Jeffrey W. Bullard
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jeffrey W. Bullard has a total of 75 co-authors. Here are the top co-authors by number of shared publications:
- Pan Feng
School of Materials Science and Engineering, Southeast University, Nanjing 211189, China
5 shared publications - Gaurav Sant
University of California, Los Angeles
4 shared publications - Tandré Oey
Laboratory for the Chemistry of Construction Materials (LC2) Department of Civil and Environmental Engineering University of California Los Angeles California
4 shared publications Edward J. Garboczi
National Institute of Standards and Technology, Gaithersburg, MD 20899, United States
3 shared publications- Edward J. Garboczi
National Institute of Standards and Technology
3 shared publications - Zachary Grasley
Director of Center for Infrastructure Renewal (CIR), Texas A&M Engineering, Bryan, TX 77807, USA
3 shared publications
Latest Publications
- Open Access
- 27 July 2025
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2679 (10) , 1003-1016
Examining the Effects of Biochar Characteristics on Early-Age Hydration and Fresh Properties of Cement Paste
Biochar is produced by pyrolysis of various wastes and is considered a promising construction material aimed to replace or supplement ordinary cement or supplementary cementitious materials owing to its low-carbon, environment-friendly characteristics, and waste management benefits. However, the large variance in properties among different biochars is a challenge for understanding and controlling its physical–chemical–mechanical roles in cementitious mixtures. In addition, the unique water retention characteristics of biochar and its influence on the overall performance of cement composites are not fully understood. This study examines the effects of biochar characteristics (e.g., chemical composition and saturation state) on cement paste properties, particularly focusing on early-age hydration and fresh properties. We performed a set of laboratory measurements that includes (a) the characterization of fundamental properties of biochars, (b) the hydration behavior of cement pastes infused with biochar, and (c) the compressive strength of cement paste samples cured up to 7 days. The results show that incorporating biochar affects early-age behavior and fresh properties of cement paste such as setting time, workability, hydration kinetics, and rheological behavior. In addition, those effects depend on biochar’s physical, chemical, and morphological characteristics. The physical characteristics of biochar associated with surface area, particle size, and water absorption-retention capacity tend to control the overall early-age performance of cement paste. Incorporating 5 wt% biochar can improve the compressive strength of cement paste. While the Si-rich biochar (rice husk biochar) exhibited noticeable pozzolanic reactivity, its effect on early-age hydration was not significant at up to 5 wt% examined in this study.
- 27 July 2025
- Published by SAGE Publications in Transportation Research Record: Journal of the Transportation Research Board
- Vol. 2679 (10) , 1003-1016
Open AccessExamining the Effects of Biochar Characteristics on Early-Age Hydration and Fresh Properties of Cement Paste
Biochar is produced by pyrolysis of various wastes and is considered a promising construction material aimed to replace or supplement ordinary cement or supplementary cementitious materials owing to its low-carbon, environment-friendly characteristics, and waste management benefits. However, the large variance in properties among different biochars is a challenge for understanding and controlling its physical–chemical–mechanical roles in cementitious mixtures. In addition, the unique water retention characteristics of biochar and its influence on the overall performance of cement composites are not fully understood. This study examines the effects of biochar characteristics (e.g., chemical composition and saturation state) on cement paste properties, particularly focusing on early-age hydration and fresh properties. We performed a set of laboratory measurements that includes (a) the characterization of fundamental properties of biochars, (b) the hydration behavior of cement pastes infused with biochar, and (c) the compressive strength of cement paste samples cured up to 7 days. The results show that incorporating biochar affects early-age behavior and fresh properties of cement paste such as setting time, workability, hydration kinetics, and rheological behavior. In addition, those effects depend on biochar’s physical, chemical, and morphological characteristics. The physical characteristics of biochar associated with surface area, particle size, and water absorption-retention capacity tend to control the overall early-age performance of cement paste. Incorporating 5 wt% biochar can improve the compressive strength of cement paste. While the Si-rich biochar (rice husk biochar) exhibited noticeable pozzolanic reactivity, its effect on early-age hydration was not significant at up to 5 wt% examined in this study.
- 22 April 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 515
Calcium hydroxide dissolution rates: Dependence on temperature and saturation
- 22 April 2025
- Published by Elsevier in Chemical Engineering Journal
- Vol. 515
Calcium hydroxide dissolution rates: Dependence on temperature and saturation
- 26 February 2025
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 45 (10)
Fabrication of intricate lunar regolith monoliths via freeze casting
- 26 February 2025
- Published by Elsevier in Journal of the European Ceramic Society
- Vol. 45 (10)
Fabrication of intricate lunar regolith monoliths via freeze casting
- 25 February 2025
- Published by Elsevier in Acta Astronautica
- Vol. 231, 153-174
Sintering of Lunar regolith: A review
- 25 February 2025
- Published by Elsevier in Acta Astronautica
- Vol. 231, 153-174
Sintering of Lunar regolith: A review
- 1 July 2024
- Published by Elsevier in Cement and Concrete Research
- Vol. 183
Dissolution kinetics of densified and undensified silica fume in a KOH solution at pH 13 and 23 °C
- 1 July 2024
- Published by Elsevier in Cement and Concrete Research
- Vol. 183
Dissolution kinetics of densified and undensified silica fume in a KOH solution at pH 13 and 23 °C
- 10 March 2024
- Published by Elsevier in Applied Materials Today
- Vol. 37
Sintering kinetics and microstructure development of synthetic lunar highlands and mare regolith
- 10 March 2024
- Published by Elsevier in Applied Materials Today
- Vol. 37
Sintering kinetics and microstructure development of synthetic lunar highlands and mare regolith
- Retraction
- 1 October 2021
- Published by Elsevier in Construction and Building Materials
- Vol. 304, 124704
Retraction notice to “Experimental investigation and comparative machine-learning prediction of strength behavior of optimized recycled rubber concrete” [JCBM 256 (2020) 119478]
- 1 October 2021
- Published by Elsevier in Construction and Building Materials
- Vol. 304, 124704
RetractionRetraction notice to “Experimental investigation and comparative machine-learning prediction of strength behavior of optimized recycled rubber concrete” [JCBM 256 (2020) 119478]
- 1 February 2021
- Published by Elsevier in Chemical Engineering Journal
- Vol. 406
How do specific surface area and particle size distribution change when granular media dissolve?
- 1 February 2021
- Published by Elsevier in Chemical Engineering Journal
- Vol. 406
How do specific surface area and particle size distribution change when granular media dissolve?
- 11 July 2020
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (11) , 6198-6207
Topological controls on aluminosilicate glass dissolution: Complexities induced in hyperalkaline aqueous environments
Fly ash, an aluminosilicate composite consisting of disordered (major) and crystalline (minor) compounds, is a low‐carbon alternative that can partially replace ordinary portland cement (OPC) in the binder fraction of concrete. Therefore, understanding the reactivity of fly ash in the hyperalkaline conditions prevalent in concrete is critical to predicting concrete's performance; including setting and strength gain. Herein, temporal measurements of the solution composition (using inductively coupled plasma‐optical emission spectrometry: ICP‐OES) are used to assess the aqueous dissolution rate of monophasic synthetic aluminosilicate glasses analogous to those present in technical fly ashes, under hyperalkaline conditions (10 ≤ pH ≤ 13) across a range of temperatures (25°C ≤ T≤45°C). The dissolution rate is shown to depend on the average number of topological constraints per atom within the glass network (n c , unitless), but this dependence weakens with increasing pH (>10). This is postulated to be on account of: (a) time‐dependent changes in the glass’ surface structure, that is, the number of topological constraints; and/or (b) a change in the dissolution mechanism (eg from network hydrolysis to transport control). The results indicate that the topological description of glass dissolution is most rigorously valid only at very short reaction times (ie at high undersaturations), especially under conditions of hyperalkalinity. These findings provide an improved basis to understand the underlying factors that affect the initial and ongoing reactivity of aluminosilicate glasses such as fly ash in changing chemical environments, for example, when such materials are utilized in cementitious composites.
- 11 July 2020
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 103 (11) , 6198-6207
Topological controls on aluminosilicate glass dissolution: Complexities induced in hyperalkaline aqueous environments
Fly ash, an aluminosilicate composite consisting of disordered (major) and crystalline (minor) compounds, is a low‐carbon alternative that can partially replace ordinary portland cement (OPC) in the binder fraction of concrete. Therefore, understanding the reactivity of fly ash in the hyperalkaline conditions prevalent in concrete is critical to predicting concrete's performance; including setting and strength gain. Herein, temporal measurements of the solution composition (using inductively coupled plasma‐optical emission spectrometry: ICP‐OES) are used to assess the aqueous dissolution rate of monophasic synthetic aluminosilicate glasses analogous to those present in technical fly ashes, under hyperalkaline conditions (10 ≤ pH ≤ 13) across a range of temperatures (25°C ≤ T≤45°C). The dissolution rate is shown to depend on the average number of topological constraints per atom within the glass network (n c , unitless), but this dependence weakens with increasing pH (>10). This is postulated to be on account of: (a) time‐dependent changes in the glass’ surface structure, that is, the number of topological constraints; and/or (b) a change in the dissolution mechanism (eg from network hydrolysis to transport control). The results indicate that the topological description of glass dissolution is most rigorously valid only at very short reaction times (ie at high undersaturations), especially under conditions of hyperalkalinity. These findings provide an improved basis to understand the underlying factors that affect the initial and ongoing reactivity of aluminosilicate glasses such as fly ash in changing chemical environments, for example, when such materials are utilized in cementitious composites.
- 1 May 2020
- Published by Elsevier in Chemical Geology
- Vol. 541
Hydrodynamic factors influencing mineral dissolution rates
- 1 May 2020
- Published by Elsevier in Chemical Geology
- Vol. 541
Hydrodynamic factors influencing mineral dissolution rates