Qiang Ren
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Qiang Ren has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Xuandong Liu
State Key Laboratory of Electrical Insulation and Power Equipment, Xi’an Jiaotong University
2 shared publications Chengjun Liang
Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an 710049, China
1 shared publicationChengwei Huang
Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an 710049, China
1 shared publicationFeiyan Zhou
Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an 710049, China
1 shared publicationHao Sun
Key Laboratory of Electrical Insulation and Power Equipment, School of Electrical Engineering, Xi’an Jiaotong University, Xi’an 710049, China
1 shared publication- Hao Sun
State Key Laboratory of Electrical Insulation and Power Equipment, Xian Jiaotong University, Xian, China
1 shared publication
Latest Publications
- 16 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 50 (1) , 79-87
Discharge Characteristics of Fusion Plasma Jet Array and its Influencing Factors
The downstream uniformity of the atmospheric-pressure plasma jet (APPJ) array is a key technical problem with regard to large-scale applications nowadays. However, as the only array that can achieve large uniform plasma action area currently, the discharge characteristics and its influencing factors of the fusion plasma jet array have not been fully studied. In order to solve this problem, this article studies the discharge characteristics of the fusion APPJ array under different parameters, obtains its discharge mode conversion patterns and conversion characteristics, and thus the parameter conditions for achieving the diffused discharge mode. Finally, the influence of the thickness of the discharge dielectric tube and the inner diameter of the secondary tube on the discharge characteristics of the fusion APPJ array is studied. Results show that increasing the voltage amplitude and gas flow rate will both cause the discharge mode of the fusion plasma jet array to experience a conversion from starting discharge to diffused discharge mode to filament discharge mode. For the array with the thickness of the discharge dielectric tube of 1 mm and the inner diameter of the secondary tube of 20 mm, when the gas flow rate is between 1.6 and 2.8 L/min, the array can achieve the diffused discharge mode; reducing the thickness of the discharge dielectric tube will cause the gas flow rate under the diffused discharge mode to decrease; changing the inner diameter of the secondary tube hardly affects the parameter interval distribution of the discharge modes. The results of this article may provide a theoretical foundation for achieving large-scale plasma jet source.
- 16 December 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Plasma Science
- Vol. 50 (1) , 79-87
Discharge Characteristics of Fusion Plasma Jet Array and its Influencing Factors
The downstream uniformity of the atmospheric-pressure plasma jet (APPJ) array is a key technical problem with regard to large-scale applications nowadays. However, as the only array that can achieve large uniform plasma action area currently, the discharge characteristics and its influencing factors of the fusion plasma jet array have not been fully studied. In order to solve this problem, this article studies the discharge characteristics of the fusion APPJ array under different parameters, obtains its discharge mode conversion patterns and conversion characteristics, and thus the parameter conditions for achieving the diffused discharge mode. Finally, the influence of the thickness of the discharge dielectric tube and the inner diameter of the secondary tube on the discharge characteristics of the fusion APPJ array is studied. Results show that increasing the voltage amplitude and gas flow rate will both cause the discharge mode of the fusion plasma jet array to experience a conversion from starting discharge to diffused discharge mode to filament discharge mode. For the array with the thickness of the discharge dielectric tube of 1 mm and the inner diameter of the secondary tube of 20 mm, when the gas flow rate is between 1.6 and 2.8 L/min, the array can achieve the diffused discharge mode; reducing the thickness of the discharge dielectric tube will cause the gas flow rate under the diffused discharge mode to decrease; changing the inner diameter of the secondary tube hardly affects the parameter interval distribution of the discharge modes. The results of this article may provide a theoretical foundation for achieving large-scale plasma jet source.
- Open Access
- 18 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 92945-92953
XJTU: Typical Arrangements for Downstream Uniformity Assessment in Atmospheric-Pressure Plasma Jet Arrays
The downstream uniformity of the atmospheric-pressure plasma jet array is a key technical problem in regards to large-scale applications. This paper presents a 2-D array device of five jets arranged in four different shapes designed from the perspective of symmetry. Various schemes were tested to determine the effects of jet arrangement on the downstream uniformity of the array: the completely symmetrical array X, the completely asymmetrical array J, and semi-symmetrical arrays T and U. The interactions in the arrays were observed via optical imaging as well as electrical and spectroscopic characterizations. The results show that the downstream plume pattern markedly changes with the jet arrangement. Peripheral plumes suppress the internal plumes to varying extent under different jet arrangements. The emission intensity of the helium line at 706.5 nm was taken as a criterion to find that downstream uniformity under the arrangements J, T, U, and X gradually decreases as the jet arrangement grows increasingly symmetrical. The electric field simulation shows that different jet arrangements cause various degrees of inhomogeneous electric field distributions, which in turn affect the charge transferred into each plasma jet and the distributions of active particles resulting in downstream uniformity variations. The results presented here may provide a theoretical foundation for improving the downstream uniformity of the plasma jet arrays and achieving large-scale plasma jet sources.
- 18 May 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 92945-92953
Open AccessXJTU: Typical Arrangements for Downstream Uniformity Assessment in Atmospheric-Pressure Plasma Jet Arrays
The downstream uniformity of the atmospheric-pressure plasma jet array is a key technical problem in regards to large-scale applications. This paper presents a 2-D array device of five jets arranged in four different shapes designed from the perspective of symmetry. Various schemes were tested to determine the effects of jet arrangement on the downstream uniformity of the array: the completely symmetrical array X, the completely asymmetrical array J, and semi-symmetrical arrays T and U. The interactions in the arrays were observed via optical imaging as well as electrical and spectroscopic characterizations. The results show that the downstream plume pattern markedly changes with the jet arrangement. Peripheral plumes suppress the internal plumes to varying extent under different jet arrangements. The emission intensity of the helium line at 706.5 nm was taken as a criterion to find that downstream uniformity under the arrangements J, T, U, and X gradually decreases as the jet arrangement grows increasingly symmetrical. The electric field simulation shows that different jet arrangements cause various degrees of inhomogeneous electric field distributions, which in turn affect the charge transferred into each plasma jet and the distributions of active particles resulting in downstream uniformity variations. The results presented here may provide a theoretical foundation for improving the downstream uniformity of the plasma jet arrays and achieving large-scale plasma jet sources.