Magnus Rydén
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Magnus Rydén has a total of 12 co-authors. Here are the top co-authors by number of shared publications:
- Tobias Mattisson
Division of Energy Technology, Department of Space, Earth and Environment, Chalmers University of Technology, 41296 Gothenburg, Sweden
3 shared publications - Anders Lyngfelt
Chalmers University of Technology, 412 96 Göteborg, Sweden
2 shared publications - Henrik Leion
Chemistry and Chemical Engineering, Chalmers University of Technology, 412 93 Göteborg, Sweden
2 shared publications - Dazheng Jing
Department of Chemistry and Chemical Engineering, Division of Energy and Materials, Chalmers University of Technology, SE-41296 Gothenburg, Sweden
1 shared publication - Esa Pursiheimo
VTT Technical Research Centre of Finland, Energy Systems and Climate, Finland
1 shared publication - Ivana Staničić
Department of Space, Earth and Environment, Division of Energy Technology, Chalmers University of Technology, SE-412 96 Gothenburg, Sweden
1 shared publication
Latest Publications
- Open Access
- 1 May 2021
- Published by Elsevier in Biomass and Bioenergy
- Vol. 148, 106060
Oxygen carrier aided combustion (OCAC) of two waste fuels - Experimental and theoretical study of the interaction between ilmenite and zinc, copper and lead
- 1 May 2021
- Published by Elsevier in Biomass and Bioenergy
- Vol. 148, 106060
Open AccessOxygen carrier aided combustion (OCAC) of two waste fuels - Experimental and theoretical study of the interaction between ilmenite and zinc, copper and lead
- Open Access
- 1 August 2019
- Published by Elsevier in Sustainable Energy Technologies and Assessments
- Vol. 34, 157-172
Robust decision making analysis of BECCS (bio-CLC) in a district heating and cooling grid
- 1 August 2019
- Published by Elsevier in Sustainable Energy Technologies and Assessments
- Vol. 34, 157-172
Open AccessRobust decision making analysis of BECCS (bio-CLC) in a district heating and cooling grid
- Open Access
- 30 September 2013
- Published by Wiley in International Journal of Chemical Engineering
- Vol. 2013, 1-16
Examination of Perovskite Structure CaMnO3-δwith MgO Addition as Oxygen Carrier for Chemical Looping with Oxygen Uncoupling Using Methane and Syngas
Perovskite structure oxygen carriers with the general formula CaMnxMg1-xO3-δwere spray-dried and examined in a batch fluidized bed reactor. The CLOU behavior, reactivity towards methane, and syngas were investigated at temperature 900°C to 1050°C. All particles showed CLOU behavior at these temperatures. For experiments with methane, a bed mass corresponding to 57 kg/MW was used in the reactor, and the average CH4to CO2conversion was above 97% for most materials. Full syngas conversion was achieved for all materials utilizing a bed mass corresponding to 178 kg/MW. SEM/EDX and XRD confirmed the presence of MgO in the fresh and used samples, indicating that the Mg cation is not incorporated into the perovskite structure and the active compound is likely pure CaMnO3-δ. The very high reactivity with fuel gases, comparable to that of baseline oxygen carriers of NiO, makes these perovskite particles highly interesting for commercial CLC application. Contrary to NiO, oxygen carriers based on CaMnO3-δhave no thermodynamic limitations for methane oxidation to CO2and H2O, not to mention that the materials are environmentally friendly and can utilize much cheaper raw materials for production. The physical properties, crystalline phases, and morphology information were also determined in this work.
- 30 September 2013
- Published by Wiley in International Journal of Chemical Engineering
- Vol. 2013, 1-16
Open AccessExamination of Perovskite Structure CaMnO3-δwith MgO Addition as Oxygen Carrier for Chemical Looping with Oxygen Uncoupling Using Methane and Syngas
Perovskite structure oxygen carriers with the general formula CaMnxMg1-xO3-δwere spray-dried and examined in a batch fluidized bed reactor. The CLOU behavior, reactivity towards methane, and syngas were investigated at temperature 900°C to 1050°C. All particles showed CLOU behavior at these temperatures. For experiments with methane, a bed mass corresponding to 57 kg/MW was used in the reactor, and the average CH4to CO2conversion was above 97% for most materials. Full syngas conversion was achieved for all materials utilizing a bed mass corresponding to 178 kg/MW. SEM/EDX and XRD confirmed the presence of MgO in the fresh and used samples, indicating that the Mg cation is not incorporated into the perovskite structure and the active compound is likely pure CaMnO3-δ. The very high reactivity with fuel gases, comparable to that of baseline oxygen carriers of NiO, makes these perovskite particles highly interesting for commercial CLC application. Contrary to NiO, oxygen carriers based on CaMnO3-δhave no thermodynamic limitations for methane oxidation to CO2and H2O, not to mention that the materials are environmentally friendly and can utilize much cheaper raw materials for production. The physical properties, crystalline phases, and morphology information were also determined in this work.