KBKrishan Bhakta

Krishan Bhakta

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Krishan Bhakta has a total of 17 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Electromyography-Informed Estimates of Joint Contact Forces Within the Lower Back and Knee Joints During a Diverse Set of Industry-Relevant Manual Lifting Tasks

    by Felicia R. Davenport, Jennifer K. Leestma, Adriana Staten, Krishan Bhakta, Joshua Fernandez, Anirban Mazumdar, Aaron J. Young, Gregory S. Sawicki

    Repetitive manual labor tasks involving twisting, bending, and lifting commonly lead to lower back and knee injuries in the workplace. To identify tasks with high injury risk, we recruited N = 9 participants to perform industry-relevant, 2-handed lifts with a 11-kg weight. These included symmetrical/asymmetrical, ascending/descending lifts that varied in start-to-end heights (knee-to-waist and waist-to-shoulder). We used a data-driven musculoskeletal model that combined force and motion data with a muscle activation-informed solver (OpenSim, CEINMS) to estimate 3-dimensional internal joint contact forces (JCFs) in the lower back (L5/S1) and knee. Symmetrical lifting resulted in larger peak JCFs than asymmetrical lifting in both the L5/S1 (+20.2% normal [P < .01], +20.3% shear [P = .001], +20.6% total [P < .01]) and the knee (+39.2% shear [P = .001]), and there were no differences in peak JCFs between ascending versus descending motions. Below-the-waist lifting generated significantly greater JCFs in the L5/S1 and knee than above-the-waist lifts (P < .01). We found a positive correlation between knee and L5/S1 peak total JCFs (R2 = .60, P < .01) across the task space, suggesting motor coordination that favors sharing of load distribution across the trunk and legs during lifting.


  • Open Access

    Continuous-Context, User-Independent, Real-Time Intent Recognition for Powered Lower-Limb Prostheses

    by Krishan Bhakta, Jairo Maldonado-Contreras, Jonathan Camargo, Sixu Zhou, William Compton, Kinsey R. Herrin, Aaron J. Young

    Community ambulation is essential for maintaining a healthy lifestyle, but it poses significant challenges for individuals with limb loss due to complex task demands. In wearable robotics, particularly powered prostheses, there is a critical need to accurately estimate environmental context, such as walking speed and slope, to offer intuitive and seamless assistance during varied ambulation tasks. We developed a user-independent and multicontext, intent recognition system that was deployed in real-time on an Open Source Leg (OSL). We recruited 11 individuals with transfemoral amputation, with seven participants used for real-time validation. Our findings revealed two main conclusions: (1) the user-independent (IND) performance across speed and slope was not statistically different from user-dependent (DEP) models in real-time and did not degrade compared to its offline counterparts, and (2) IND walking speed estimates showed ∼0.09 m/s mean absolute error (MAE) and slope estimates showed ∼0.95 deg MAE across multicontext scenarios. Additionally, we provide an open-source dataset to facilitate further research in accurately estimating speed and slope using an IND approach in real-world walking tasks on a powered prosthesis.


  • Comparing Metabolic Cost and Muscle Activation for Knee and Back Exoskeletons in Lifting

    by Christoph Nuesslein, Krishan Bhakta, Joshua Fernandez, Felicia Davenport, Jennifer Leestma, Raymond Kim, Dawit Lee, Anirban Mazumdar, Gregory Sawicki, Aaron Young

    Performing heavy manual lifting jobs can be extremely strenuous, often resulting in high rates of injury at overloaded joints. Lower-body exoskeletons have potential to mitigate this fatigue and injury through targeted joint assistance. A variety of current wearable devices aim to provide this kind of support, but their effects on both directly and indirectly targeted joints have not been fully investigated. In this study, a powered bilateral knee exoskeleton (research device), and passive back exosuit (HeroWear Apex) were compared across 10 individuals through a battery of manual lifting tasks. Metabolic, electromyographic, and subject-reported outcome measure data were used to determine which exoskeleton provided the best assistance for each task type. It was found that the knee exoskeleton significantly reduced metabolic cost by 9.6% compared to the no-exoskeleton baseline (p<.05). Both the knee and back exoskeletons reduced activation in up to 6 of the muscles measured (out of 16). Importantly, each device primarily reduced muscle activation around the joint it targeted, not around adjacent joints. These findings suggest that exoskeletons that target the knee or lower back joint during lifting can provide significant assistance in reducing exertion.


  • Biomechanical Evaluation of Stair Ambulation Using Impedance Control on an Active Prosthesis

    by Jonathan Camargo, Krishan Bhakta, Kinsey Herrin, Aaron Young

    Active prostheses can provide net positive work to individuals with amputation, offering more versatility across locomotion tasks than passive prostheses. However, the effect of powered joints on bilateral biomechanics has not been widely explored for ambulation modes different than level ground and treadmill walking. In this study, we present the bilateral biomechanics of stair ascent and descent with a powered knee-ankle prosthesis compared to the biomechanical profiles of able-bodied subjects at different configurations of stair height between 102 mm and 178 mm. In addition, we include reference profiles from users with passive prostheses for the nominal stair height of 152 mm to place our findings in relation to the typical solution for individuals with transfemoral amputation (TFA). We report the biomechanical profiles of kinematics, kinetics, and power, together with temporal and waveform symmetry and distribution of mechanical energy across the joints. We found that an active prosthesis provides a substantial contribution to mechanical power during stair ascent and power absorption during stair descent and gait patterns like able-bodied subjects. The active prosthesis enables step-over-step gait in stair ascent. This translates into a lower mechanical energy requirement on the intact side, with a 57% reduction of energy at the knee and 26% at the hip with respect to the passive prosthesis. For stair descent, we found a 28% reduction in the negative work done by the intact ankle. These results reflect the benefit of active prostheses, allowing the users to complete tasks more efficiently than passive legs. However, in comparison to able-bodied biomechanics, the results still differ from the ideal patterns. We discuss the limitations that explain this difference and suggest future directions for the design of impedance controllers by taking inspiration from the biological modulation of the knee moment as a function of the stair height.


  • Evaluation of Continuous Walking Speed Determination Algorithms and Embedded Sensors for a Powered Knee & Ankle Prosthesis

    by Krishan Bhakta, Jonathan Camargo, William Compton, Kinsey Herrin, Aaron Young

    Dynamically altering the parameters for assistance in a lower limb prosthesis is a challenge that depends directly on the ability to estimate gait parameters. Machine learning algorithms present an opportunity to develop methods for continuously determining walking speed in different conditions. Current state-of-the-art solutions involve using wearable sensors such as IMUs to estimate these parameters. These methods require an entire gait cycle to update the walking speed; this leads to delays when responding to changing speeds and ultimately renders these methods ineffective for adaptation into real-time prosthesis control. In this study, we developed subject dependent and independent machine learning models for rapidly determining walking speed and evaluated on data collected from 6 individuals with unilateral transfemoral amputation walking on our robotic knee/ankle prosthesis. We evaluated the performance of these models across a variety of static walking speeds and dynamic speed trials. Our findings suggest that using machine learning models offers excellent accuracy for both subject dependent and subject independent algorithms (DEP RMSE: 0.014 ± 0.001 m/s, IND RMSE: 0.070 ± 0.007 m/s, (p <; 0.05), with the advantage of real-time continuous determination at 50 Hz, which allows for good performance when rapidly changing walking speed. We also determine the most effective sensors to use for improving model performance. Our study provides valuable information for determining walking speed more reliably across different users and is robust to dynamic changes experienced in gait.


  • Machine Learning Model Comparisons of User Independent & Dependent Intent Recognition Systems for Powered Prostheses

    by Krishan Bhakta, Jonathan Camargo, Luke Donovan, Kinsey Herrin, Aaron Young

    Developing intelligent prosthetic controllers to recognize user intent across users is a challenge. Machine learning algorithms present an opportunity to develop methods for predicting user's locomotion mode. Currently, linear discriminant analysis (LDA) offers the standard solution in the state-of-the-art for subject dependent models and has been used in the development of subject independent applications. However, the performance of subject independent models differ radically from their dependent counterpart. Furthermore, most of the studies limit the evaluation to a fixed terrain with individual stair height and ramp inclination. In this study, we investigated the use of the XGBoost algorithm for developing a subject independent model across 8 individuals with transfemoral amputation. We evaluated the performance of XGBoost across different stair heights and inclination angles and found that it generalizes well across preset conditions. Our findings suggest that XGBoost offers a potential benefit for both subject independent and subject dependent algorithms outperforming LDA and NN (DEP SS Error: 2.93% $\pm$ 0.49%, DEP TS Error: 7.03% $\pm$ 0.74%, IND SS Error: 10.12% $\pm$ 3.16%, and IND TS Error: 15.78% $\pm$ 2.39%)(p < 0.05). We were also able to show that with the inclusion of extra sensors the model performance could continually be improved in both user dependent and independent models (p < 0.05). Our study provides valuable information for future intent recognition systems to make them more reliable across different users and common community ambulation modes.