Long Tan
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Long Tan has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Du Liu
1 shared publicationHeping Wu
1 shared publicationJiliang Wang
1 shared publication- Jin Luo
Faculty of Engineering, China University of Geosciences (Wuhan), Wuhan 430074, China
1 shared publication - Joachim Rohn
GeoZentrum Nordbayern, Department Geographie und Geowissenschaften, Friedrich-Alexander University Erlangen-Nuremberg (FAU), 91054 Erlangen, Germany
1 shared publication - Peng Zhao
State Key Laboratory of Tropical Oceanography Laboratory of Ocean and Marginal Sea Geology South China Sea Institute of Oceanology, CAS Guangzhou China
1 shared publication
Latest Publications
- Open Access
- 3 March 2021
- Published by Copernicus GmbH
Stability analysis of the surrounding rock of cavern under extreme situation based on limited borehole data.
In the pre-feasibility study stage, only a small amount of borehole data can be obtained. Since the available geological information is insufficient, the engineering geological conditions of the project can only be preliminarily and approximately estimated during this stage. In this study, we attempt to seek a method to make a preliminary analysis and evaluation of the stability of the surrounding rock masses of an underground rock carven project, which makes full and optimum use of the limited borehole data to accomplish the assessment of the investigated site. The basic information on rock fractures is extracted from the borehole Television logging data and the fracture extension directions are also determined. Providing that the cracks detected in the borehole would extend to the cavern area, the cracks with appropriate direction, larger width and larger hydraulic conductivity can be selected. These selected cracks are considered in the numerical model established using ANSYS, and the stability of surrounding rock of cavern is analyzed under this situation. In the absence of large amount of borehole data, this method, which set up an extreme case, can be used to analyze possible failure of rock mass under extreme adverse conduction in advance. In general, the proposed method for stability analysis could contribute to the design and construction practice of a tunnel project constructed in fractured rock masses.
- 3 March 2021
- Published by Copernicus GmbH
Open AccessStability analysis of the surrounding rock of cavern under extreme situation based on limited borehole data.
In the pre-feasibility study stage, only a small amount of borehole data can be obtained. Since the available geological information is insufficient, the engineering geological conditions of the project can only be preliminarily and approximately estimated during this stage. In this study, we attempt to seek a method to make a preliminary analysis and evaluation of the stability of the surrounding rock masses of an underground rock carven project, which makes full and optimum use of the limited borehole data to accomplish the assessment of the investigated site. The basic information on rock fractures is extracted from the borehole Television logging data and the fracture extension directions are also determined. Providing that the cracks detected in the borehole would extend to the cavern area, the cracks with appropriate direction, larger width and larger hydraulic conductivity can be selected. These selected cracks are considered in the numerical model established using ANSYS, and the stability of surrounding rock of cavern is analyzed under this situation. In the absence of large amount of borehole data, this method, which set up an extreme case, can be used to analyze possible failure of rock mass under extreme adverse conduction in advance. In general, the proposed method for stability analysis could contribute to the design and construction practice of a tunnel project constructed in fractured rock masses.
- Open Access
- 1 January 2020
- Published by Wiley in Advances in Civil Engineering
- Vol. 2020 (1)
Effects of Saline Solutions on the Desiccation Cracking and Shrinkage Behavior of Gaomiaozi Bentonite
Bentonite, when used as buffer/backfill material in the deep disposal of high‐level radioactive waste (HLW), could undergo desiccation shrinkage or even cracking due to the heat released from HLW, impairing the efficiency of the barrier system. Furthermore, in‐service buffer materials are inevitably in contact with the groundwater, which sometimes contain high salt concentrations. The groundwater salinity may modify the properties of bentonite and hence affect the process of desiccation and its performance. To investigate this effect, in this study, a series of temperature‐controlled desiccation tests was conducted on compacted specimens of Gaomiaozi (GMZ) bentonite preliminarily saturated with two different saline solutions (NaCl and CaCl2) at the concentration varying from 0.5 to 2.0 mol/L. The experimental results indicated that, as the concentration of saline solution increases, the initial saturated water content of bentonite decreases, whereas the residual water content at the completion of the desiccation test increases. The water evaporation rate is reduced for the specimens saturated with a high‐concentration saline solution, and CaCl2 has a more significant influence on water evaporation than NaCl. The evolution of cracks on the sample surface during the desiccation process can be divided into four stages: crack growth, maintenance, closure, and stabilization; an increase in the salt concentration effectively inhibits crack development. It was shown that the infiltration of saline solutions alters the microstructure of bentonite by changing the arrangement of clay particles from a dispersed pattern to more aggregate state, which results in a decrease in shrinkage strain and shrinkage anisotropy.
- 1 January 2020
- Published by Wiley in Advances in Civil Engineering
- Vol. 2020 (1)
Open AccessEffects of Saline Solutions on the Desiccation Cracking and Shrinkage Behavior of Gaomiaozi Bentonite
Bentonite, when used as buffer/backfill material in the deep disposal of high‐level radioactive waste (HLW), could undergo desiccation shrinkage or even cracking due to the heat released from HLW, impairing the efficiency of the barrier system. Furthermore, in‐service buffer materials are inevitably in contact with the groundwater, which sometimes contain high salt concentrations. The groundwater salinity may modify the properties of bentonite and hence affect the process of desiccation and its performance. To investigate this effect, in this study, a series of temperature‐controlled desiccation tests was conducted on compacted specimens of Gaomiaozi (GMZ) bentonite preliminarily saturated with two different saline solutions (NaCl and CaCl2) at the concentration varying from 0.5 to 2.0 mol/L. The experimental results indicated that, as the concentration of saline solution increases, the initial saturated water content of bentonite decreases, whereas the residual water content at the completion of the desiccation test increases. The water evaporation rate is reduced for the specimens saturated with a high‐concentration saline solution, and CaCl2 has a more significant influence on water evaporation than NaCl. The evolution of cracks on the sample surface during the desiccation process can be divided into four stages: crack growth, maintenance, closure, and stabilization; an increase in the salt concentration effectively inhibits crack development. It was shown that the infiltration of saline solutions alters the microstructure of bentonite by changing the arrangement of clay particles from a dispersed pattern to more aggregate state, which results in a decrease in shrinkage strain and shrinkage anisotropy.
- Open Access
Investigation of Flow and Heat Transfer Characteristics in Fractured Granite
Hydraulic and heat transfer properties of artificially fractured rocks are the key issues for efficient exploitation of geothermal energy in fractured reservoirs and it has been studied by many previous researchers. However, the fluid temperature evolution along the flow path and rock temperature changes was rarely considered. This study investigated flow and heat transfer characteristics of two sets of fractured granite samples each with a single fissure. The samples were collected from a geothermal reservoir of Gonghe basin in Qinghai province in China. The results show that the larger area ratio, the higher hydraulic conductivity exhibited. Hydraulic conductivity of fractured rock masses is positively proportional to injection pressure, but inversely proportional with both confining pressure and temperature. In order to analyze heat transfer during the flow process, temperature distribution along the flow path in a fracture was monitored. The temperature of the fluid was determined to increase with distance from the flowing inlet. Increasing the temperature of the rock or decreasing the injection pressure will raise the temperature at the same location. Furthermore, in order to understand the heat transfer in rock mass, temperature distribution was observed by using an infrared thermal camera. Finally, the energy exchange efficiency during the flowing process was examined. The energy exchange rate increases continuously with the rock temperature, with an effective stress ratio of 1:2.
Open AccessInvestigation of Flow and Heat Transfer Characteristics in Fractured Granite
Hydraulic and heat transfer properties of artificially fractured rocks are the key issues for efficient exploitation of geothermal energy in fractured reservoirs and it has been studied by many previous researchers. However, the fluid temperature evolution along the flow path and rock temperature changes was rarely considered. This study investigated flow and heat transfer characteristics of two sets of fractured granite samples each with a single fissure. The samples were collected from a geothermal reservoir of Gonghe basin in Qinghai province in China. The results show that the larger area ratio, the higher hydraulic conductivity exhibited. Hydraulic conductivity of fractured rock masses is positively proportional to injection pressure, but inversely proportional with both confining pressure and temperature. In order to analyze heat transfer during the flow process, temperature distribution along the flow path in a fracture was monitored. The temperature of the fluid was determined to increase with distance from the flowing inlet. Increasing the temperature of the rock or decreasing the injection pressure will raise the temperature at the same location. Furthermore, in order to understand the heat transfer in rock mass, temperature distribution was observed by using an infrared thermal camera. Finally, the energy exchange efficiency during the flowing process was examined. The energy exchange rate increases continuously with the rock temperature, with an effective stress ratio of 1:2.