Younggyun Oh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Younggyun Oh has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Hyungil Chae
Department of Electrical Engineering, Konkuk University, Seoul, South Korea
2 shared publications - Jintae Kim
Konkuk University
1 shared publication Juyong Lee
Department of Electrical Engineering, Konkuk University, Seoul, South Korea
1 shared publication- Juyong Lee
Department of Electrical and Electronic Engineering, Konkuk University, Seoul 05029, Korea
1 shared publication Kihyun Kim
Department of Electrical Engineering, Konkuk University, Seoul, South Korea
1 shared publication- Sein Oh
Department of Electrical and Electronic Engineering, Kookmin University, Seoul 02707, Korea
1 shared publication
Latest Publications
- 17 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (11) , 3424-3433
An 85 dB DR 4 MHz BW Pipelined Noise-Shaping SAR ADC With 1–2 MASH Structure
A pipelined noise-shaping successive approximation register (NS-SAR) ADC with 1–2 multistage noise-shaping (MASH) structure is presented. Two-stage pipelined structure consisting of 5 bit NS-SAR and 4 bit NS-SAR quantizers enables 3rd-order noise-shaping. A single operational transconductance amplifier (OTA) is shared by an integrator for noise-shaping and a residue amplifier for pipelining to maximize the power efficiency. The measured dynamic range (DR) is 84.6 dB when the sampling rate is 83.3 MS/s, bandwidth is 4 MHz, and power consumption is 3.5 mW showing Schreier figure-of-merit (FoM S,DR ) of 175.2 dB. The proposed ADC structure greatly relaxes design requirement of each SAR quantizer and can achieve high resolution and wide bandwidth with good power efficiency.
- 17 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (11) , 3424-3433
An 85 dB DR 4 MHz BW Pipelined Noise-Shaping SAR ADC With 1–2 MASH Structure
A pipelined noise-shaping successive approximation register (NS-SAR) ADC with 1–2 multistage noise-shaping (MASH) structure is presented. Two-stage pipelined structure consisting of 5 bit NS-SAR and 4 bit NS-SAR quantizers enables 3rd-order noise-shaping. A single operational transconductance amplifier (OTA) is shared by an integrator for noise-shaping and a residue amplifier for pipelining to maximize the power efficiency. The measured dynamic range (DR) is 84.6 dB when the sampling rate is 83.3 MS/s, bandwidth is 4 MHz, and power consumption is 3.5 mW showing Schreier figure-of-merit (FoM S,DR ) of 175.2 dB. The proposed ADC structure greatly relaxes design requirement of each SAR quantizer and can achieve high resolution and wide bandwidth with good power efficiency.
- Open Access
Low Power CMOS-Based Hall Sensor with Simple Structure Using Double-Sampling Delta-Sigma ADC
A CMOS (Complementary metal-oxide-semiconductor) Hall sensor with low power consumption and simple structure is introduced. The tiny magnetic signal from Hall device could be detected by a high-resolution delta-sigma ADC in presence of offset and flickering noise. Also, the offset as well as the flickering noise are effectively suppressed by the current spinning technique combined with double sampling switches of the ADC. The double sampling scheme of the ADC reduces the operating frequency and helps to reduce the power consumption. The prototype Hall sensor is fabricated in a 0.18-µm CMOS process, and the measurement shows detection range of ±150 mT and sensitivity of 110 µV/mT. The size of active area is 0.7 mm2, and the total power consumption is 4.9 mW. The proposed system is advantageous not only for low power consumption, but also for small sensor size due to its simplicity.
Open AccessLow Power CMOS-Based Hall Sensor with Simple Structure Using Double-Sampling Delta-Sigma ADC
A CMOS (Complementary metal-oxide-semiconductor) Hall sensor with low power consumption and simple structure is introduced. The tiny magnetic signal from Hall device could be detected by a high-resolution delta-sigma ADC in presence of offset and flickering noise. Also, the offset as well as the flickering noise are effectively suppressed by the current spinning technique combined with double sampling switches of the ADC. The double sampling scheme of the ADC reduces the operating frequency and helps to reduce the power consumption. The prototype Hall sensor is fabricated in a 0.18-µm CMOS process, and the measurement shows detection range of ±150 mT and sensitivity of 110 µV/mT. The size of active area is 0.7 mm2, and the total power consumption is 4.9 mW. The proposed system is advantageous not only for low power consumption, but also for small sensor size due to its simplicity.