NFNoah Felvey

Noah Felvey

*This is an algorithmically generated author record based on publicly available information.

Noah Felvey has a total of 15 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Reduction of Cofed Carbon Dioxide Modifies the Local Coordination Environment of Zeolite-Supported, Atomically Dispersed Chromium to Promote Ethane Dehydrogenation

    by Wenqi Zhou, Noah Felvey, Jiawei Guo, Adam S. Hoffman, Simon R. Bare, Ambarish R. Kulkarni, Ron C. Runnebaum, Coleman X. Kronawitter

    The reduction of CO2 is known to promote increased alkene yields from alkane dehydrogenations when the reactions are cocatalyzed. The mechanism of this promotion is not understood in the context of catalyst active-site environments because CO2 is amphoteric, and even general aspects of the chemistry, including the significance of competing side reactions, differ significantly across catalysts. Atomically dispersed chromium cations stabilized in highly siliceous MFI zeolite are shown here to enable the study of the role of parallel CO2 reduction during ethylene-selective ethane dehydrogenation. Based on infrared spectroscopy and X-ray absorption spectroscopy data interpreted through calculations using density functional theory (DFT), the synthesized catalyst contains atomically dispersed Cr cations stabilized by silanol nests in micropores. Reactor studies show that cofeeding CO2 increases stable ethylene-selective ethane dehydrogenation rates over a wide range of partial pressures. Operando X-ray absorption near-edge structure (XANES) and extended X-ray absorption fine-structure (EXAFS) spectra indicate that during reaction at 650 °C the Cr cations maintain a nominal 2+ charge and a total Cr-O coordination number of approximately 2. However, CO2 reduction induces a change, correlated with the CO2 partial pressure, in the population of two distinct Cr-O scattering paths. This indicates that the promotional effect of parallel CO2 reduction can be attributed to a subtle change in Cr-O bond lengths in the local coordination environment of the active site. These insights are made possible by simultaneously fitting multiple EXAFS spectra recorded in different reaction conditions; this novel procedure is expected to be generally applicable for interpreting operando catalysis EXAFS data.


  • Interconversion of Atomically Dispersed Platinum Cations and Platinum Clusters in Zeolite ZSM-5 and Formation of Platinum gem-Dicarbonyls

    by Noah Felvey, Jiawei Guo, Rachita Rana, Le Xu, Simon R. Bare, Bruce C. Gates, Alexander Katz, Ambarish R. Kulkarni, Ron C. Runnebaum, Coleman X. Kronawitter

    Catalysts composed of platinum dispersed on zeolite supports are widely applied in industry, and coking and sintering of platinum during operation under reactive conditions require their oxidative regeneration, with the platinum cycling between clusters and cations. The intermediate platinum species have remained only incompletely understood. Here, we report an experimental and theoretical investigation of the structure, bonding, and local environment of cationic platinum species in zeolite ZSM-5, which are key intermediates in this cycling. Upon exposure of platinum clusters to O2 at 700 °C, oxidative fragmentation occurs, and Pt2+ ions are stabilized at six-membered rings in the zeolite that contain paired aluminum sites. When exposed to CO under mild conditions, these Pt2+ ions form highly uniform platinum gem-dicarbonyls, which can be converted in H2 to Ptδ+ monocarbonyls. This conversion, which weakens the platinum-zeolite bonding, is a first step toward platinum migration and aggregation into clusters. X-ray absorption and infrared spectra provide evidence of the reductive and oxidative transformations in various gas environments. The chemistry is general, as shown by the observation of platinum gem-dicarbonyls in several commercially used zeolites (ZSM-5, Beta, mordenite, and Y).


  • Room temperature and atmospheric pressure aqueous partial oxidation of ethane to oxygenates over AuPd catalysts

    by Yu Lei Wang, Sadi Gurses, Noah Felvey, Coleman X. Kronawitter

    New modes of chemical manufacturing based on small-scale, distributed facilities have been proposed to supplement many existing production operations in the chemical industry, including the synthesis of value-added products from light alkanes. Motivated by this prospect, herein the aqueous partial oxidation of ethane over unsupported AuPd nanoparticle catalysts is investigated, with emphasis on outcomes for reactions occurring at 21 °C and 1 bar ethane. When H2O2 is used as an oxidant, the system generates numerous C2 oxygenates, including ethyl hydroperoxide/ethanol, acetaldehyde, and acetic acid. Ethyl hydroperoxide is found to be the primary product resulting from the direct oxidation of ethane: it is produced with 100% selectivity in batch reactions with short durations and with low initial H2O2 concentrations. At longer times or in more oxidizing conditions, deeper product oxidations expectedly occur. In batch experiments, the maximum observed yield of oxygenates is 7707 μmol gAuPd −1 h−1. Product distributions differ when H2O2 is replaced by H2 and O2 in the headspace. Additionally, to simulate a scenario wherein H2O2 is produced on-site and to study ethane oxidation in steady, low H2O2 concentrations over 50 h, a semi-batch configuration facilitating continuous injection of dilute H2O2 was implemented. These efforts showed that H2O2 can serve as an oxygenate-selective oxidant of ethane when its concentration is kept low during reaction. These and other experimental results, as well as initial computational results using density functional theory, suggest that paths forward for aqueous ethane conversion exist, and systems should be engineered to emphasize product stabilization.


  • Ethane dehydrogenation over Cr/ZSM-5: characterization of active sites through probe molecule adsorption FTIR

    by Noah W. Felvey, Michael J. Meloni, Coleman X. Kronawitter, Ron C. Runnebaum

    Dispersed Cr species supported on zeolite ZSM-5 were investigated in the context of catalytic ethane dehydrogenation. Probe molecule FTIR and XANES were used to characterize the nature of Cr sites across a range of Cr loadings and in the presence of various extra-framework cations on ZSM-5. These characteristics were related to catalytic performance in ethane dehydrogenation toward the goal of developing design principles for Cr/zeolite catalysts for improved alkane conversions. Diffuse reflectance infrared Fourier transform spectroscopy (FTIR-DRIFTS) with nitric oxide (NO) and carbon monoxide (CO) probe molecules was determined to be an effective tool for distinguishing various types of Cr species present after exposure to reducing conditions typical of alkane dehydrogenation catalysis. It was found that 0.5 wt% Cr/H-ZSM-5 is a stable, ethylene-selective catalyst whose Cr sites are reduced at reaction temperature (650 °C) in the presence of either ethane or N2. Zeolite framework Al sites were determined to be critical for the stabilization of active Cr sites during ethane dehydrogenation – in the absence of available Al sites, Cr sites quickly deactivated. It was also found that greater Cr/Al molar ratios yielded a greater abundance of electron-rich Cr2+ species after reduction. This trend correlated with increased ethane dehydrogenation activity and decreased stability in time-on-stream studies. Both high activity and enhanced stability were observed for Cr/Ca-ZSM-5. Taken together, these results indicate that ethane dehydrogenation over Cr/ZSM-5 is optimized when Cr preferentially situates adjacent to isolated framework Al sites.