Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Ashish Bisht has a total of 121 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Trench-Isolated LGAD Sensors for Time-Resolved STXM

    by Shuqi Li, Anna Bergamaschi, Ashish Bisht, Maurizio Boscardin, Martin Brückner, Maria Carulla, Roberto Dinapoli, Simon Ebner, Simone Emiliani, Khalil Ferjaoui, et al.

  • Open Access

    Development of a double-sided LGAD prototype from single-sided sensors: design, characterization, and proof of principle

    by Jerzy Pietraszko, Maurizio Boscardin, Ashish Bisht, Thomas Bergauer, Alfons Dehé, Henrik Flörsheimer, Jochen Frühauf, Tetyana Galatyuk, Harald Handerkas, Henning Heggen, et al.

    This work presents the development and experimental validation of a novel thin (active layer thickness of 85 μm) double-sided strip Low-Gain Avalanche Detector (LGAD) prototype. We demonstrate a post-fabrication segmentation process where a standard single-sided LGAD sensor is micromachined to enable dual-sided signal extraction. Characterization using a dedicated front-end electronics system confirms strong spatial and temporal correlations between the junction and ohmic sides. The results validate that this architecture preserves the excellent timing performance of LGADs while providing a scalable solution for high-precision tracking in material-sensitive applications. By applying this procedure in conjunction with additional sensor thinning, a total sensor thickness below 50 μm can be achieved. To our knowledge, this represents the first implementation of a thin double-sided LGAD.

  • Open Access

    LGAD technology for heavy ion detection and radiation damage diagnostics in diamond

    by Jerzy Pietraszko, Ashish Bisht, Thomas Bergauer, Henrik Floersheimer, Jochen Frühauf, Tetyana Galatyuk, Henning Heggen, Albert Hirtl, Matthias Kausel, Mladen Kis, et al.

    We present the application of LGAD technology for time-of-flight measurements of heavy ions and for precise diagnostics of radiation damage in diamond sensors. The polycrystalline CVD (pcCVD) diamond sensor used in this work was irradiated with heavy ion beams at GSI, Darmstadt, Germany during several experimental campaigns and subsequently investigated at MedAustron, Wiener Neustadt, Austria. To mitigate radiation-induced performance degradation, we propose a dedicated amplification system originally developed for LGAD sensors, which significantly extends the operational lifetime of diamond detectors. For precise sensor diagnostics, we employed strip LGAD sensors — commonly used for minimum ionizing particle (MIP) detection — and demonstrated their excellent performance for heavy ion (He/C) detection, achieving timing resolutions below 40 ps.


  • Open Access

    Development and characterization of large area LGADs for space applications

    by L. Cavazzini, A. Bisht, M. Boscardin, M. Centis Vignali, F. Ficorella, M. Fernandez Garcia, O. Hammad Alì, M. Moll, G. Paternoster, M. Wiehe

    Low Gain Avalanche Diodes (LGADs) are silicon detectors that use the impact ionization process to achieve gain values of about O(10) and timing resolution of O(30 ps) to detect Minimum Ionizing Particles. In High Energy Physics, the state-of-the-art LGADs foreseen for timing layers feature an active thickness of 50 µm and a channel size in the order of O(1 mm^2). Space-based experiments could benefit from a Time-of-Flight system composed by these sensors to distinguish between primary and secondary charged particles hits in the tracker. Scaling up the technology to match the typical channel area of the micro-strip sensors used in spaceborne experiments deteriorates the timing capabilities of the LGADs due, in first approximation, to the increased capacitance. In this study, pad sensors with thickness 50, 100, and 150 µm are investigated, featuring different gain layer profiles, designed to address variation in capacitance. Various layouts are also compared to see their impact on the time resolution. Characterization of leakage current and capacitance as a function of the bias voltage, along with Transient Current Technique, and radioactive source measurements are used to evaluate the performances of these devices. By evaluating gain, noise, and jitter, this work demonstrates the feasibility of designing 1 cm^2 LGADs with a jitter as low as 80 ps. Additionally, the study examines signal propagation and uniformity, as the channel size significantly influence there characteristics and their relevance to timing resolution.


  • Open Access

    Synchrotron light source focused X-ray detection with LGADs, AC-LGADs and TI-LGADs

    by A. Molnar, M. Davis, G. Oregan, S. Beringer, Y. Zhao, S.M. Mazza, A. Tiernan, J. Ott, H.F.-W. Sadrozinski, A. Seiden, et al.

    The response of Low Gain Avalanche Diodes (LGADs), a type of thin silicon detector with internal gain, to X-rays of energies between 6–16 keV was characterized at the Stanford Synchrotron Radiation Lightsource (SSRL). The utilized beamline at SSRL was 7-2, with a nominal beam size of 30 μm, repetition rate of 500 MHz, and with an energy dispersion ΔE/E of 10-4. Multi-channel LGADs, AC-LGADs, and TI-LGADs of different thicknesses and gain layer configurations from Hamamatsu Photonics (HPK) and Fondazione Bruno Kessler (FBK) were tested. The sensors were read out with a discrete component board and digitized with a fast oscilloscope or a CAEN fast digitizer. The devices' energy response, energy resolution, and time resolution were measured as a function of X-ray energy and position. The charge collection and multiplication mechanism were simulated using TCAD Sentaurus, and the results were compared with the collected data.


  • Open Access

    Jitter Measurements of 1 cm2 LGADs for Space Experiments

    by Ashish Bisht, Leo Cavazzini, Matteo Centis Vignali, Fabiola Caso, Omar Hammad Ali, Francesco Ficorella, Maurizio Boscardin, Giovanni Paternoster

    This work explores the possibility of using Low Gain Avalanche Diodes (LGADs) for tracker-based experiments studying Charged Cosmic Rays (CCRs) in space. While conventional silicon microstrip sensors provide only spatial information about the charged particle passing through the tracker, LGADs have the potential to provide additional timing information with a resolution in the order of tens of picoseconds. For the first time, it has been demonstrated that an LGAD with an active area of approximately 1 cm2 can achieve a jitter of less than 40 ps. A comparison of design and gain layers is carried out to understand which provides the best time resolution. For this purpose, laboratory measurements of sensors’ electrical properties and gain using LED and an Infrared laser, as well as their jitter, were performed.


  • A Holistic Optimisation - Success Mantra for HPC Performance

    by Ashish Bisht, Deepika H. V, Haribabu P, S A Kumar, S D Sudarsan

    High Performance Computing (HPC) aids in solving numerous complex scientific problems such as weather forecasting, drug discovery, physical simulations, molecular modeling, nuclear research, cryptanalysis, oil and gas exploration. To scale these kinds of applications across the nodes of a cluster or supercomputer Message Passing Interface (MPI) is used. The performance of MPI is one of the key aspects to achieve the expected speedup in the application performance on a HPC cluster, which in turn depends on the architecture of the servers and hence it is important to understand the same for HPC practitioners. Application performance is dependent not only on an applications' capability to scale but also on the efficiency of application to execute on an architecture. In this paper, we compare the performance of applications using MPI on two architectures of based on Intel and ARM. This is important as the former is a predominant architecture and the latter is one of the upcoming architectures among the supercomputers. We have used benchmarks which cover a wide variety of applications belonging to the Berkley dwarfs. This will help to analyze the comprehensive behavior of HPC applications on both the architectures. Finally, we present our observations in terms of computation, communication, data size and functional behavior of the applications.


  • Characterization of novel trench-isolated LGADs for 4D tracking

    by Ashish Bisht, Giacomo Borghi, Maurizio Boscardin, Matteo Centis Vignali, Francesco Ficorella, Omar Hammad Ali, Giovanni Paternoster


  • The second production of RSD (AC-LGAD) at FBK

    by M. Mandurrino, R. Arcidiacono, A. Bisht, G. Borghi, M. Boscardin, N. Cartiglia, M. Centis Vignali, G.-F. Dalla Betta, M. Ferrero, F. Ficorella, et al.

    In this contribution we describe the second run of RSD (Resistive AC-Coupled Silicon Detectors) designed at INFN Torino and produced by Fondazione Bruno Kessler (FBK), Trento. RSD are n-in-p detectors intended for 4D particle tracking based on the LGAD technology that get rid of any segmentation implant in order to achieve the 100% fill-factor. They are characterized by three key-elements, (i) a continuous gain implant, (ii) a resistive n-cathode and (iii) a dielectric coupling layer deposited on top, guaranteeing a good spatial reconstruction of the hit position while benefiting from the good timing properties of LGADs. We will start from the very promising results of our RSD1 batch in terms of tracking performances and then we will move to the description of the design of the RSD2 run. In particular, the principles driving the sensor design and the specific AC-electrode layout adopted to optimize the signal confinement will be addressed.