Sein Oh
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Sein Oh has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
H. Chae
Department of Electrical and Electronic Engineering Konkuk University Seoul Republic of Korea
1 shared publication- Hyungil Chae
Department of Electrical Engineering, Konkuk University, Seoul, South Korea
1 shared publication - Juyong Lee
Department of Electrical and Electronic Engineering, Konkuk University, Seoul 05029, Korea
1 shared publication K. Kim
Department of Electronic Engineering Kookmin University Seoul Republic of Korea
1 shared publication- Younggyun Oh
Department of Electrical Engineering, Kookmin University, Seoul, South Korea
1 shared publication
Latest Publications
- Open Access
Low Power CMOS-Based Hall Sensor with Simple Structure Using Double-Sampling Delta-Sigma ADC
A CMOS (Complementary metal-oxide-semiconductor) Hall sensor with low power consumption and simple structure is introduced. The tiny magnetic signal from Hall device could be detected by a high-resolution delta-sigma ADC in presence of offset and flickering noise. Also, the offset as well as the flickering noise are effectively suppressed by the current spinning technique combined with double sampling switches of the ADC. The double sampling scheme of the ADC reduces the operating frequency and helps to reduce the power consumption. The prototype Hall sensor is fabricated in a 0.18-µm CMOS process, and the measurement shows detection range of ±150 mT and sensitivity of 110 µV/mT. The size of active area is 0.7 mm2, and the total power consumption is 4.9 mW. The proposed system is advantageous not only for low power consumption, but also for small sensor size due to its simplicity.
Open AccessLow Power CMOS-Based Hall Sensor with Simple Structure Using Double-Sampling Delta-Sigma ADC
A CMOS (Complementary metal-oxide-semiconductor) Hall sensor with low power consumption and simple structure is introduced. The tiny magnetic signal from Hall device could be detected by a high-resolution delta-sigma ADC in presence of offset and flickering noise. Also, the offset as well as the flickering noise are effectively suppressed by the current spinning technique combined with double sampling switches of the ADC. The double sampling scheme of the ADC reduces the operating frequency and helps to reduce the power consumption. The prototype Hall sensor is fabricated in a 0.18-µm CMOS process, and the measurement shows detection range of ±150 mT and sensitivity of 110 µV/mT. The size of active area is 0.7 mm2, and the total power consumption is 4.9 mW. The proposed system is advantageous not only for low power consumption, but also for small sensor size due to its simplicity.
- Open Access
- 1 May 2020
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 56 (10) , 480-482
Bandpass ΔΣ ADC using pipelined SAR ADC
This Letter proposes a second‐order bandpass ΔΣ ADC using a pipelined successive‐approximation‐register (SAR) ADC as an internal quantiser. The second‐order bandpass noise‐shaping is achieved by utilising the residue signal after SAR conversion and inherent delay existing in a pipelined structure. The proposed ADC can show very high resolution even with low‐order noise‐shaping and low oversampling ratio. Also, it shows good energy efficiency and a high sampling rate due to the use of a pipelined SAR ADC as a quantiser.
- 1 May 2020
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 56 (10) , 480-482
Open AccessBandpass ΔΣ ADC using pipelined SAR ADC
This Letter proposes a second‐order bandpass ΔΣ ADC using a pipelined successive‐approximation‐register (SAR) ADC as an internal quantiser. The second‐order bandpass noise‐shaping is achieved by utilising the residue signal after SAR conversion and inherent delay existing in a pipelined structure. The proposed ADC can show very high resolution even with low‐order noise‐shaping and low oversampling ratio. Also, it shows good energy efficiency and a high sampling rate due to the use of a pipelined SAR ADC as a quantiser.