Ying Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Ying Liu has a total of 39 co-authors. Here are the top co-authors by number of shared publications:
- Hui You
School of Mechanical Engineering, Guangxi University, Nanning 530004, China
4 shared publications - Shaokun Ma
School of Civil Engineering and Architecture, Guangxi University, Nanning, China
4 shared publications - Cuimin Sun
School of Computer and Electronic Information Engineering, Guangxi University, Nanning 530004, China
3 shared publications - Wenhe He
School of Electrical Engineering, Guangxi University, Nanning, China
3 shared publications - Yaping Liu
School of Mechanical Engineering, Guangxi University, Nanning, China
3 shared publications - Zhen Huang
School of Civil Engineering and Architecture, Guangxi University, Nanning 530004, China
3 shared publications
Latest Publications
- 20 September 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (1) , 149-165
Effects of reconsolidation on cyclic deformation behaviours of a kaolin clay
- 20 September 2024
- Published by Springer Nature in Acta Geotechnica
- Vol. 20 (1) , 149-165
Effects of reconsolidation on cyclic deformation behaviours of a kaolin clay
- Open Access
- 7 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 73 (00189456) , 1-13
A Novel Overlapping ME Peaks Decomposition Algorithm Based on Iterative Derivative Sharpening
In Microchip electrophoresis (ME) signals, multiple sub-peaks low resolution overlapping peaks seriously interfere with the measurement of peak parameters. However, existing peak analysis methods either address the problem of two sub-peaks overlapping peaks or set peak parameters empirically. In this study, an automatic overlapping peaks decomposition algorithm based on signal smoothing, iterative sharpening, and peak fitting is proposed. First, the Savitzky-Golay (SG) filter is used for smoothing ME signals because it outperforms other smoothing methods in peak retention ability, smoothness, and preservation of the high-frequency information content of the signal. Second, an iterative peaks sharpening strategy is proposed based on the principle of the even-order derivative method. Finally, overlapping peak analysis methods based on swarm intelligence algorithms, gradient algorithms, and simplex algorithm, respectively, are proposed. For the swarm intelligence based fitting algorithms, the fitting errors of ME signals using the proposed peak sharpening strategy are reduced by 13.5%, 23.7%, and 40.0% on average, respectively.
- 7 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 73 (00189456) , 1-13
Open AccessA Novel Overlapping ME Peaks Decomposition Algorithm Based on Iterative Derivative Sharpening
In Microchip electrophoresis (ME) signals, multiple sub-peaks low resolution overlapping peaks seriously interfere with the measurement of peak parameters. However, existing peak analysis methods either address the problem of two sub-peaks overlapping peaks or set peak parameters empirically. In this study, an automatic overlapping peaks decomposition algorithm based on signal smoothing, iterative sharpening, and peak fitting is proposed. First, the Savitzky-Golay (SG) filter is used for smoothing ME signals because it outperforms other smoothing methods in peak retention ability, smoothness, and preservation of the high-frequency information content of the signal. Second, an iterative peaks sharpening strategy is proposed based on the principle of the even-order derivative method. Finally, overlapping peak analysis methods based on swarm intelligence algorithms, gradient algorithms, and simplex algorithm, respectively, are proposed. For the swarm intelligence based fitting algorithms, the fitting errors of ME signals using the proposed peak sharpening strategy are reduced by 13.5%, 23.7%, and 40.0% on average, respectively.
- 22 February 2024
- Published by Springer Nature in Sādhanā
- Vol. 49 (1) , 1-13
Research on the protection effect and parameter optimization design of isolation pile-diaphragm wall combination support structure
- 22 February 2024
- Published by Springer Nature in Sādhanā
- Vol. 49 (1) , 1-13
Research on the protection effect and parameter optimization design of isolation pile-diaphragm wall combination support structure
- 28 December 2023
- Published by Springer Nature in Frontiers of Earth Science
- Vol. 18 (1) , 219-226
The important role of Turbidity Maximum Zone in sedimentary dynamic of estuarine mangrove swamp
- 28 December 2023
- Published by Springer Nature in Frontiers of Earth Science
- Vol. 18 (1) , 219-226
The important role of Turbidity Maximum Zone in sedimentary dynamic of estuarine mangrove swamp
- 26 May 2023
- Published by Springer Nature in Natural Hazards
- Vol. 118 (1) , 495-524
Transparent soil model test and numerical study on the effect of adjacent spring on the stability of tunnel face in composite strata
- 26 May 2023
- Published by Springer Nature in Natural Hazards
- Vol. 118 (1) , 495-524
Transparent soil model test and numerical study on the effect of adjacent spring on the stability of tunnel face in composite strata
- Open Access
- 22 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 72 (00189456) , 1-9
A Novel Unresolved Peaks Analysis Algorithm for ME Signal Detection Based on Improved SMA
Microchip electrophoresis (ME) is an ion detection system with low cost and portability, which is suitable for online analysis of environmental samples. However, the unresolved peaks in the detection signal of complex samples seriously affect the measurement accuracy of sample concentration. In this paper, an efficient unresolved peaks analysis algorithm is proposed, which is based on the Sigmoidal membership function, Lévy flight, and Slime Mould Algorithm (SLSMA). First, the hyperbolic tangent function in the original Slime Mould Algorithm (SMA) is replaced by the Sigmoidal membership function to enhance the global optimization capability. Second, we use the Lévy flight sequences to further enhance the convergence speed of the SMA algorithm. Then, the performance of SLSMA is tested using synthetic peaks with different resolutions and noise levels. Finally, ME peaks are used to further validate the application of the proposed algorithm. The results show that the proposed algorithm has higher computational efficiency and can be used for the analysis of ME peaks.
- 22 May 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 72 (00189456) , 1-9
Open AccessA Novel Unresolved Peaks Analysis Algorithm for ME Signal Detection Based on Improved SMA
Microchip electrophoresis (ME) is an ion detection system with low cost and portability, which is suitable for online analysis of environmental samples. However, the unresolved peaks in the detection signal of complex samples seriously affect the measurement accuracy of sample concentration. In this paper, an efficient unresolved peaks analysis algorithm is proposed, which is based on the Sigmoidal membership function, Lévy flight, and Slime Mould Algorithm (SLSMA). First, the hyperbolic tangent function in the original Slime Mould Algorithm (SMA) is replaced by the Sigmoidal membership function to enhance the global optimization capability. Second, we use the Lévy flight sequences to further enhance the convergence speed of the SMA algorithm. Then, the performance of SLSMA is tested using synthetic peaks with different resolutions and noise levels. Finally, ME peaks are used to further validate the application of the proposed algorithm. The results show that the proposed algorithm has higher computational efficiency and can be used for the analysis of ME peaks.
- Open Access
A Novel Symmetrical Peak Fitting Method Based on Improved WOA Algorithm for the Analysis of Microchip Electrophoresis Signals
The problem of overlapping peaks has been a challenge in microchip electrophoresis (ME) signal analysis. However, traditional peak fitting algorithms have difficulty analyzing overlapping peaks due to the high dependence on the starting point. In this study, we propose a symmetrical peak fitting method named the tent-mapped whale optimization algorithm and Levenberg–Marquardt (TWOALM), which combines a whale optimization algorithm (WOA) improved by one of the most commonly used chaotic maps, the tent map and the Levenberg–Marquardt (LM) algorithm. Specifically, we first derive the fitted model for the overlapping peaks, showing that it is separable nonlinear least squares, significantly reducing the number of parameters to be optimized. Second, we integrate the tent map into the WOA, which improves the convergence speed of the peak fitting algorithm. Finally, we propose an efficient peak-fitting algorithm that combines the improved WOA and LM. The advantage of the proposed algorithm is that it is significantly faster than WOA and significantly more accurate than the LM algorithm. The results of fitting the synthetic peaks and ME signals showed that the combination of the chaotic map-based WOA algorithm and the LM algorithm can significantly improve the peak fitting performance and provide an effective solution for the analysis of overlapping peaks.
Open AccessA Novel Symmetrical Peak Fitting Method Based on Improved WOA Algorithm for the Analysis of Microchip Electrophoresis Signals
The problem of overlapping peaks has been a challenge in microchip electrophoresis (ME) signal analysis. However, traditional peak fitting algorithms have difficulty analyzing overlapping peaks due to the high dependence on the starting point. In this study, we propose a symmetrical peak fitting method named the tent-mapped whale optimization algorithm and Levenberg–Marquardt (TWOALM), which combines a whale optimization algorithm (WOA) improved by one of the most commonly used chaotic maps, the tent map and the Levenberg–Marquardt (LM) algorithm. Specifically, we first derive the fitted model for the overlapping peaks, showing that it is separable nonlinear least squares, significantly reducing the number of parameters to be optimized. Second, we integrate the tent map into the WOA, which improves the convergence speed of the peak fitting algorithm. Finally, we propose an efficient peak-fitting algorithm that combines the improved WOA and LM. The advantage of the proposed algorithm is that it is significantly faster than WOA and significantly more accurate than the LM algorithm. The results of fitting the synthetic peaks and ME signals showed that the combination of the chaotic map-based WOA algorithm and the LM algorithm can significantly improve the peak fitting performance and provide an effective solution for the analysis of overlapping peaks.
- Open Access
- 3 October 2022
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2022, 1-13
The Effects of Isolation Pile on the Ground Deformation due to a Deep Pit Excavation
Pit excavation could inevitably introduce ground movement and threaten the safety of nearby existing high buildings, metro tunnels, or roads. To reduce ground movement and protect those existing structures against large deformation, isolation pile is widely used in engineering practices. A series of physical model tests was carried out to investigate the effects of isolation piles on the ground deformation induced by excavating a pit. Digital image correlation (DIC) analysis was employed to study the ground deformation and slip surface under different pile lengths and locations relative to the retaining wall. The results indicate that the ground deformation and the shear band in the ground are less affected by the existence of a pile if the isolation pile’s end is above or slightly extends beyond the slip surface. In contrast, if the isolation pile extends beyond the slip surface sufficiently, even though the ground movement behind the pile is reduced, the settlement of the soil between the pile and retaining wall would be enlarged. Meanwhile, the horizontal deformation shows an arching shape along the depths and has a noticeable value in the middle section of subsoil. The ground deformation behind the isolation pile shows dependence on the pile’s horizontal displacement, regardless of the pile’s length and location. An empirical model is proposed to evaluate the efficiency of isolation piles on settlement protection. The comparison of the prediction and the results from tests and FEA shows a reasonable agreement.
- 3 October 2022
- Published by Wiley in Advances in Materials Science and Engineering
- Vol. 2022, 1-13
Open AccessThe Effects of Isolation Pile on the Ground Deformation due to a Deep Pit Excavation
Pit excavation could inevitably introduce ground movement and threaten the safety of nearby existing high buildings, metro tunnels, or roads. To reduce ground movement and protect those existing structures against large deformation, isolation pile is widely used in engineering practices. A series of physical model tests was carried out to investigate the effects of isolation piles on the ground deformation induced by excavating a pit. Digital image correlation (DIC) analysis was employed to study the ground deformation and slip surface under different pile lengths and locations relative to the retaining wall. The results indicate that the ground deformation and the shear band in the ground are less affected by the existence of a pile if the isolation pile’s end is above or slightly extends beyond the slip surface. In contrast, if the isolation pile extends beyond the slip surface sufficiently, even though the ground movement behind the pile is reduced, the settlement of the soil between the pile and retaining wall would be enlarged. Meanwhile, the horizontal deformation shows an arching shape along the depths and has a noticeable value in the middle section of subsoil. The ground deformation behind the isolation pile shows dependence on the pile’s horizontal displacement, regardless of the pile’s length and location. An empirical model is proposed to evaluate the efficiency of isolation piles on settlement protection. The comparison of the prediction and the results from tests and FEA shows a reasonable agreement.
- Open Access
- 31 August 2022
- Published by MDPI AG in Micromachines
- Vol. 13 (9) , 1439
Effects of Side Profile on Acoustic Streaming by Oscillating Microstructures in Channel
In microchannels, microstructure-induced acoustic streaming can be achieved at low frequencies, providing simple platforms for biomedicine and microfluidic manipulation. Nowadays, microstructures are generally fabricated by photolithography or soft photolithography. Existing studies mainly focused on the projection plane, while ignoring the side profile including microstructure’s sidewall and channel’s upper wall. Based on the perturbation theory, the article focuses on the effect of microstructure’s sidewall errors caused by machining and the viscous dissipation of upper wall on the streaming. We discovered that the side profile parameters, particularly the gap (gap g between the top of the structure and the upper wall of the channel), have a significant impact on the maximum velocity, mode, and effective area of the streaming.To broaden the applicability, we investigated boundary layer thickness parameters including frequency and viscosity. Under different thickness parameters, the effects of side profile parameters on the streaming are similar. But the maximum streaming velocity is proportional to the frequency squared and inversely proportional to the viscosity. Besides, the ratio factor of the maximum streaming velocity to the vibration velocity is affected by the side profile parameter gap g and sidewall profile angle .- 31 August 2022
- Published by MDPI AG in Micromachines
- Vol. 13 (9) , 1439
Open AccessEffects of Side Profile on Acoustic Streaming by Oscillating Microstructures in Channel
In microchannels, microstructure-induced acoustic streaming can be achieved at low frequencies, providing simple platforms for biomedicine and microfluidic manipulation. Nowadays, microstructures are generally fabricated by photolithography or soft photolithography. Existing studies mainly focused on the projection plane, while ignoring the side profile including microstructure’s sidewall and channel’s upper wall. Based on the perturbation theory, the article focuses on the effect of microstructure’s sidewall errors caused by machining and the viscous dissipation of upper wall on the streaming. We discovered that the side profile parameters, particularly the gap (gap g between the top of the structure and the upper wall of the channel), have a significant impact on the maximum velocity, mode, and effective area of the streaming.To broaden the applicability, we investigated boundary layer thickness parameters including frequency and viscosity. Under different thickness parameters, the effects of side profile parameters on the streaming are similar. But the maximum streaming velocity is proportional to the frequency squared and inversely proportional to the viscosity. Besides, the ratio factor of the maximum streaming velocity to the vibration velocity is affected by the side profile parameter gap g and sidewall profile angle .