TiO2 bilayer that exhibits the beneficial properties of both materials. Photoanodes coated with SnOx/TiO2 exhibited a similar photovoltage to that of SnOx-coated photoanodes, and showed >480 h of stable photocurrent for planar photoelectrodes and >140 h of stable photocurrent for n-Si microcone arrays under continuous simulated solar illumination in alkaline electrolytes.