Jeroen A. Deijkers
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Jeroen A. Deijkers has a total of 32 co-authors. Here are the top co-authors by number of shared publications:
Haydn N.G. Wadley
4 shared publications- Haydn N. G. Wadley
University of Virginia Department of Materials Science and Engineering 395 McCormick Rd., P.O. Box 400745, Charlottesville, Virginia 22904
3 shared publications - Prasanna Venkataraman Balachandran
Department of Materials Science and Engineering, University of Virginia, Charlottesville, USA
3 shared publications Haydn Wadley
2 shared publications- John Thomas Gaskins
Department of Mechanical and Aerospace Engineering, University of Virginia, Charlottesville, Virginia 22904, United States
2 shared publications - Patrick Edward Hopkins
University of Virginia
2 shared publications
Latest Publications
- 11 September 2026
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 47 (2)
Infrared absorption of lanthanide disilicate environmental barrier coating materials
- 11 September 2026
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 47 (2)
Infrared absorption of lanthanide disilicate environmental barrier coating materials
- Open Access
- 14 August 2026
- Published by Elsevier in SSRN Electronic Journal
The Infrared Properties of Ytterbium Disilicate
Ytterbium disilicate (Yb2Si2O7: YbDS) is a wide-bandgap, high-melting-temperature, polar material widely used as the primary thermal and environmental barrier coating for silicon carbide composites deployed in the hottest regions of advanced gas turbine engines. These coatings are exposed to a substantial radiative flux spanning the ultraviolet through the mid-infrared as well as to convective heating. To assess the significance of radiative heating from combustion gas emissions, the complex dielectric function of polycrystalline YbDS has been characterized from ambient to 1,000 °C using infrared spectroscopic ellipsometry and Fourier transform infrared spectroscopy. Density functional theory calculations of the zone-center phonon modes, combined with Born effective charge calculations, were used to identify the infrared-active phonon modes responsible for the observed spectral features. The measured intrinsic optical properties have enabled the fractions of incident flux that are reflected, transmitted, absorbed, and re-emitted by YbDS coating materials to be deduced. These fractions are strongly wavelength-dependent in the near and mid-infrared but are only weakly influenced by temperature. The experimental measurements reveal that YbDS has a low reflectance and is highly transparent in the 2-5 μm wavelength region, indicating that coating-protected SiC components are vulnerable to radiative heating by combustion gases. The phonon calculations show that the spectral location of the transparency window results from those of the longitudinal and transverse optical phonon modes. Their wavelengths are determined by displacements of the Si-O bonds whose stiffness and effective ion mass are intrinsic properties of the disilicate sublattice and effected little by the lanthanide ion.
- 14 August 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessThe Infrared Properties of Ytterbium Disilicate
Ytterbium disilicate (Yb2Si2O7: YbDS) is a wide-bandgap, high-melting-temperature, polar material widely used as the primary thermal and environmental barrier coating for silicon carbide composites deployed in the hottest regions of advanced gas turbine engines. These coatings are exposed to a substantial radiative flux spanning the ultraviolet through the mid-infrared as well as to convective heating. To assess the significance of radiative heating from combustion gas emissions, the complex dielectric function of polycrystalline YbDS has been characterized from ambient to 1,000 °C using infrared spectroscopic ellipsometry and Fourier transform infrared spectroscopy. Density functional theory calculations of the zone-center phonon modes, combined with Born effective charge calculations, were used to identify the infrared-active phonon modes responsible for the observed spectral features. The measured intrinsic optical properties have enabled the fractions of incident flux that are reflected, transmitted, absorbed, and re-emitted by YbDS coating materials to be deduced. These fractions are strongly wavelength-dependent in the near and mid-infrared but are only weakly influenced by temperature. The experimental measurements reveal that YbDS has a low reflectance and is highly transparent in the 2-5 μm wavelength region, indicating that coating-protected SiC components are vulnerable to radiative heating by combustion gases. The phonon calculations show that the spectral location of the transparency window results from those of the longitudinal and transverse optical phonon modes. Their wavelengths are determined by displacements of the Si-O bonds whose stiffness and effective ion mass are intrinsic properties of the disilicate sublattice and effected little by the lanthanide ion.
- Open Access
- 27 November 2025
- Published by Elsevier in Materials & Design
- Vol. 260
Optical absorption of lanthanide disilicate environmental barrier coating materials
- 27 November 2025
- Published by Elsevier in Materials & Design
- Vol. 260
Open AccessOptical absorption of lanthanide disilicate environmental barrier coating materials
- Open Access
- 6 June 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 41 (4)
Noise reduction and peak detection in x-ray diffraction data by linear and nonlinear methods
Considerable progress has been made in the last few years in removing white noise from visible–near-ultraviolet (UV/VIS) spectra while leaving information intact. For x-ray diffraction, the challenges are different: detecting and locating peaks rather than line shape analysis. Here, we investigate possibilities of state-of-the-art UV/VIS methods for noise reduction, peak detection, and peak location applied to x-ray diffraction data, in this case, data for a ZrO2 −33 mol. % TaO4 ceramic. The same advantages seen in UV/VIS spectroscopy are found here as well.
- 6 June 2023
- Published by American Vacuum Society in Journal of Vacuum Science & Technology B
- Vol. 41 (4)
Open AccessNoise reduction and peak detection in x-ray diffraction data by linear and nonlinear methods
Considerable progress has been made in the last few years in removing white noise from visible–near-ultraviolet (UV/VIS) spectra while leaving information intact. For x-ray diffraction, the challenges are different: detecting and locating peaks rather than line shape analysis. Here, we investigate possibilities of state-of-the-art UV/VIS methods for noise reduction, peak detection, and peak location applied to x-ray diffraction data, in this case, data for a ZrO2 −33 mol. % TaO4 ceramic. The same advantages seen in UV/VIS spectroscopy are found here as well.
- 1 September 2021
- Published by Elsevier in Acta Materialia
- Vol. 217
A duplex bond coat approach to environmental barrier coating systems
- 1 September 2021
- Published by Elsevier in Acta Materialia
- Vol. 217
A duplex bond coat approach to environmental barrier coating systems
- 1 March 2021
- Published by Elsevier in Materials Today Physics
- Vol. 17
Evolution of microstructure and thermal conductivity of multifunctional environmental barrier coating systems
- 1 March 2021
- Published by Elsevier in Materials Today Physics
- Vol. 17
Evolution of microstructure and thermal conductivity of multifunctional environmental barrier coating systems
- 1 August 2020
- Published by Elsevier in Materialia
- Vol. 12
The thermal and mechanical properties of hafnium orthosilicate: Experiments and first-principles calculations
- 1 August 2020
- Published by Elsevier in Materialia
- Vol. 12
The thermal and mechanical properties of hafnium orthosilicate: Experiments and first-principles calculations
- 28 May 2020
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (9) , 5400-5410
Hafnium silicate formation during the reaction of β‐cristobalite SiO 2 and monoclinic HfO 2 particles
Hafnium silicate (HfSiO 4 ; hafnon) is under consideration as an environmental barrier coating material for high‐temperature applications. However, its rate of formation from mixtures of monoclinic HfO 2 and crystalline (β‐cristobalite) SiO 2 powders is unknown. Here it has been synthesized and its formation rate measured during their solid‐state reaction at temperatures from 1250°C to 1400°C. Rietveld refinement of X‐ray diffraction patterns indicates that at 1250°C the hafnon phase fraction increases linearly with time, while at the highest reaction temperature, the hafnon phase fraction exhibited a parabolic dependence upon time. Between these two limiting temperatures, a region of linear behavior preceded a transition to parabolic kinetics, with the transition occurring at an earlier time as the reaction temperature increased. Arrhenius relations fitted the kinetics of hafnium silicate formation in both the linear and parabolic regimes. Scanning electron microscopy indicated that the reaction proceeded by diffusion of SiO 2 into HfO 2 , similar to the mechanism by which zirconium silicate has been formed from vitreous SiO 2 and tetragonal ZrO 2 . The initial linear rate of reaction is consistent with the growth of the contact area between the SiO 2 and HfO 2 particles combined with rapid permeation of the Si 4+ and O 2− through the initial, incompletely formed hafnon. After a thin hafnon layer had formed between the reactants, the rate of hafnium silicate growth slowed and further growth was governed by the rate of diffusion of Si 4+ and O 2− through the reaction product consistent with the observed parabolic dependence of the phase fraction upon time.
- 28 May 2020
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (9) , 5400-5410
Hafnium silicate formation during the reaction of β‐cristobalite SiO 2 and monoclinic HfO 2 particles
Hafnium silicate (HfSiO 4 ; hafnon) is under consideration as an environmental barrier coating material for high‐temperature applications. However, its rate of formation from mixtures of monoclinic HfO 2 and crystalline (β‐cristobalite) SiO 2 powders is unknown. Here it has been synthesized and its formation rate measured during their solid‐state reaction at temperatures from 1250°C to 1400°C. Rietveld refinement of X‐ray diffraction patterns indicates that at 1250°C the hafnon phase fraction increases linearly with time, while at the highest reaction temperature, the hafnon phase fraction exhibited a parabolic dependence upon time. Between these two limiting temperatures, a region of linear behavior preceded a transition to parabolic kinetics, with the transition occurring at an earlier time as the reaction temperature increased. Arrhenius relations fitted the kinetics of hafnium silicate formation in both the linear and parabolic regimes. Scanning electron microscopy indicated that the reaction proceeded by diffusion of SiO 2 into HfO 2 , similar to the mechanism by which zirconium silicate has been formed from vitreous SiO 2 and tetragonal ZrO 2 . The initial linear rate of reaction is consistent with the growth of the contact area between the SiO 2 and HfO 2 particles combined with rapid permeation of the Si 4+ and O 2− through the initial, incompletely formed hafnon. After a thin hafnon layer had formed between the reactants, the rate of hafnium silicate growth slowed and further growth was governed by the rate of diffusion of Si 4+ and O 2− through the reaction product consistent with the observed parabolic dependence of the phase fraction upon time.
- 25 March 2020
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (8) , 4489-4497
Density functional theory and machine learning guided search for RE 2 Si 2 O 7 with targeted coefficient of thermal expansion
Density functional theory (DFT) calculations and machine learning (ML) methods are used to establish a relationship between the crystal structures of rare‐earth (RE) disilicates (RE 2 Si 2 O 7 ) and their coefficient of thermal expansion (CTE). The DFT total energy data predict the presence of several energetically competing crystal structures, which is rationalized as one of the reasons for observing polymorphism. An ensemble of support vector regression models is trained to rapidly predict the CTE as a function of RE 2 Si 2 O 7 crystal chemistry. Experiments subsequently validated the structure and CTE predictions for Sm 2 Si 2 O 7 .
- 25 March 2020
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (8) , 4489-4497
Density functional theory and machine learning guided search for RE 2 Si 2 O 7 with targeted coefficient of thermal expansion
Density functional theory (DFT) calculations and machine learning (ML) methods are used to establish a relationship between the crystal structures of rare‐earth (RE) disilicates (RE 2 Si 2 O 7 ) and their coefficient of thermal expansion (CTE). The DFT total energy data predict the presence of several energetically competing crystal structures, which is rationalized as one of the reasons for observing polymorphism. An ensemble of support vector regression models is trained to rapidly predict the CTE as a function of RE 2 Si 2 O 7 crystal chemistry. Experiments subsequently validated the structure and CTE predictions for Sm 2 Si 2 O 7 .