Christopher S. Dandeneau
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Christopher S. Dandeneau has a total of 26 co-authors. Here are the top co-authors by number of shared publications:
- Brenda L. Garcia-Diaz
Savannah River National Laboratory
4 shared publications - Dale Hitchcock
Savannah River National Laboratory (SRNL), Aiken, SC (United States)
2 shared publications - Kyle S. Brinkman
Department of Materials Science and Engineering, Clemson University, Clemson, South Carolina 29634, USA
2 shared publications - Luke C. Olson
Savannah River National Laboratory
2 shared publications Rahul Rajeev
2 shared publicationsAbhaya Kumar Mishra
1 shared publication
Latest Publications
- Open Access
- 2 October 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1082
Comparative stability of Ga and Ta-doped LLZO in molten Li-Pb: phase evolution and degradation behavior
- 2 October 2026
- Published by Elsevier in Journal of Alloys and Compounds
- Vol. 1082
Open AccessComparative stability of Ga and Ta-doped LLZO in molten Li-Pb: phase evolution and degradation behavior
- 8 July 2026
- Published by Taylor & Francis in Fusion Science and Technology
- p. 1-12
Enhancing Tritium Extraction from Molten Salts Using Metal Permeators
- 8 July 2026
- Published by Taylor & Francis in Fusion Science and Technology
- p. 1-12
Enhancing Tritium Extraction from Molten Salts Using Metal Permeators
- Open Access
- 18 June 2026
- Published by Elsevier in SSRN Electronic Journal
Comparative Stability of Ga and Ta-Doped LLZO in Molten Li-Pb: Phase Evolution and Degradation Behavior
Li7La3Zr2O12 (LLZO) is a promising solid electrolyte for high-temperature liquid-metal electrochemical systems, including molten Li-Pb environments for nuclear electrochemical lithium tritide extraction in fusion breeding blankets, and liquid-metal batteries. In this work, Ga- and Ta-doped LLZO were compared after exposure in molten Li-Pb at 450 ℃. X-ray diffraction showed that Ta-doped LLZO retained the cubic garnet phase after exposure, whereas Ga-doped LLZO underwent cubic-to-tetragonal transformation. Ga-doped LLZO also showed bulk blackening, grain cracking, and Pb penetration along grain boundaries, while Ta-doped LLZO formed only a thin reacted surface layer (~2 μm) and the bulk structure was preserved. Electron paramagnetic resonance on Li-Pb exposed Ga-doped LLZO revealed a signal near g=2.00, indicating reduction-induced paramagnetic electronic defects. Reheating in air restored the original color and partially recovered the cubic phase, indicating a reduction-driven and partially reversible degradation process. Thermodynamic analysis further showed that Ta-doped LLZO (-843 kJ/mol) has more negative enthalpy of formation from oxides than Ga-doped LLZO (-401 kJ/mol), supporting greater bulk stability of Ta-substituted LLZO. These results demonstrate that dopant chemistry strongly controls LLZO stability in molten Li-Pb, with Ta-doped LLZO showing significantly greater resistance to bulk degradation than Ga-doped LLZO.
- 18 June 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessComparative Stability of Ga and Ta-Doped LLZO in Molten Li-Pb: Phase Evolution and Degradation Behavior
Li7La3Zr2O12 (LLZO) is a promising solid electrolyte for high-temperature liquid-metal electrochemical systems, including molten Li-Pb environments for nuclear electrochemical lithium tritide extraction in fusion breeding blankets, and liquid-metal batteries. In this work, Ga- and Ta-doped LLZO were compared after exposure in molten Li-Pb at 450 ℃. X-ray diffraction showed that Ta-doped LLZO retained the cubic garnet phase after exposure, whereas Ga-doped LLZO underwent cubic-to-tetragonal transformation. Ga-doped LLZO also showed bulk blackening, grain cracking, and Pb penetration along grain boundaries, while Ta-doped LLZO formed only a thin reacted surface layer (~2 μm) and the bulk structure was preserved. Electron paramagnetic resonance on Li-Pb exposed Ga-doped LLZO revealed a signal near g=2.00, indicating reduction-induced paramagnetic electronic defects. Reheating in air restored the original color and partially recovered the cubic phase, indicating a reduction-driven and partially reversible degradation process. Thermodynamic analysis further showed that Ta-doped LLZO (-843 kJ/mol) has more negative enthalpy of formation from oxides than Ga-doped LLZO (-401 kJ/mol), supporting greater bulk stability of Ta-substituted LLZO. These results demonstrate that dopant chemistry strongly controls LLZO stability in molten Li-Pb, with Ta-doped LLZO showing significantly greater resistance to bulk degradation than Ga-doped LLZO.
- Open Access
- 18 February 2026
- Published by Elsevier in SSRN Electronic Journal
Sacrificial Zirconium Coatings for Corrosion Mitigation in Molten Chloride Salts
Zirconium films on Haynes 230 (H230) were examined as a corrosion mitigation strategy for potential upset conditions (e.g., loss of atmospheric control) in a molten chloride salt storage tank. In addition to Ni-based alloys such as H230, the devised method should also be applicable to Fe-based alloys. Commercial KCl-MgCl2-NaCl (45.8-47.8-6.4 mol%) salt was first purified by a two-stage thermal/chemical treatment to eliminate corrosive impurities. H230 specimens were then coated in Zr (thickness ~113 µm) using the purified salt as a transfer medium; evidence of Ni-Zr interdiffusion was observed in the as-deposited films. Zr-coated H230 (Zr-H230) coupons were ultimately immersed in the molten salt separately under air or Ar ambient at 800 °C for 100 h to assess the ability of the Zr films to protect the underlying H230. The Zr layer thickness decreased after immersion testing in both environments, but the air-exposed Zr coating was far more heavily attacked and mostly converted to ZrO2. Importantly though, the underlying H230 in the air‑exposed sample remained intact, and the Zr coating in the Ar-exposed specimen mostly stayed in the surface region where it was initially deposited. Such findings demonstrate that Zr can be applied to an alloy surface and remain in place to provide a protective function in the event of atmospheric upsets.
- 18 February 2026
- Published by Elsevier in SSRN Electronic Journal
Open AccessSacrificial Zirconium Coatings for Corrosion Mitigation in Molten Chloride Salts
Zirconium films on Haynes 230 (H230) were examined as a corrosion mitigation strategy for potential upset conditions (e.g., loss of atmospheric control) in a molten chloride salt storage tank. In addition to Ni-based alloys such as H230, the devised method should also be applicable to Fe-based alloys. Commercial KCl-MgCl2-NaCl (45.8-47.8-6.4 mol%) salt was first purified by a two-stage thermal/chemical treatment to eliminate corrosive impurities. H230 specimens were then coated in Zr (thickness ~113 µm) using the purified salt as a transfer medium; evidence of Ni-Zr interdiffusion was observed in the as-deposited films. Zr-coated H230 (Zr-H230) coupons were ultimately immersed in the molten salt separately under air or Ar ambient at 800 °C for 100 h to assess the ability of the Zr films to protect the underlying H230. The Zr layer thickness decreased after immersion testing in both environments, but the air-exposed Zr coating was far more heavily attacked and mostly converted to ZrO2. Importantly though, the underlying H230 in the air‑exposed sample remained intact, and the Zr coating in the Ar-exposed specimen mostly stayed in the surface region where it was initially deposited. Such findings demonstrate that Zr can be applied to an alloy surface and remain in place to provide a protective function in the event of atmospheric upsets.
- 4 April 2023
- Published by Springer Nature in Journal of Materials Science
- Vol. 58 (14) , 6174-6184
Rapid fabrication of Ga-doped Li7La3Zr2O12 powder via microwave-assisted solution combustion synthesis
- 4 April 2023
- Published by Springer Nature in Journal of Materials Science
- Vol. 58 (14) , 6174-6184
Rapid fabrication of Ga-doped Li7La3Zr2O12 powder via microwave-assisted solution combustion synthesis
- 7 December 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 107 (23) , 232901
Polaronic conduction and Anderson localization in reduced strontium barium niobate
Electron transport mechanisms in reduced Sr0.5Ba0.5Nb2O6 (SBN50) are investigated from ∼100 to 955 K through an analysis of the electrical conductivity (σ) and the Seebeck coefficient (S) with respect to temperature (T). Notably, experimental evidence is presented that supports a scenario of Anderson localization below 600 K and carrier excitation across a mobility edge at higher temperature. As a relaxor ferroelectric, stoichiometric SBN has intrinsic disorder associated with both the distribution of Sr/Ba vacancies and the formation of polarized nanoregions. The removal of oxygen through reduction generates conduction electrons in SBN. At the lowest temperatures measured (100–155 K), the electrical conductivity exhibits a temperature dependence characteristic of variable range hopping, followed by a transition to small polaron hopping at intermediate temperatures (250–545 K). In both the variable range and small polaron hopping regimes, a semiconductor-like temperature dependence of the electrical conductivity (dσ/dT > 0) was observed. However, above 615 K, dσ/dT decreases dramatically and eventually becomes metal-like (dσ/dT < 0). Concomitantly, the Seebeck coefficient exhibits a linear dependence on lnT from 615 to 955 K with the same slope (∼104 V/K) for both polycrystalline SBN50 and single crystalline SBN61 (both reduced), indicating a similar, constant density of states near the Fermi level for both compositions. The application of Seebeck coefficient theory to this inherently disordered material reveals that the excitation of carriers across a mobility edge is likely responsible for the change in dσ/dT at high temperature. Such findings may have a significant impact in the field of conductive ferroelectrics.- 7 December 2015
- Published by AIP Publishing in Applied Physics Letters
- Vol. 107 (23) , 232901
Polaronic conduction and Anderson localization in reduced strontium barium niobate
Electron transport mechanisms in reduced Sr0.5Ba0.5Nb2O6 (SBN50) are investigated from ∼100 to 955 K through an analysis of the electrical conductivity (σ) and the Seebeck coefficient (S) with respect to temperature (T). Notably, experimental evidence is presented that supports a scenario of Anderson localization below 600 K and carrier excitation across a mobility edge at higher temperature. As a relaxor ferroelectric, stoichiometric SBN has intrinsic disorder associated with both the distribution of Sr/Ba vacancies and the formation of polarized nanoregions. The removal of oxygen through reduction generates conduction electrons in SBN. At the lowest temperatures measured (100–155 K), the electrical conductivity exhibits a temperature dependence characteristic of variable range hopping, followed by a transition to small polaron hopping at intermediate temperatures (250–545 K). In both the variable range and small polaron hopping regimes, a semiconductor-like temperature dependence of the electrical conductivity (dσ/dT > 0) was observed. However, above 615 K, dσ/dT decreases dramatically and eventually becomes metal-like (dσ/dT < 0). Concomitantly, the Seebeck coefficient exhibits a linear dependence on lnT from 615 to 955 K with the same slope (∼104 V/K) for both polycrystalline SBN50 and single crystalline SBN61 (both reduced), indicating a similar, constant density of states near the Fermi level for both compositions. The application of Seebeck coefficient theory to this inherently disordered material reveals that the excitation of carriers across a mobility edge is likely responsible for the change in dσ/dT at high temperature. Such findings may have a significant impact in the field of conductive ferroelectrics.