Michal Leibner
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Michal Leibner has a total of 29 co-authors. Here are the top co-authors by number of shared publications:
- Hana Kudrnova
Charles University in Prague
4 shared publications - Lucia Bajtošová
Charles University
4 shared publications - Martin Vlach
Charles University
4 shared publications - Miroslav Cieslar
Faculty of Mathematics and Physics, Charles University, Ke Karlovu 5, 121 16 Prague, Czech Republic
4 shared publications - Veronika Kodetová
Faculty of Mathematics and Physics, Charles University, Prague, Czech Republic
4 shared publications Hana Kudrnová
Charles University, Faculty of Mathematics and Physics, Prague, Czech Republic, EU
2 shared publications
Latest Publications
- Open Access
Heat Treatment of Cast and Cold Rolled Al–Yb and Al–Mn–Yb–Zr Alloys
The microstructure, electrical properties and microhardness of as-cast and cold rolled AlYb and AlMnYbZr alloys were investigated. The addition of Mn, Yb and Zr has a positive influence on grain size. A deformed structure of the grains with no changes of their size was observed after cold rolling. The Al3Yb particles coherent with the matrix were observed in the AlYb alloys. The size of the particles was about 20 nm in the initial state; after isochronal treatment up to 540 °C the particles coarsen, and their number density was lower. The deformation has a massive effect on the microhardness behavior until treatment at 390 °C, after which the difference in microhardness changes between as-cast and cold rolled alloys disappeared. Relative resistivity changes show a large decrease in the temperature interval of 330–540 °C which is probably caused by a combination of recovery of dislocations and precipitation of the Al3(Yb,Zr) particles. Precipitation hardening was observed between 100 and 450 °C in the AlYb alloy after ageing at 625 °C/24 h and between 330 and 570 °C in the AlMnYbZr alloy after ageing at 625 °C/24 h.
Open AccessHeat Treatment of Cast and Cold Rolled Al–Yb and Al–Mn–Yb–Zr Alloys
The microstructure, electrical properties and microhardness of as-cast and cold rolled AlYb and AlMnYbZr alloys were investigated. The addition of Mn, Yb and Zr has a positive influence on grain size. A deformed structure of the grains with no changes of their size was observed after cold rolling. The Al3Yb particles coherent with the matrix were observed in the AlYb alloys. The size of the particles was about 20 nm in the initial state; after isochronal treatment up to 540 °C the particles coarsen, and their number density was lower. The deformation has a massive effect on the microhardness behavior until treatment at 390 °C, after which the difference in microhardness changes between as-cast and cold rolled alloys disappeared. Relative resistivity changes show a large decrease in the temperature interval of 330–540 °C which is probably caused by a combination of recovery of dislocations and precipitation of the Al3(Yb,Zr) particles. Precipitation hardening was observed between 100 and 450 °C in the AlYb alloy after ageing at 625 °C/24 h and between 330 and 570 °C in the AlMnYbZr alloy after ageing at 625 °C/24 h.
- Open Access
- 1 January 2021
- Published by TANGER Ltd.
Mechanical and electrical properties of cast Al–Er–Zr alloy
- 1 January 2021
- Published by TANGER Ltd.
Open AccessMechanical and electrical properties of cast Al–Er–Zr alloy
- Open Access
Role of Small Addition of Sc and Zr in Clustering and Precipitation Phenomena Induced in AA7075
A detailed characterization of phase transformations in the heat-treated commercial 7075 aluminum alloys without/with low Sc–Zr addition was carried out. Mechanical and electrical properties, thermal and corrosion behavior were compared to the microstructure development. The eutectic phase consists of four parts: MgZn2 phase, Al2CuMg phase (S-phase), Al2Zn3Mg3 phase (T-phase), and primary λ-Al(Mn,Fe,Si) phase. Strengthening during non-isothermal (isochronal) annealing is caused by a combination of formation of the GP zones, η’-phase, T-phase and co-presence of the primary and secondary Al3(Sc,Zr)-phase particles. Positive influence on corrosion properties is owing to the addition of Sc–Zr. Positron annihilation showed an evolution of solute Zn,Mg-(co-)clusters into (precursors of) the GP zones in the course of natural ageing. The concentration of the (co-)clusters is slightly negatively affected by the low Sc–Zr addition. A combination of both precipitation sequences of the Al–Zn–Mg–Cu-based system was observed. The apparent activation energy values for dissolution/formation of the clusters/GP zones and for formation of the metastable η’-phase, stable T-phase and stable η-phase were calculated.
Open AccessRole of Small Addition of Sc and Zr in Clustering and Precipitation Phenomena Induced in AA7075
A detailed characterization of phase transformations in the heat-treated commercial 7075 aluminum alloys without/with low Sc–Zr addition was carried out. Mechanical and electrical properties, thermal and corrosion behavior were compared to the microstructure development. The eutectic phase consists of four parts: MgZn2 phase, Al2CuMg phase (S-phase), Al2Zn3Mg3 phase (T-phase), and primary λ-Al(Mn,Fe,Si) phase. Strengthening during non-isothermal (isochronal) annealing is caused by a combination of formation of the GP zones, η’-phase, T-phase and co-presence of the primary and secondary Al3(Sc,Zr)-phase particles. Positive influence on corrosion properties is owing to the addition of Sc–Zr. Positron annihilation showed an evolution of solute Zn,Mg-(co-)clusters into (precursors of) the GP zones in the course of natural ageing. The concentration of the (co-)clusters is slightly negatively affected by the low Sc–Zr addition. A combination of both precipitation sequences of the Al–Zn–Mg–Cu-based system was observed. The apparent activation energy values for dissolution/formation of the clusters/GP zones and for formation of the metastable η’-phase, stable T-phase and stable η-phase were calculated.
- Open Access
- 1 January 2020
- Published by TANGER Ltd.
- Vol. 2020, 1024-1029
THERMAL CHARACTERISTICS AND ELECTRICAL PROPERTIES OF HOT DEFORMED AA7075 ALLOYS WITH AND WITHOUT Sc, Zr ADDITIONS
- 1 January 2020
- Published by TANGER Ltd.
- Vol. 2020, 1024-1029
Open AccessTHERMAL CHARACTERISTICS AND ELECTRICAL PROPERTIES OF HOT DEFORMED AA7075 ALLOYS WITH AND WITHOUT Sc, Zr ADDITIONS
- Open Access
- 1 January 2018
- Published by Central Library of the Slovak Academy of Sciences in Metallic Materials
- Vol. 56 (06) , 367-377
Characterization of phase development in commercial Al-Zn-Mg(-Mn,Fe) alloy with and without Sc,Zr-addition
Characterization of phase development in commercial Al-Zn-Mg(-Mn,Fe) alloy with and without Sc,Zr-addition
- 1 January 2018
- Published by Central Library of the Slovak Academy of Sciences in Metallic Materials
- Vol. 56 (06) , 367-377
Open AccessCharacterization of phase development in commercial Al-Zn-Mg(-Mn,Fe) alloy with and without Sc,Zr-addition
Characterization of phase development in commercial Al-Zn-Mg(-Mn,Fe) alloy with and without Sc,Zr-addition