DUDaisuke Ueda

Daisuke Ueda

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Daisuke Ueda has a total of 17 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Power Receiving Unit for High-Power Resonant Wireless Power Transfer

    by Ching-Yao Liu, Hsien-Chung Tang, Yueh-Tsung Shieh, Chih-Chiang Wu, Wei-Hua Chieng, Edward-Yi Chang, Daisuke Ueda

    A new power receiving unit (PRU) is proposed in this paper for resonant wireless power transfer (WPT), which is characterized by the capability of attracting high power from the power transmitting unit (PTU). The resonant WPT is designed for delivering the electrical power to the PRU attached on an electrical vehicle (EV) chassis 50 cm away from a PTU installed on the ground. The proposed PRU uses only the passive elements such as inductors, diodes, and capacitors, which need no initial power from the EV. It is then applicable for charging a battery to several hundred volts for even a first-time charging battery. For a resonant WPT at a switching frequency of 4 MHz, the proposed PRU behaves as a negative impedance converter (NIC) itself in the subharmonics of 4 MHz. The NIC effect plus the subharmonic oscillation causes an instability current charging the battery connected to the PRU. In this paper, we simulated the PRU and performed the experiment. The experiment demonstrated a battery charging of 150 W from 50 cm away using three D-mode GaN HEMT transistors via the instability current ramp. The power transfer efficiency (PTE) improved as the power delivered to the load (PDL) increased. The peak PTE was 65% in the present findings. The simulation analysis showed that the circuit allowed itself be used to much higher power transfer when it is implemented with more GaN HEMT transistors connected in parallel. The theoretical derivation of the PRU circuit is also used to support both the experimental and simulation results.


  • Open Access

    Power Receiving Unit for High Power Resonant Wireless Power Transfer

    by Ching-Yao Liu, Hsien-Chung Tang, Yueh-Tsung Shieh, Chih-Chiang Wu, Wei-Hua Chieng, Edward-Yi Chang, Daisuke Ueda

    A new power receiving unit (PRU) is proposed in this paper for the resonant wireless power transfer (WPT), which is characterized by the capability of attracting high power from the power transmitting unit (PTU). The resonant WPT is designed for delivering the electrical power to the PRU attached on an electrical vehicle (EV) chassis 50cm away from a PTU installed on the ground. The proposed PRU uses only the passive elements such as inductors, diodes and the capacitors, which needs no initial power from the EV. It is then applicable for charging a battery to several hundred volts for even a first-time charging battery. At a switching frequency of the resonant WPT in the experiment being 4MHz, the proposed PRU behaves itself as a negative impedance converter (NIC) in the subharmonics of 4MHz. The NIC effect plus the subharmonic oscillation causes an instability current charging the battery connected to the PRU. In this paper, we simulated the PRU and performed the experiment. The experiment demonstrates a battery charging of 150W from 50cm away using three D-mode GaN HEMT transistors via the instability current ramp. The power transfer efficiency (PTE) improved as the power delivered to load (PDL) goes higher. The best power transfer efficiency (PTE) is 65% in the present findings. The simulation analysis shows that the circuit allows itself be used to much higher power transfer when it is implemented with more GaN HEMT transistors connected in parallel. The theoretical derivation of the PRU circuit is also used to support both the experimental and simulation results.


  • Open Access

    A Novel GaN:C Millimeter-Wave HEMT with AlGaN Electron-Blocking Layer

    by You-Chen Weng, Yueh-Chin Lin, Heng-Tung Hsu, Min-Lu Kao, Hsuan-Yao Huang, Daisuke Ueda, Minh-Thien-Huu Ha, Chih-Yi Yang, Jer-Shen Maa, Edward-Yi Chang, et al.

    An AlGaN/GaN/Si high electron mobility transistor (HEMT) using a GaN:C buffer with a 2 nm AlGaN electron-blocking layer (EBL) is investigated for the first time for millimeter-wave applications. Compared with the double heterostructure field effect transistor (DHFET), the AlGaN/GaN HEMT with the GaN:C/EBL buffer has a lower vertical leakage, higher thermal stability, and better RF performance. In addition, AlGaN EBL can prevent carbon-related traps from GaN:C and improve electron confinement in 2DEG during high-frequency operation. Finally, a Pout of 31.2 dBm with PAE of 21.7% were measured at 28 GHz at 28 V. These results demonstrated the great potential of HEMTs using GaN:C with AlGaN EBL epitaxy technology for millimeter-wave applications.


  • GaN Power Devices for Microwave/Switching Applications

    by Daisuke Ueda

    Provided with both high blocking voltage and high current handling capability, GaN-based device has been expected to be a viable alternative to GaAs, Silicon, and even to SiC ones in power electronics (Ueda et al., 2005). However, there still remains technological tasks to overcome in order to put them into practical use. Those are summarized as following three points; i.e., "Normally-off', "Collapse-free", and "Heat-release". In this paper, those points will be addressed by introducing new transistor named GIT (gate injection transistor) (Uemoto et al., 2006) with relevant technologies.