HYHiroyuki Yamada

Hiroyuki Yamada

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Hiroyuki Yamada has a total of 2 co-authors. Here are the top co-authors by number of shared publications:

  • Hiroo Taura

    Department of Mechanical Engineering, Nagaoka University of Technology, Kamitomioka-machi 1603-1, Nagaoka-shi 940-2188, Niigata, Japan

    3 shared publications
  • Satoru Kaneko

    Department of Mechanical Engineering, Nagaoka University of Technology, Kamitomioka-machi 1603-1, Nagaoka-shi, Niigata 940-2188, Japan

    3 shared publications

Latest Publications

  • Numerical and Experimental Analyses of the Dynamic Characteristics of Journal Bearings With Square Dimples

    by Hiroyuki Yamada, Hiroo Taura, Satoru Kaneko

    Numerous previous numerical studies have investigated the effect of surface texturing upon the static characteristics of journal bearings, including their load-carrying capacity and friction torque. In general, the dynamic characteristics of journal bearings are also important, since they are essential factors in predicting the vibration behavior of actual rotors supported by journal bearings. However, the effects of surface texture upon these dynamic characteristics have not been investigated through either numerical or experimental analysis. Thus, in the present study, such analyses were conducted to investigate the dynamic characteristics of textured journal bearings, such as their dynamic coefficients of oil film and the stability-threshold shaft speed supported by the bearings. Numerical analysis was done using a model that included inertial effects and energy loss; this model agreed well with experimental results concerning static characteristics from our previous study. Dynamic testing based on a sinusoidal-excitation method was also performed using textured journal bearings with uniform square dimples to verify the numerical results, which agreed qualitatively with those of experiment, confirming the validity of the numerical analysis. These results suggest that under the same operating conditions, the main effect of texturing upon the dynamic coefficients is to yield the cross-coupled stiffness coefficients with lower absolute values than the conventional ones with a smooth surface. The linear stability-threshold shaft speed of the rotor supported by the textured journal bearings became higher than that of a smooth bearing, mainly due to the reduction of cross-coupled stiffness coefficients. This tendency became more pronounced for high Reynolds number operating conditions and textured bearings with a large number of dimples.


  • Static Characteristics of Journal Bearings With Square Dimples

    by Hiroyuki Yamada, Hiroo Taura, Satoru Kaneko

    Surface texturing is a technique for improving frictional and hydrodynamic performances of journal bearings because microtextures can serve as reservoirs for oil or traps for debris and may also generate hydrodynamic pressure. Over the past two decades, many researchers have experimentally demonstrated that texturing of various tribological elements can reduce friction force and wear, contributing to improvement of lubrication performance. Some numerical studies have examined the hydrodynamic lubrication conditions and reported that surface texturing affects the static characteristics of journal bearings, such as their load carrying capacity and friction torque. However, the validity of these numerical models has not been confirmed because of a lack of experimental studies. This study proposes a numerical model that includes both inertial effects and energy loss at the edges of dimples on the surface of a journal bearing in order to investigate the bearing's static characteristics. Experimental verification of journal bearings is also conducted with a uniform square-dimple pattern on their full-bearing surface. The results obtained by the model agree well with those of experiment, confirming the model's validity. These results show that under the same operating conditions, textured bearings yield a higher eccentricity ratio and lower attitude angle than the conventional ones with a smooth surface. This tendency becomes more marked for high Reynolds number operating conditions and for textured bearings with a large number of dimples.