Chaikarn Liewhiran
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Chaikarn Liewhiran has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
Anurat Wisitsoraat
National Science and Technology Development Agency (NSTDA) Khlong Luang
15 shared publicationsKanittha Inyawilert
Office of Research Administration
10 shared publicationsMameaseng Siriwalai
9 shared publicationsAdisorn Tuantranont
Natl Sci & Technol Dev Agcy NSTDA, Natl Secur & Dual Use Technol Ctr, Klongluang 12120, Phathum Thani, Thailand
7 shared publicationsMatawee Punginsang
Office of Research Administration
7 shared publications- Matawee Punginsang
Chiang Mai University
3 shared publications
Latest Publications
- Open Access
- 18 August 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (34) , 51388-51403
Humidity-Enhanced Effects of Sputtered Au Nanoparticles on the Ethanol Sensing Performance of Thermally Evaporated ZnO Nanowires
Mitigating the adverse effects of humidity on the sensing performance of one-dimensional (1D) metal oxide semiconductors has been a key challenge in gas sensor development. This study investigated the humidity-enhanced effect of gold (Au) nanoparticles on the ethanol response of 1D ZnO nanostructures. ZnO nanowires were grown using a thermal evaporation–condensation method with Au-catalyzed growth kinetics for the fabrication of conductometric chemical sensors. Au nanoparticles were then additionally decorated on ZnO nanostructures by sputtering with varying times from 2 to 10 s. Structural examinations demonstrated Au nanoparticles with diverse diameters (10–70 nm) widely distributed on ZnO nanowires exhibiting lengths of 0.1–1 μm and diameters of 10–30 nm. All fabricated sensors were systematically evaluated toward NO2, NH3, C3H6O, CO, and C2H5OH at 250–400 °C under dry and humid conditions. ZnO nanowires functionalized with Au for 5 s were found to exhibit the highest response of 93.75 to 70 ppm of C2H5OH, which was significantly greater than that of the pristine ZnO nanowire sensor (1.86) at 50% relative humidity (RH) and the optimum sensing temperature of 350 °C. Interestingly, the optimally Au-decorated ZnO nanowire sensor showed humidity-enhanced behaviors with significantly boosted ethanol responses at 50% RH. In addition, the optimal sensor displayed a low theoretical limit of detections (3.7 ppb) and high C2H5OH selectivity against interfering gases, including NO2, NH3, C3H6O, and CO. The observed ethanol response improvement and humidity-enhanced effect might be ascribed to the attributes of ohmic metal–semiconductor junctions formed at Au–ZnO interfaces and the capabilities of very fine sputtered Au nanoparticles to enhance oxygen chemisorption and suppress the formation of surface hydroxyl and hydronium species on ZnO nanowires. According to the results, Au-decorated ZnO nanowires fabricated by evaporation–condensation and sputtering could be potential candidates for use as practical C2H5OH sensors.
- 18 August 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (34) , 51388-51403
Open AccessHumidity-Enhanced Effects of Sputtered Au Nanoparticles on the Ethanol Sensing Performance of Thermally Evaporated ZnO Nanowires
Mitigating the adverse effects of humidity on the sensing performance of one-dimensional (1D) metal oxide semiconductors has been a key challenge in gas sensor development. This study investigated the humidity-enhanced effect of gold (Au) nanoparticles on the ethanol response of 1D ZnO nanostructures. ZnO nanowires were grown using a thermal evaporation–condensation method with Au-catalyzed growth kinetics for the fabrication of conductometric chemical sensors. Au nanoparticles were then additionally decorated on ZnO nanostructures by sputtering with varying times from 2 to 10 s. Structural examinations demonstrated Au nanoparticles with diverse diameters (10–70 nm) widely distributed on ZnO nanowires exhibiting lengths of 0.1–1 μm and diameters of 10–30 nm. All fabricated sensors were systematically evaluated toward NO2, NH3, C3H6O, CO, and C2H5OH at 250–400 °C under dry and humid conditions. ZnO nanowires functionalized with Au for 5 s were found to exhibit the highest response of 93.75 to 70 ppm of C2H5OH, which was significantly greater than that of the pristine ZnO nanowire sensor (1.86) at 50% relative humidity (RH) and the optimum sensing temperature of 350 °C. Interestingly, the optimally Au-decorated ZnO nanowire sensor showed humidity-enhanced behaviors with significantly boosted ethanol responses at 50% RH. In addition, the optimal sensor displayed a low theoretical limit of detections (3.7 ppb) and high C2H5OH selectivity against interfering gases, including NO2, NH3, C3H6O, and CO. The observed ethanol response improvement and humidity-enhanced effect might be ascribed to the attributes of ohmic metal–semiconductor junctions formed at Au–ZnO interfaces and the capabilities of very fine sputtered Au nanoparticles to enhance oxygen chemisorption and suppress the formation of surface hydroxyl and hydronium species on ZnO nanowires. According to the results, Au-decorated ZnO nanowires fabricated by evaporation–condensation and sputtering could be potential candidates for use as practical C2H5OH sensors.
- Open Access
- 7 August 2025
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 10 (8) , 5748-5759
Performance and Selectivity toward Acetone against Various Gaseous Markers for Liver Diseases of Flame-Made Ir-Loaded In2O3 Nanoparticulate Sensors
In this work, iridium (Ir) loaded indium oxide (In2O3) nanoparticles made via a flame spray pyrolysis (FSP) technique for the first time were systematically investigated for acetone (C3H6O) detection at ppb levels. The structural data based on microscopic and spectroscopic analyses unveiled that 3-6 nm secondary metallic Ir nanoparticles were loaded on 8-15 nm cubic In2O3 nanoparticles with uniform dispersion at a low Ir content of 0.5 wt % or less. Sensing films fabricated from the powders via a spin-coating process were assessed for their gas-sensing properties toward four groups of breath gases including environmental gases, volatile organic compounds, volatile organic acids or short-chain fatty acids, and volatile sulfur compounds. From the test results, the optimum Ir loading level of 0.5 wt % yielded the highest response (S = 6.02-1000 ppb C3H6O) with a low detection limit of 10.7 ppb and good acetone selectivity against numerous breath gases at 300 °C. In addition, the 0.5 wt % Ir-loaded In2O3 sensor exhibited a modestly low acetone response decline of less than 25% in humid air (80%RH) at 300 °C. Consequently, the 0.5 wt % Ir-loaded In2O3 nanomaterial was attractive for sensitive detections of acetone at ppb levels applicable to medical applications, including initial screening of liver diseases.
- 7 August 2025
- Published by American Chemical Society (ACS) in ACS Sensors
- Vol. 10 (8) , 5748-5759
Open AccessPerformance and Selectivity toward Acetone against Various Gaseous Markers for Liver Diseases of Flame-Made Ir-Loaded In2O3 Nanoparticulate Sensors
In this work, iridium (Ir) loaded indium oxide (In2O3) nanoparticles made via a flame spray pyrolysis (FSP) technique for the first time were systematically investigated for acetone (C3H6O) detection at ppb levels. The structural data based on microscopic and spectroscopic analyses unveiled that 3-6 nm secondary metallic Ir nanoparticles were loaded on 8-15 nm cubic In2O3 nanoparticles with uniform dispersion at a low Ir content of 0.5 wt % or less. Sensing films fabricated from the powders via a spin-coating process were assessed for their gas-sensing properties toward four groups of breath gases including environmental gases, volatile organic compounds, volatile organic acids or short-chain fatty acids, and volatile sulfur compounds. From the test results, the optimum Ir loading level of 0.5 wt % yielded the highest response (S = 6.02-1000 ppb C3H6O) with a low detection limit of 10.7 ppb and good acetone selectivity against numerous breath gases at 300 °C. In addition, the 0.5 wt % Ir-loaded In2O3 sensor exhibited a modestly low acetone response decline of less than 25% in humid air (80%RH) at 300 °C. Consequently, the 0.5 wt % Ir-loaded In2O3 nanomaterial was attractive for sensitive detections of acetone at ppb levels applicable to medical applications, including initial screening of liver diseases.
- Open Access
- 29 April 2025
- Published by Elsevier in Talanta Open
- Vol. 11
Selectivity towards methyl mercaptan of Pt-PtO functionalized WO3 nanostructures made by flame spray pyrolysis
- 29 April 2025
- Published by Elsevier in Talanta Open
- Vol. 11
Open AccessSelectivity towards methyl mercaptan of Pt-PtO functionalized WO3 nanostructures made by flame spray pyrolysis
- Open Access
- 6 February 2025
- Published by Elsevier in Talanta Open
- Vol. 11
High-performance room-temperature formic acid vapor sensors based on multi-walled carbon nanotubes/polypyrrole composites
- 6 February 2025
- Published by Elsevier in Talanta Open
- Vol. 11
Open AccessHigh-performance room-temperature formic acid vapor sensors based on multi-walled carbon nanotubes/polypyrrole composites
- 30 November 2023
- Published by Chiang Mai University in Chiang Mai Journal of Science
- Vol. 50 (6) , 1-18
Formic Acid Gas Sensors Based on Electrolytically Exfoliated Graphene-loaded Flame-Made Spinel Zn2SnO4 Composites
In this w ork, effective gas-sensing material were prepared by combining spinel zinc stannate (Zn2SnO4) nanoparticles synthesized by flame spray pyrolysis and graphene produced by the electrolytic exfoliation for volatile organic acids (VOAs) detection. The effect of graphene content in the range of 0.2–5 wt% on formic acid (HCOOH)-sensing performance of Zn2SnO4 nanoparticles was evaluated. Structural, physical, and chemical properties were investigated using X-ray diffraction, Raman spectroscopy, BET-surface analysis, energy dispersive X-ray spectroscopy, and electron microscopy. From the gas-sensing test towards 0.005-0.1 vol% HCOOH in dry air at 200-400°C, the graphene-loaded Zn2SnO4 sensor with the optimal graphene content of 0.5 wt% displayed the highest response of ~4970 towards HCOOH at the optimal temperature of 300°C. Moreover, it showed high HCOOH selectivity against several other VOAs, volatile organic compounds, and environmental gases. Therefore, graphene-loaded spinel Zn2SnO4 sensors could be attractive choices for selective HCOOH detection and useful for food science and industrial applications.
- 30 November 2023
- Published by Chiang Mai University in Chiang Mai Journal of Science
- Vol. 50 (6) , 1-18
Formic Acid Gas Sensors Based on Electrolytically Exfoliated Graphene-loaded Flame-Made Spinel Zn2SnO4 Composites
In this w ork, effective gas-sensing material were prepared by combining spinel zinc stannate (Zn2SnO4) nanoparticles synthesized by flame spray pyrolysis and graphene produced by the electrolytic exfoliation for volatile organic acids (VOAs) detection. The effect of graphene content in the range of 0.2–5 wt% on formic acid (HCOOH)-sensing performance of Zn2SnO4 nanoparticles was evaluated. Structural, physical, and chemical properties were investigated using X-ray diffraction, Raman spectroscopy, BET-surface analysis, energy dispersive X-ray spectroscopy, and electron microscopy. From the gas-sensing test towards 0.005-0.1 vol% HCOOH in dry air at 200-400°C, the graphene-loaded Zn2SnO4 sensor with the optimal graphene content of 0.5 wt% displayed the highest response of ~4970 towards HCOOH at the optimal temperature of 300°C. Moreover, it showed high HCOOH selectivity against several other VOAs, volatile organic compounds, and environmental gases. Therefore, graphene-loaded spinel Zn2SnO4 sensors could be attractive choices for selective HCOOH detection and useful for food science and industrial applications.
- 29 November 2023
- Published by Chiang Mai University in Chiang Mai Journal of Science
- Vol. 50 (6) , 1-18
Highly Selective NO2 Sensors Based on Electrolytically Exfoliated Graphene/Flame-made WO3 Composite Films
Chiang Mai Journal of Science, Faculty of Science, Chiang Mai University
- 29 November 2023
- Published by Chiang Mai University in Chiang Mai Journal of Science
- Vol. 50 (6) , 1-18
Highly Selective NO2 Sensors Based on Electrolytically Exfoliated Graphene/Flame-made WO3 Composite Films
Chiang Mai Journal of Science, Faculty of Science, Chiang Mai University
- 27 October 2023
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 299
H2S-sensing properties of flame-synthesized RuO2-decorated WO3 nanoparticulate spin-coated films
- 27 October 2023
- Published by Elsevier in Materials Science and Engineering: B
- Vol. 299
H2S-sensing properties of flame-synthesized RuO2-decorated WO3 nanoparticulate spin-coated films