SYSaad Alami Younssi

Saad Alami Younssi

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Saad Alami Younssi has a total of 22 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Removal of Congo red dye by ultrafiltration composite membrane of PpPD/PVA on flat pozzolan/micronized phosphate ceramic support

    by Dounia Beqqour, Wiame Taanaoui, Mohamed Ouammou, Saad Alami Younssi, Jamal Bennazha, Jason A. Cody, M. El Rhazi


  • Open Access

    Development of composite ultrafiltration membrane made of PmPD/PVA layer deposited on ceramic pozzolan/micronized phosphate support and its application for Congo red dye removal

    by D. Beqqour, G. Derouich, W. Taanaoui, A. Essate, M. Ouammou, S. Alami Younssi, J. Bennazha, J.A. Cody, M. El Rhazi


  • Open Access

    Pollution of Water Sources from Agricultural and Industrial Effluents: Special Attention to NO3ˉ, Cr(VI), and Cu(II)

    by Majda Breida, Saad Alami Younssi, Mohamed Ouammou, Mohamed Bouhria, Mahmoud Hafsi

    One of the most important challenges facing humanity today is to conserve and sustain water resources (either surface water or groundwater). This challenge became more pronounced with the increase of urban, agricultural, and industrial activities that discharge a considerable amount of wastewater. Therefore, the preservation of water sources from pollutants is a major concern, shared by all, public, industrial, scientific, researchers, and decision-makers. This chapter analyzes in more detail the pollution and pollutants caused by agricultural and industrial activities. Particular attention is given to pollution via nitrogen and heavy metals (NO3−, Cr(VI), and Cu(II)) in either international or national level. The effect of these pollutants on human health and environment, their standards/regulations, and the different current methods used for their detection and treatment are all discussed in the chapter.


  • Open Access

    Alumina Membranes for Desalination and Water Treatment

    by Saad Alami Younssi, Majda Breida, Brahim Achiou

    In recent years, there has been a growing interest in utilizing inorganic membranes, particularly alumina (Al2O3) ceramic membranes (CMs), and to address a variety of separation problems in miscellaneous industry. Al2O3 membranes are commercially predominant in CMs market. Al2O3 material is generally used either as membrane support and/or as membrane layer due to advantages provided by this material and its derivatives such as availability in tonnage quantities, chemical inertness, good hardness, and thermal stability of the porous texture during elaboration steps. In this chapter, we comprehensibly look at the recent studies related to desalination and water treatment by ultrafiltration (UF), nanofiltration (NF) Al2O3 membrane, and highlight the separation properties of the membrane in specific environmental pollution. The influences of membrane operating conditions and water quality on the rejection of pollutant by Al2O3 membrane are reported through a series of bench-level experiments.


  • Open Access

    Elaboration and characterization of flat membrane supports from Moroccan clays. Application for the treatment of wastewater

    by H. Elomari, B. Achiou, M. Ouammou, A. Albizane, J. Bennazha, S. Alami Younssi, I. Elamrani

    In this work, ceramic supports for microfiltration have been made and thoroughly characterized from three Moroccan clays: clay of Meknes (CM), fine clay of Fès (FCF), and granular clay of Fès (GCF). X-ray fluorescence (XRF), X-ray diffraction, and thermogravimetric analysis (TGA) techniques were used to characterize the raw material. Flat disks of 3.6 cm of diameter and 1.5 mm in thickness were prepared from the natural clays: the powder was crushed and sieved to 63 μm. The obtained powder was then pressed without organic additives and without water addition to elaborate a porous structure. Finally, a thermal treatment was carried out in a programmable oven at different final temperatures; the best firing temperature of the support is 950°C. The resulting supports have been characterized by scanning electron microscopy, water porosity, corrosion resistance and mechanical strength. The porosity of the supports CM, FCF, and GCF was, respectively, 28.1, 30.8 and 40%, and the average pore diameter was 1.8 μm for the CM support, 1.50 μm for FCF support and 2.84 μm for GCF support. Elaborated flat supports have been used to treat colored solutions to verify the suitability of such filters in the preclarification step in wastewater treatment for Moroccan industry. Results showed a good retention of turbidity and conductivity for the three elaborated supports.


  • Open Access

    New ceramic membranes from natural Moroccan phosphate for microfiltration application

    by I. Barrouk, S. Alami Younssi, A. Kabbabi, M. Persin, A. Albizane, S. Tahiri

    This paper is devoted to preparation of low-cost microfiltration (MF) membranes using lixiviated phosphate powder crushed at 50 μm. The filtering layer was coated on phosphate tubular support with 10 μm pore diameter and 43% porosity. The preparation of this ceramic layer was performed by the slip-casting method. A deflocculated slip was obtained by mixing mineral powder, polyvinyl alcohol, and water with dispersant. After drying at room temperature for 24 h, the MF layer was heated to 800°C for consolidation. Scanning electron microscopy observation showed homogeneous layers without cracks with an average pore diameter of 0.35 μm for the active layer, the thickness is approximately 10 μm. Water permeability obtained is about 700 L/h m2 bar. The membranes have been tested to treat wastewater of phosphate industry, to clarify synthetic solutions of lime and aluminum hydroxide, and to remove bacteriological pollution present in water wells. The experiments carried out show that elaborated MF membrane is very efficient for the reduction of turbidity, total phosphorus, and number of bacterial germs with almost the same performances than that obtained with a commercial α-alumina membrane.