Yongjae Kim
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Yongjae Kim has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Heeyeop Chae
School of Chemical Engineering, Sungkyunkwan University (SKKU), Suwon 16419, Republic of Korea
7 shared publications - Heeju Ha2 shared publications
- Heesung Shin
Department of Biotechnology and Bioinformatics, Korea University, Chungnam, Korea
2 shared publications Hojin Kang
School of Chemical Engineering Sungkyunkwan University (SKKU) Suwon Republic of Korea
2 shared publicationsIn-Hwa Yoo
Department of Biotechnology and Bioinformatics, Korea University, Chungnam, Korea
2 shared publicationsMinsung Jeon
Department of Semiconductor Convergence Engineering Sungkyunkwan University (SKKU) Suwon Republic of Korea
2 shared publications
Latest Publications
- 20 January 2024
- Published by Wiley in Plasma Processes and Polymers
- Vol. 21 (5)
Low global warming C5F10O isomers for plasma atomic layer etching and reactive ion etching of SiO2 and Si3N4
Plasma atomic layer etching (ALE) processes for SiO2 and Si3N4 and reactive ion etching (RIE) processes for SiO2 with hole patterns were developed using C4F8 and the low global warming potential gases of perfluoroisopropyl vinyl ether (PIPVE) and perfluoropropyl vinyl ether (PPVE). The ALE windows of SiO2 and Si3N4 were in the range of 50.0–57.5 V for all precursors. Etch per cycle of SiO2 was determined to be 5.5 Å/cycle (C4F8), 3.3 Å/cycle (PIPVE), and 5.4 Å/cycle (PPVE), all lower than that of Si3N4. PPVE reduced global warming emissions by 49%, demonstrating better vertical etch profiles in RIE compared to C4F8.
- 20 January 2024
- Published by Wiley in Plasma Processes and Polymers
- Vol. 21 (5)
Low global warming C5F10O isomers for plasma atomic layer etching and reactive ion etching of SiO2 and Si3N4
Plasma atomic layer etching (ALE) processes for SiO2 and Si3N4 and reactive ion etching (RIE) processes for SiO2 with hole patterns were developed using C4F8 and the low global warming potential gases of perfluoroisopropyl vinyl ether (PIPVE) and perfluoropropyl vinyl ether (PPVE). The ALE windows of SiO2 and Si3N4 were in the range of 50.0–57.5 V for all precursors. Etch per cycle of SiO2 was determined to be 5.5 Å/cycle (C4F8), 3.3 Å/cycle (PIPVE), and 5.4 Å/cycle (PPVE), all lower than that of Si3N4. PPVE reduced global warming emissions by 49%, demonstrating better vertical etch profiles in RIE compared to C4F8.
- Open Access
- 28 December 2023
- Published by The Korean Vacuum Society in Applied Science and Convergence Technology
- Vol. 33 (1) , 1-6
Atomic Layer Etching of SiO2 for Nanoscale Semiconductor Devices: A Review
Daeun Hong, Yongjae Kim, and Heeyeop Chae. Applied Science and Convergence Technology 2024;33:1-6. https://doi.org/10.5757/ASCT.2024.33.1.1
- 28 December 2023
- Published by The Korean Vacuum Society in Applied Science and Convergence Technology
- Vol. 33 (1) , 1-6
Open AccessAtomic Layer Etching of SiO2 for Nanoscale Semiconductor Devices: A Review
Daeun Hong, Yongjae Kim, and Heeyeop Chae. Applied Science and Convergence Technology 2024;33:1-6. https://doi.org/10.5757/ASCT.2024.33.1.1
- 16 November 2023
- Published by Wiley in Plasma Processes and Polymers
- Vol. 21 (3)
Plasma atomic layer etching of ruthenium with surface fluorination and ion bombardment
The plasma atomic layer etching (ALE) process for Ru was developed with surface fluorination and ion bombardment. We employed two methods for surface fluorination: (i) fluorocarbon deposition using CHF 3 or C 4 F 8 plasmas and (ii) chemisorption and diffusion with CF 4 plasma. C 4 F 8 plasma generated a more fluorine rich fluorocarbon layer on the Ru surface compared with CHF 3 plasma, and a higher etch per cycle (EPC) of 1.5 nm/cycle was achieved with C 4 F 8 plasma, in contrast to the 0.6 nm/cycle achieved with CHF 3 plasma. Moreover, chemisorption and diffusion with CF 4 plasma yielded an EPC of 1.2 nm/cycle. The ALE process using CHF 3 plasma shows the lowest fluorine residue and lowest surface roughness compared with the ALE process using C 4 F 8 and CF 4 plasmas.
- 16 November 2023
- Published by Wiley in Plasma Processes and Polymers
- Vol. 21 (3)
Plasma atomic layer etching of ruthenium with surface fluorination and ion bombardment
The plasma atomic layer etching (ALE) process for Ru was developed with surface fluorination and ion bombardment. We employed two methods for surface fluorination: (i) fluorocarbon deposition using CHF 3 or C 4 F 8 plasmas and (ii) chemisorption and diffusion with CF 4 plasma. C 4 F 8 plasma generated a more fluorine rich fluorocarbon layer on the Ru surface compared with CHF 3 plasma, and a higher etch per cycle (EPC) of 1.5 nm/cycle was achieved with C 4 F 8 plasma, in contrast to the 0.6 nm/cycle achieved with CHF 3 plasma. Moreover, chemisorption and diffusion with CF 4 plasma yielded an EPC of 1.2 nm/cycle. The ALE process using CHF 3 plasma shows the lowest fluorine residue and lowest surface roughness compared with the ALE process using C 4 F 8 and CF 4 plasmas.
- 4 June 2023
- Published by Elsevier in Applied Surface Science
- Vol. 635
Surface wettability control and fluorination modeling of amorphous carbon films fluorinated with CF4 plasma
- 4 June 2023
- Published by Elsevier in Applied Surface Science
- Vol. 635
Surface wettability control and fluorination modeling of amorphous carbon films fluorinated with CF4 plasma
- 18 April 2023
- Published by Elsevier in Applied Surface Science
- Vol. 627
Plasma atomic layer etching of molybdenum with surface fluorination
- 18 April 2023
- Published by Elsevier in Applied Surface Science
- Vol. 627
Plasma atomic layer etching of molybdenum with surface fluorination
- 15 February 2023
- Published by Elsevier in Applied Surface Science
- Vol. 619
Thermal atomic layer etching of cobalt using plasma chlorination and chelation with hexafluoroacetylacetone
- 15 February 2023
- Published by Elsevier in Applied Surface Science
- Vol. 619
Thermal atomic layer etching of cobalt using plasma chlorination and chelation with hexafluoroacetylacetone
- 13 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Semiconductor Manufacturing
- Vol. 33 (2) , 252-257
Sensitivity Enhancement of SiO2Plasma Etching Endpoint Detection Using Modified Gaussian Mixture Model
In this study, the Gaussianmixturemodel (GMM) was modified and implemented to determine the real-time endpoint of SiO2 plasma etching using optical emission spectrum analysis. Optical emission spectroscopy (OES) signals were collected from the SiO2 plasma etching processes, and the modified GMM was applied to SiO2 etching with relative areas of 8.0, 4.0, and 1.0%. Consequently, the sensitivity of OES signals was improved by 5.5 times, and the sensitivity factor of the modified GMM was increased by approximately two times, compared with those of the modified K-means cluster analysis (another clustering technique). In addition, 60 peaks related to the reactants were selected out of 6144 signals to improve the sensitivity of the modified GMM with full-spectrum wavelengths. The modified GMManalysis using the 60 reactant-related peaks exhibited a higher sensitivity ( 1.4 times) than that with 6144 full-spectrum OES signals. Thus, themodified GMM can be a suitable and effective clustering technique for etching endpoint detection.
- 13 February 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Semiconductor Manufacturing
- Vol. 33 (2) , 252-257
Sensitivity Enhancement of SiO2Plasma Etching Endpoint Detection Using Modified Gaussian Mixture Model
In this study, the Gaussianmixturemodel (GMM) was modified and implemented to determine the real-time endpoint of SiO2 plasma etching using optical emission spectrum analysis. Optical emission spectroscopy (OES) signals were collected from the SiO2 plasma etching processes, and the modified GMM was applied to SiO2 etching with relative areas of 8.0, 4.0, and 1.0%. Consequently, the sensitivity of OES signals was improved by 5.5 times, and the sensitivity factor of the modified GMM was increased by approximately two times, compared with those of the modified K-means cluster analysis (another clustering technique). In addition, 60 peaks related to the reactants were selected out of 6144 signals to improve the sensitivity of the modified GMM with full-spectrum wavelengths. The modified GMManalysis using the 60 reactant-related peaks exhibited a higher sensitivity ( 1.4 times) than that with 6144 full-spectrum OES signals. Thus, themodified GMM can be a suitable and effective clustering technique for etching endpoint detection.
- Open Access
- 24 September 2010
- Published by Oxford University Press (OUP) in FEMS Immunology & Medical Microbiology
- Vol. 60 (2) , 171-178
MKP1 regulates the induction of inflammatory response by pneumococcal pneumolysin in human epithelial cells
The expression of proinflammatory cytokines represents an important host innate response during infections. The reduction of cytokine expression thus mediates impaired host defenses. We previously reported that pneumococcal pneumolysin is less potent in inducing inflammatory responses in human epithelial cells at the early stage of treatment. How this might occur in response to pneumolysin is still not clearly understood. Here, we show the expression of tumor necrosis factor-α (TNF-α) was reduced by MAPK phosphatase 1 (MKP1), expression of which was significantly increased in response to pneumolysin at the early stage of treatment. TNF-α expression was mediated in a time-dependent manner by p38 mitogen-activated protein kinase, activation of which is under the control of MKP1. Thus, this study reveals novel roles of pneumolysin in mediating MKP1 expression for the regulation of proinflammatory cytokine expression in a time-dependent manner.
- 24 September 2010
- Published by Oxford University Press (OUP) in FEMS Immunology & Medical Microbiology
- Vol. 60 (2) , 171-178
Open AccessMKP1 regulates the induction of inflammatory response by pneumococcal pneumolysin in human epithelial cells
The expression of proinflammatory cytokines represents an important host innate response during infections. The reduction of cytokine expression thus mediates impaired host defenses. We previously reported that pneumococcal pneumolysin is less potent in inducing inflammatory responses in human epithelial cells at the early stage of treatment. How this might occur in response to pneumolysin is still not clearly understood. Here, we show the expression of tumor necrosis factor-α (TNF-α) was reduced by MAPK phosphatase 1 (MKP1), expression of which was significantly increased in response to pneumolysin at the early stage of treatment. TNF-α expression was mediated in a time-dependent manner by p38 mitogen-activated protein kinase, activation of which is under the control of MKP1. Thus, this study reveals novel roles of pneumolysin in mediating MKP1 expression for the regulation of proinflammatory cytokine expression in a time-dependent manner.
- 7 September 2010
- Published by Springer Nature in Biotechnology Letters
- Vol. 33 (1) , 97-102
Autoinduction of a genetic locus encoding putative acyltransferase in Corynebacterium glutamicum
A genetic locus, encoding putative acyltransferase, was induced by autoinducers in Corynebacterium glutamicum. The autoinducers were maximally produced by the bacterium after 24 h culture. Those molecules are resistant to proteinase K treatment (300 μg ml−1) for 30 min at 37°C or at 121°C for 15 min, and remained stable after extensive storage at 4°C. Autoinducers in the cell-free culture fluids from Corynebacterium ammoniagenes and Pseudomonas aeruginosa also induced the expression of acyltransferase in C. glutamicum, suggesting possible cross-recognition of the autoinducers by C. glutamicum. C. glutamicum thus possesses an autoinduction system which secretes autoinducers during growth, triggering the expression of downstream genes, exemplified by the putative acyltransferase gene.
- 7 September 2010
- Published by Springer Nature in Biotechnology Letters
- Vol. 33 (1) , 97-102
Autoinduction of a genetic locus encoding putative acyltransferase in Corynebacterium glutamicum
A genetic locus, encoding putative acyltransferase, was induced by autoinducers in Corynebacterium glutamicum. The autoinducers were maximally produced by the bacterium after 24 h culture. Those molecules are resistant to proteinase K treatment (300 μg ml−1) for 30 min at 37°C or at 121°C for 15 min, and remained stable after extensive storage at 4°C. Autoinducers in the cell-free culture fluids from Corynebacterium ammoniagenes and Pseudomonas aeruginosa also induced the expression of acyltransferase in C. glutamicum, suggesting possible cross-recognition of the autoinducers by C. glutamicum. C. glutamicum thus possesses an autoinduction system which secretes autoinducers during growth, triggering the expression of downstream genes, exemplified by the putative acyltransferase gene.