Role of Small Addition of Sc and Zr in Clustering and Precipitation Phenomena Induced in AA7075
Authors:
- Martin VlachMVMartin Vlach
- Veronika KodetovaVKVeronika Kodetova
- Jakub CizekJakub Cizek
- Michal LeibnerMLMichal Leibner
- Tomáš KekuleTKTomáš Kekule
- František LukáčFLFrantišek Lukáč
- Miroslav CieslarMCMiroslav Cieslar
- Lucia BajtošováLBLucia Bajtošová
- Hana KudrnováHKHana Kudrnová
- Vladimir SimaVSVladimir Sima
- Sebastian ZikmundSZSebastian Zikmund
- Eva CernoskovaECEva Cernoskova
Open Access
Abstract
A detailed characterization of phase transformations in the heat-treated commercial 7075 aluminum alloys without/with low Sc–Zr addition was carried out. Mechanical and electrical properties, thermal and corrosion behavior were compared to the microstructure development. The eutectic phase consists of four parts: MgZn2 phase, Al2CuMg phase (S-phase), Al2Zn3Mg3 phase (T-phase), and primary λ-Al(Mn,Fe,Si) phase. Strengthening during non-isothermal (isochronal) annealing is caused by a combination of formation of the GP zones, η’-phase, T-phase and co-presence of the primary and secondary Al3(Sc,Zr)-phase particles. Positive influence on corrosion properties is owing to the addition of Sc–Zr. Positron annihilation showed an evolution of solute Zn,Mg-(co-)clusters into (precursors of) the GP zones in the course of natural ageing. The concentration of the (co-)clusters is slightly negatively affected by the low Sc–Zr addition. A combination of both precipitation sequences of the Al–Zn–Mg–Cu-based system was observed. The apparent activation energy values for dissolution/formation of the clusters/GP zones and for formation of the metastable η’-phase, stable T-phase and stable η-phase were calculated.Keywords
Funding Information
- Grantová Agentura České Republiky (17-17139S)
This publication has 70 references indexed in Scilit:
- The coexistence of two S (Al2CuMg) phases in Al–Cu–Mg alloysActa Materialia, 2012
- Investigation of microstructural evolution and mechanical properties during two-step ageing treatment at 115 and 160 °C in an Al–Zn–Mg–Cu alloy pre-stretched thick plateMaterials Characterization, 2008
- The microstructural evolution of an Al–Zn–Mg–Cu alloy during homogenizationMaterials Letters, 2006
- On the nature of T(Al2Mg3Zn3) and S(Al2CuMg) phases present in as-cast and annealed 7055 aluminum alloyMaterials Science and Engineering: A, 2005
- Microstructures and mechanical properties of ultrafine grained 7075 Al alloy processed by ECAP and their evolutions during annealingActa Materialia, 2004
- A model for the yield strength of overaged Al–Zn–Mg–Cu alloysActa Materialia, 2003
- The determination of activation energy from linear heating rate experiments: a comparison of the accuracy of isoconversion methodsThermochimica Acta, 2003
- Interaction of recrystallization and precipitation: The effect of Al3Sc on the recrystallization behaviour of deformed aluminiumActa Materialia, 2003
- Modelling of the age hardening behaviour of Al–Mg–Si alloysActa Materialia, 2001
- A resistivity study of 7012 Al-Zn-Mg alloy commercial tempersMaterials Letters, 1987