SZSiqi Zhan

Siqi Zhan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Siqi Zhan has a total of 5 co-authors. Here are the top co-authors by number of shared publications:

  • Haohao Zou

    Key Laboratory of Advanced Structural Materials, Ministry of Education, Changchun University of Technology, No. 2055, Yan’an Street, Changchun 130012, China

    1 shared publication
  • Weiwei Zhu

    Key Laboratory of Advanced Structural Materials, Ministry of Education and School of Materials Science and Engineering, Changchun University of Technology, Changchun, China

    1 shared publication
  • Xu Ran

    Changchun University of Technology

    1 shared publication
  • Yong Wang

    Key Laboratory of Advanced Structural Materials, Ministry of Education, Changchun University of Technology, Changchun 130012, China

    1 shared publication
  • Zhikang Hao

    Key Laboratory of Advanced Structural Materials, Ministry of Education, Changchun University of Technology, Changchun 130012, China

    1 shared publication

Latest Publications

  • Open Access

    Tribological Behavior of Copper–Graphite Composites Reinforced with Cu-Coated or Uncoated SiO2 Particles

    by Haohao Zou, Xu Ran, Weiwei Zhu, Yong Wang, Siqi Zhan, Zhikang Hao

    Copper–graphite composites reinforced with SiO2 particles were fabricated by powder metallurgy technique. Electroless copper plating was introduced to improve the interfacial bonding between SiO2 particles and copper matrix. The microstructure, density, and hardness of the composites were characterized. The tribological properties, such as friction coefficient and wear rate of the composites, were studied using a pin-on-ring tribometer. The results show that the hard SiO2 can restrict the severe plastic deformation and adhesion contact in the process of wear. At the same time, parts of SiO2 particles can be broken into fine particles during wear process, which is helpful for decreasing adhesion wear and abrasive wear. Therefore, the addition of SiO2 leads to increasing friction stability and friction coefficient, and decreasing wear rate. In addition, the electroless copper plating improves the interfacial bonding between SiO2 and copper matrix, which prevents separation of SiO2 from copper matrix and further increase tribological properties of the composites.