GMGoran Mihajlovic

Goran Mihajlovic

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Goran Mihajlovic has a total of 58 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Achieving low write error rates in perpendicular spin–orbit torque MRAM: A micromagnetic modeling feasibility study

    by Goran Mihajlović, Yabin Fan, Tiffany S. Santos, Michael K. Grobis, Neil Robertson

    We report a micromagnetic modeling study of switching perpendicularly magnetized free layers with spin–orbit torques (SOTs) generated by spin currents consisting of only orthogonal (conventional SOT) as well as both orthogonal and collinear (unconventional SOT) spin polarizations relative to the free layer (FL) magnetization. Focusing on the FL diameter of 50 nm, for conventional SOT, we find relatively high probabilities of FL back-hopping or incomplete switching at room temperature (T) for several bias configurations that deterministically switch the FL at T = 0 K, including in-plane bias field with and without Dzyaloshinskii–Moriya interaction (DMI) as well as the field-free case with DMI in the presence of field-like torque. For unconventional SOT, fast, field-free deterministic switching is found at T = 0 K for orthogonal y-spin SOT efficiency θy = 0.3 when collinear z-spin efficiency θz/θy > 0.25. Such large ratio is needed to change the nature of the magnetization switching from a non-uniform state with dominant component along y to an almost fully reversed and uniform state along -z, resulting in thermally robust and complete switching without back-hopping. In addition, the presence of z spins of such magnitude results in lowering of the switching current density by a factor of about 3, depending on the damping parameter α of the FL (more for lower α). Based on these results, we conclude that achieving low write error rate operation in perpendicular SOT MRAM is not feasible using approaches that exploit conventional SOT, but it should be straightforward to achieve with unconventional SOTs that meet parameter values determined by this study.

  • Open Access

    Leveraging a Passive MRAM Crossbar for Hardware-in-the-Loop and Continual learning

    by M. Drouhin, M. Grelier, M. Deroo, Y. Sassi, E. Monteblanco, N. Davila, G. Mihajlović, R. V. Chopdekar, T. S. Santos, J. A. Katine, et al.

    Artificial neural networks have enabled major advances in artificial intelligence, yet their growing computational and energy demands challenge conventional von Neumann architectures due to the costly separation of memory and processing. In-memory computing has emerged as a promising solution, particularly through memristive crossbar arrays capable of performing multiply-and-accumulate operations directly within memory. Among non-volatile memory technologies, magnetic tunnel junctions, the core elements of MRAM, offer high endurance, non-volatility, and CMOS compatibility, making them attractive candidates for neuromorphic systems. In this work, we report inference results on a 15 × 15 MRAM crossbar, benchmarking experimental measurements against numerical simulations. We further demonstrate hardware-in-the-loop inference and experimentally validate metaplasticity mechanisms enabling continual learning on simple tasks. These results highlight the potential of MRAM-based in-memory architectures for adaptive, energy-efficient, and scalable AI hardware.

  • Characterization of thermal stability of perpendicular spin transfer torque magnetoresistive random access memory cells with free layer diameter of around 20 nm

    by Goran Mihajlović, Wonjoon Jung, Noraica Dávila, Hans J Richter, Michael Tran, Tiffany S Santos, Jordan A Katine, Michael K Grobis

    We report an experimental evaluation of the thermal stability factor, Δ, for magnetoresistive random access memory bits with perpendicular magnetic anisotropy and a magnetic free layer diameter of about 20 nm, using magnetic field and spin transfer torque (STT) excitations to accelerate switching. We compare the results to the values obtained by thermal-only excitation. We find that fitting the magnetic switching field distributions to a macrospin model results in identical values of Δ mean and sigma to those determined by direct thermal excitation, also known as the retention bake method. On the other hand, fitting the pulse width dependence of the STT switching voltages in the thermal activation regime can either underestimate or overestimate Δ depending on the choice of exponent ξ that defines the scaling of Δ with STT. We find the best agreement for ξ = 1.45.

  • Size Dependence of the Read Voltage and Electrical Diameter of STT MRAM Cells

    by Goran Mihajlović, Wonjoon Jung, Noraica Dávila, Jeffrey Lille, Michael Tran, Jordan A. Katine, Michael K. Grobis

    We present an experimental study of the size-dependent tunnelling magnetoresistance ratio (TMR) and voltage read signal in perpendicular spin transfer torque magnetoresistive random access (STT-MRAM) memory cells, which shows that the maximum read signal is mostly independent of the size, while TMR decreases with decreasing size. Our analysis shows that this is due to a size-dependent parasitic resistance specific to the nanofabrication process and that the intrinsic ΔRA of the cells is size-independent. As a consequence, we show that the electrical diameter of an MRAM cell can be reliably extracted down to sub-20 nm assuming that ΔRA does not depend on the cell size.


  • Spin transfer torque switching in double magnetic tunnel junctions based on dual MgO layers

    by G. Mihajlović, W. Jung, R. V. Chopdekar, J. Lille, M. K. Grobis

    We report fabrication and characterization of double magnetic tunnel junction (DMTJ) magneto-resistive random access memory cells that exhibit characteristic about 2X reduction of switching current compared to single reference layer junctions, but maintain high tunneling magnetoresistance ratio exceeding 120 %, high coercive fields of the free layer of more than 2 kOe for 65 nm cells, and magnetically stable reference layers with pinning fields above 6 kOe. Switching analysis performed for two different relative magnetization orientations of the reference layers shows that the net switching current is the result of combined spin transfer torque effects of the individual reference layers, with tunneling and spin-valve-like contributions adding constructively. Our work shows that efficient reduction of switching current can be achieved in double magnetic tunnel junctions with dual MgO layers where one of the layers has significantly lower resistance-area product to enable high magnetoresistance ratio.


  • Open Access

    Enhanced write margin of perpendicular MRAM cells using thick MgO cap layer

    by G. Mihajlović, T. S. Santos, J. Li, J. A. Katine, M. K. Grobis

    Implementation of spin transfer torque magneto-resistive random access memory (STT-MRAM) in memory chips requires that the write margin of the MRAM cell, defined as the difference between breakdown voltage and write voltage for the specified endurance, write error rate, and write speed, is sufficiently large in order to accommodate resistance variations arising from external chip circuitry. We show that by increasing only the thickness of the MgO cap layer to make its resistance-area product close to that of the main MgO barrier, the write margin can be increased substantially without affecting the thermal stability of the cell.

  • Open Access

    Thermal effects on damping determination of perpendicular MRAM devices by spin-torque ferromagnetic resonance

    by H. J. Richter, G. Mihajlović, R. V. Chopdekar, W. Jung, J. Gibbons, N. D. Melendez, M. K. Grobis, T. S. Santos

    We report device-level damping measurements using spin-torque driven ferromagnetic resonance on perpendicular magnetic random-access memory cells. It is shown that thermal agitation enhances the apparent damping for cells smaller than about 55 nm. The effect is fundamental and does not reflect a true damping increase. In addition to the thermal effect, it is still found that device-level damping is higher than film-level damping and increases with decreasing cell size. This is attributed to edge damage caused by device patterning.


  • Fabrication and Individual Addressing of STT-MRAM Bit Array With 50 nm Full Pitch

    by Lei Wan, Tsai-Wei Wu, Neil Smith, Tiffany Santos, Goran Mihajlovic, Jui-Lung Li, Kanaiyalal Patel, Noraica D. Melendez, Bruce Terris, Jordan A. Katine

    Spin-transfer torque (STT) magnetic random access memory (MRAM) is gaining commercial traction in low-density embedded and standalone memories, but the available market opportunities would grow exponentially if STT-MRAM could approach dynamic random access memory (DRAM) bit density. Of course, achieving DRAM density will require, among other things, demonstrating the ability to pattern MRAM bits at an extremely tight pitch. Here, an experimental demonstration of fabrication and electrical testing of a STT-MRAM bit array are reported. By optimizing the hard mask and ion beam etching (IBE) processes, MRAM bit arrays with a full pitch down to 50 nm are fabricated, in which the bits are individually tested using a novel bottom-point-contact method.


  • Open Access

    Optically detected spin–orbit torque ferromagnetic resonance in an in-plane magnetized ellipse

    by P. S. Keatley, K. Chatzimpaloglou, T. Manago, P. Androvitsaneas, T. H. J. Loughran, R. J. Hicken, G. Mihajlović, L. Wan, Y. Choi, J. A. Katine

    Time-resolved scanning Kerr microscopy has been used to perform optically detected, phase-resolved spin–orbit torque ferromagnetic resonance (SOT-FMR) measurements on a microscale CoFeB ellipse at the center of a Pt Hall cross subject to RF and DC current. Time-resolved polar Kerr images revealed localized dynamics with large amplitude at the center and weaker amplitude at the edges. Therefore, field swept SOT-FMR spectra were acquired from the so-called center mode to probe the SOTs active at the center of the ellipse, thus minimizing non-uniform edge contributions. When the magnetic field was applied at 30° from the hard axis of the ellipse and a DC current was applied, a marked asymmetry was observed in the amplitude and linewidth of the FMR peaks as the applied field was reversed. Both absorptive and dispersive parts of the spectra were in good agreement with a macrospin calculation. The damping parameter (α) and the Slonczewski torque parameter were determined to be 0.025 and (6.75 ± 0.75) × 10−7 Oe A−1 cm2, respectively. The hard axis SOT-FMR linewidth was found to be almost independent of the DC current value, suggesting that the SOT has a minimal influence in the hard axis configuration and that thermal effects were insignificant. This study paves the way for spatially resolved measurements of SOT probed using localized modes of microscale devices that go beyond the spatially averaged capability of electrical measurement techniques.


  • Thermal stability for domain wall mediated magnetization reversal in perpendicular STT MRAM cells with W insertion layers

    by G. Mihajlović, N. Smith, T. Santos, J. Li, B. D. Terris, J. A. Katine

    We present an analytical model for calculating the energy barrier for the magnetic field-driven domain wall-mediated magnetization reversal of a magneto-resistive random access memory cell and apply it to study thermal stability factor Δ for various thicknesses of W layers inserted into the free layer (FL) as a function of the cell size and temperature. We find that, by increasing the W thickness, the effective perpendicular magnetic anisotropy (PMA) energy density of the FL film monotonically increases, but at the same time, Δ of the cell mainly decreases. Our analysis shows that, in addition to saturation magnetization Ms and exchange stiffness constant A ex of the FL film, the parameter that quantifies the Δ value of the cell is its coercive field Hc, rather than the net PMA field Hk of the FL film comprising the cell.