Elena Vlasova
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Elena Vlasova has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Vadym Kovalenko
Ukrainian State University of Science and Technologies
3 shared publications - Valerii Kotok
Ukrainian State University of Science and Technologies
3 shared publications - Sergey Vlasov
Dnipro University of Technology
2 shared publications - Anna Cheremysinova
Ukrainian State University of Chemical Technology Gagarina ave., 8, Dnipro, Ukraine, 49005
1 shared publication - Irina Sknar
Ukrainian State University of Chemical Technology Gagarina ave., 8, Dnipro, Ukraine, 49005
1 shared publication - Mykola Nikolenko
Faculty of Chemical Technologies and Ecology, Ukrainian State University of Chemical Technology, Gagarin Avenue 8, 49005 Dnipro, Ukraine
1 shared publication
Latest Publications
- Open Access
- 25 April 2017
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 2 (6 (86)) , 4-10
Investigation of composition and structure of tripoliphosphate coating on low carbon steel
The hypothesis on the matrix (composite) structure of the iron (III) tripolyphosphate precipitate and polyphosphate coatings on the steel substrate has been justified experimentally. According to the hypothesis, that iron (III) tripolyphosphate acts as a matrix forming agent while water-soluble sodium tripolyphosphate corrosion inhibitor is a filler. Be means of the chemical synthesis method, it has been demonstrated that the chemical basis of the coating formed on the steel surface in the STPP solution is iron (III) tripolyphosphate. It has been established that the composite structure of tripolyphosphate coatings and precipitates is determined by the nature of iron (III) tripolyphosphate. The conducted investigation on the composition of the iron (III) tripolyphosphate precipitate and tripolyphosphate coating on steel, using the gravimetric method with washing have proved the presence of STPP. The results of X-ray spectral analysis have revealed that STPP in the structure of composite coating is situated not only as a filler inside the matrix but also as an additional layer on its surface. The chemical protection mechanism of the tripolyphosphate coating on steel in atmospheric conditions has been justified.The acquired knowledge would expand the theoretical and practical concept of the structure and properties of tripolyphosphate coatings on the steel substrate and their protection mechanism in conditions of atmospheric corrosion. The application of new knowledge in researches aimed at the development of ecologically safe methods of tripolyphosphate coating deposition with estimated complex of properties, would increase their efficiency.
- 25 April 2017
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 2 (6 (86)) , 4-10
Open AccessInvestigation of composition and structure of tripoliphosphate coating on low carbon steel
The hypothesis on the matrix (composite) structure of the iron (III) tripolyphosphate precipitate and polyphosphate coatings on the steel substrate has been justified experimentally. According to the hypothesis, that iron (III) tripolyphosphate acts as a matrix forming agent while water-soluble sodium tripolyphosphate corrosion inhibitor is a filler. Be means of the chemical synthesis method, it has been demonstrated that the chemical basis of the coating formed on the steel surface in the STPP solution is iron (III) tripolyphosphate. It has been established that the composite structure of tripolyphosphate coatings and precipitates is determined by the nature of iron (III) tripolyphosphate. The conducted investigation on the composition of the iron (III) tripolyphosphate precipitate and tripolyphosphate coating on steel, using the gravimetric method with washing have proved the presence of STPP. The results of X-ray spectral analysis have revealed that STPP in the structure of composite coating is situated not only as a filler inside the matrix but also as an additional layer on its surface. The chemical protection mechanism of the tripolyphosphate coating on steel in atmospheric conditions has been justified.The acquired knowledge would expand the theoretical and practical concept of the structure and properties of tripolyphosphate coatings on the steel substrate and their protection mechanism in conditions of atmospheric corrosion. The application of new knowledge in researches aimed at the development of ecologically safe methods of tripolyphosphate coating deposition with estimated complex of properties, would increase their efficiency.
- Open Access
- 17 February 2017
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 1 (6 (85)) , 16-22
Influence of temperature on the characteristics of Ni(II), Ti(IV) layered double hydroxides synthesised by different methods
Influence of temperature on the characteristics of Ni(II), Ti(IV) layered double hydroxides synthesised by different methods
- 17 February 2017
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 1 (6 (85)) , 16-22
Open AccessInfluence of temperature on the characteristics of Ni(II), Ti(IV) layered double hydroxides synthesised by different methods
Influence of temperature on the characteristics of Ni(II), Ti(IV) layered double hydroxides synthesised by different methods
- Open Access
- 30 October 2016
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 5 (5 (83)) , 33-39
Research of the mechanism of formation and properties of tripolyphosphate coating on the steel basis
The mechanism, protective properties, microstructure, phase composition of coats on steel have been investigated. According to the developed method, the coats were deposited potentiodynamically and potentiostatically in an aqueous solution of sodium tripolyphosphate. Based on the results of electrochemical studies, it has been established, that on potentiodynamic curves, characterizing the corrosion behavior of low-carbon steel in an aqueous sodium TPP solution, up to three passivation plateaus can be observed. The multi-stage formation mechanism of tripolyphosphate coat has been proposed. The mechanism includes three stages: at the start the adsorptive film is formed, that afterwards is modified two times, accompanied by a change of properties and composition. By using the methods of optical and scanning electron microscopy, X-ray diffraction, it has been established that the coat formed in an aqueous Na TPP solution by the potentiodynamic method under conditions of complete passivation, is composed of two layers: first – thin, compact layer, that contains a crystalline phase of phosphate nature, and second – thick hydrophilic layer, capable of drying. Such coat possesses the best protective properties in 0.1 N Na2SO4 solution, that models conditions of atmospheric corrosion. The nature of the electrochemical formation mechanism of tripolyphosphate coats and features of their structural and phase composition have been established. The further studies will be directed at the development of effective deposition methods of tripolyphosphate coats with estimated set of properties for the protection of metal goods from atmospheric and high-temperature gas corrosion.
- 30 October 2016
- Published by Private Company Technology Center in Eastern-European Journal of Enterprise Technologies
- Vol. 5 (5 (83)) , 33-39
Open AccessResearch of the mechanism of formation and properties of tripolyphosphate coating on the steel basis
The mechanism, protective properties, microstructure, phase composition of coats on steel have been investigated. According to the developed method, the coats were deposited potentiodynamically and potentiostatically in an aqueous solution of sodium tripolyphosphate. Based on the results of electrochemical studies, it has been established, that on potentiodynamic curves, characterizing the corrosion behavior of low-carbon steel in an aqueous sodium TPP solution, up to three passivation plateaus can be observed. The multi-stage formation mechanism of tripolyphosphate coat has been proposed. The mechanism includes three stages: at the start the adsorptive film is formed, that afterwards is modified two times, accompanied by a change of properties and composition. By using the methods of optical and scanning electron microscopy, X-ray diffraction, it has been established that the coat formed in an aqueous Na TPP solution by the potentiodynamic method under conditions of complete passivation, is composed of two layers: first – thin, compact layer, that contains a crystalline phase of phosphate nature, and second – thick hydrophilic layer, capable of drying. Such coat possesses the best protective properties in 0.1 N Na2SO4 solution, that models conditions of atmospheric corrosion. The nature of the electrochemical formation mechanism of tripolyphosphate coats and features of their structural and phase composition have been established. The further studies will be directed at the development of effective deposition methods of tripolyphosphate coats with estimated set of properties for the protection of metal goods from atmospheric and high-temperature gas corrosion.