Matawee Punginsang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Matawee Punginsang has a total of 11 co-authors. Here are the top co-authors by number of shared publications:
Anurat Wisitsoraat
National Science and Technology Development Agency (NSTDA) Khlong Luang
3 shared publications- Chaikarn Liewhiran
Department of Physics and Materials Science, Faculty of Science, Chiang Mai University, Chiang Mai 50200, Thailand
3 shared publications Andrea Ponzoni
Università degli Studi di Brescia Via Branze 45
2 shared publications- Elisabetta Comini
Sensor Lab, Department of Information Engineering, Brescia University, 25133 Brescia, Italy
2 shared publications Giorgio Sberveglieri
Università degli Studi di Brescia Via Branze 38
2 shared publicationsAdisorn Tuantranont
National Security and Dual-Use Technology Center, National Science and Technology Development Agency (NSTDA), Klong Luang, Phathum Thani 12120, Thailand
1 shared publication
Latest Publications
- Open Access
- 18 August 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (34) , 51388-51403
Humidity-Enhanced Effects of Sputtered Au Nanoparticles on the Ethanol Sensing Performance of Thermally Evaporated ZnO Nanowires
Mitigating the adverse effects of humidity on the sensing performance of one-dimensional (1D) metal oxide semiconductors has been a key challenge in gas sensor development. This study investigated the humidity-enhanced effect of gold (Au) nanoparticles on the ethanol response of 1D ZnO nanostructures. ZnO nanowires were grown using a thermal evaporation–condensation method with Au-catalyzed growth kinetics for the fabrication of conductometric chemical sensors. Au nanoparticles were then additionally decorated on ZnO nanostructures by sputtering with varying times from 2 to 10 s. Structural examinations demonstrated Au nanoparticles with diverse diameters (10–70 nm) widely distributed on ZnO nanowires exhibiting lengths of 0.1–1 μm and diameters of 10–30 nm. All fabricated sensors were systematically evaluated toward NO2, NH3, C3H6O, CO, and C2H5OH at 250–400 °C under dry and humid conditions. ZnO nanowires functionalized with Au for 5 s were found to exhibit the highest response of 93.75 to 70 ppm of C2H5OH, which was significantly greater than that of the pristine ZnO nanowire sensor (1.86) at 50% relative humidity (RH) and the optimum sensing temperature of 350 °C. Interestingly, the optimally Au-decorated ZnO nanowire sensor showed humidity-enhanced behaviors with significantly boosted ethanol responses at 50% RH. In addition, the optimal sensor displayed a low theoretical limit of detections (3.7 ppb) and high C2H5OH selectivity against interfering gases, including NO2, NH3, C3H6O, and CO. The observed ethanol response improvement and humidity-enhanced effect might be ascribed to the attributes of ohmic metal–semiconductor junctions formed at Au–ZnO interfaces and the capabilities of very fine sputtered Au nanoparticles to enhance oxygen chemisorption and suppress the formation of surface hydroxyl and hydronium species on ZnO nanowires. According to the results, Au-decorated ZnO nanowires fabricated by evaporation–condensation and sputtering could be potential candidates for use as practical C2H5OH sensors.
- 18 August 2026
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 11 (34) , 51388-51403
Open AccessHumidity-Enhanced Effects of Sputtered Au Nanoparticles on the Ethanol Sensing Performance of Thermally Evaporated ZnO Nanowires
Mitigating the adverse effects of humidity on the sensing performance of one-dimensional (1D) metal oxide semiconductors has been a key challenge in gas sensor development. This study investigated the humidity-enhanced effect of gold (Au) nanoparticles on the ethanol response of 1D ZnO nanostructures. ZnO nanowires were grown using a thermal evaporation–condensation method with Au-catalyzed growth kinetics for the fabrication of conductometric chemical sensors. Au nanoparticles were then additionally decorated on ZnO nanostructures by sputtering with varying times from 2 to 10 s. Structural examinations demonstrated Au nanoparticles with diverse diameters (10–70 nm) widely distributed on ZnO nanowires exhibiting lengths of 0.1–1 μm and diameters of 10–30 nm. All fabricated sensors were systematically evaluated toward NO2, NH3, C3H6O, CO, and C2H5OH at 250–400 °C under dry and humid conditions. ZnO nanowires functionalized with Au for 5 s were found to exhibit the highest response of 93.75 to 70 ppm of C2H5OH, which was significantly greater than that of the pristine ZnO nanowire sensor (1.86) at 50% relative humidity (RH) and the optimum sensing temperature of 350 °C. Interestingly, the optimally Au-decorated ZnO nanowire sensor showed humidity-enhanced behaviors with significantly boosted ethanol responses at 50% RH. In addition, the optimal sensor displayed a low theoretical limit of detections (3.7 ppb) and high C2H5OH selectivity against interfering gases, including NO2, NH3, C3H6O, and CO. The observed ethanol response improvement and humidity-enhanced effect might be ascribed to the attributes of ohmic metal–semiconductor junctions formed at Au–ZnO interfaces and the capabilities of very fine sputtered Au nanoparticles to enhance oxygen chemisorption and suppress the formation of surface hydroxyl and hydronium species on ZnO nanowires. According to the results, Au-decorated ZnO nanowires fabricated by evaporation–condensation and sputtering could be potential candidates for use as practical C2H5OH sensors.
- 26 May 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (22) , 15407-15421
Comparative study on formic acid sensing properties of flame-made Zn2SnO4 nanoparticles and its parent metal oxides
Proposed CH2O2-sensing mechanism of the flame-made Zn2SnO4 based sensor correlating the resistance change behaviors under exposure to air and CH2O2 at 300 °C.
- 26 May 2023
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 25 (22) , 15407-15421
Comparative study on formic acid sensing properties of flame-made Zn2SnO4 nanoparticles and its parent metal oxides
Proposed CH2O2-sensing mechanism of the flame-made Zn2SnO4 based sensor correlating the resistance change behaviors under exposure to air and CH2O2 at 300 °C.
- 1 January 2022
- Published by Elsevier in Applied Surface Science
- Vol. 571
Selective H2S gas sensors based on ohmic hetero-interface of Au-functionalized WO3 nanowires
- 1 January 2022
- Published by Elsevier in Applied Surface Science
- Vol. 571
Selective H2S gas sensors based on ohmic hetero-interface of Au-functionalized WO3 nanowires