Yerli Cervantes
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yerli Cervantes has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Debaki Sarkar
Department of Technology Leadership & Innovation, Purdue University, West Lafayette, IN 47907, USA
1 shared publication - Mandeep Singh
Mechanical Engineering, California State University, Fresno, CA 93740, USA
1 shared publication - Sanjeev Kumar
Mechanical Engineering, California State University, Fresno, CA 93740, USA
1 shared publication - Sankha Banerjee
California State University
1 shared publication - Saquib Ahmed
Department of Mechanical Engineering Technology, SUNY Buffalo State University, Buffalo, USA; Center for Integrated Studies in Nanoscience and Nanotechnology, SUNY Buffalo State University, Buffalo, USA
1 shared publication - Shaestagir Chowdhury
Department of Mechanical and Materials Engineering, Portland State University, Portland, OR 97201, USA
1 shared publication
Latest Publications
- Open Access
- 4 July 2020
- Published by MDPI AG in Journal of Composites Science
- Vol. 4 (3) , 88
Fabrication and Characterization of Flexible Three-Phase ZnO-Graphene-Epoxy Electro-Active Thin-Film Nanocomposites: Towards Applications in Wearable Biomedical Devices
Perovskite oxides have been used as sensors, actuators, transducers, for sound generation and detection, and also in optical instruments and microscopes. Perovskite halides are currently considered as optoelectronic devices such as solar cells, photodetectors, and radiation detection, but there are major issues with stability, interfacial recombination, and electron/hole mobility. The following work looks into the fabrication of non-toxic ZnO-based lead-free alternatives to perovskite oxides for use as secondary sensors or electron transport layers along with perovskite halides for application in stacked biomedical wearable devices. Three-phase, lead-free, Zinc Oxide-Graphene-Epoxy electroactive nanocomposite thin films were fabricated. The volume fraction of the Graphene phase was held constant at 10%, while the volume fraction of the ZnO phase was varied from 10–70%. The dielectric constant, capacitance, impedance, resistance, and conductance of the samples were measured using an impedance analyzer, and the results were compared as a function of volume fraction of ZnO to understand the electron transport performance of these thin films. The impedance and dielectric spectra of the nanocomposites were recorded over a frequency range of 20 Hz to 10 MHz. The microstructural properties and cross-section of the thin films were analyzed using a Scanning Electron Microscope. The high sensitivity and electron transport properties of the composite could be potentially utilized in biomedical devices at low- and high-frequency ranges.
- 4 July 2020
- Published by MDPI AG in Journal of Composites Science
- Vol. 4 (3) , 88
Open AccessFabrication and Characterization of Flexible Three-Phase ZnO-Graphene-Epoxy Electro-Active Thin-Film Nanocomposites: Towards Applications in Wearable Biomedical Devices
Perovskite oxides have been used as sensors, actuators, transducers, for sound generation and detection, and also in optical instruments and microscopes. Perovskite halides are currently considered as optoelectronic devices such as solar cells, photodetectors, and radiation detection, but there are major issues with stability, interfacial recombination, and electron/hole mobility. The following work looks into the fabrication of non-toxic ZnO-based lead-free alternatives to perovskite oxides for use as secondary sensors or electron transport layers along with perovskite halides for application in stacked biomedical wearable devices. Three-phase, lead-free, Zinc Oxide-Graphene-Epoxy electroactive nanocomposite thin films were fabricated. The volume fraction of the Graphene phase was held constant at 10%, while the volume fraction of the ZnO phase was varied from 10–70%. The dielectric constant, capacitance, impedance, resistance, and conductance of the samples were measured using an impedance analyzer, and the results were compared as a function of volume fraction of ZnO to understand the electron transport performance of these thin films. The impedance and dielectric spectra of the nanocomposites were recorded over a frequency range of 20 Hz to 10 MHz. The microstructural properties and cross-section of the thin films were analyzed using a Scanning Electron Microscope. The high sensitivity and electron transport properties of the composite could be potentially utilized in biomedical devices at low- and high-frequency ranges.