HZHang Zhong

Hang Zhong

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Hang Zhong has a total of 31 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Probing photoreactions of individual suspended carbonaceous aerosols by multi-wavelength OT-SERS

    by Hang Zhong, Jun Chen, Yi Hu, Tao Shao, Junsheng Liao

    The photoreactions of suspended particles (4-MBA/AgNPs/C) under 473, 589 and 671 nm laser irradiation were monitored in situ by OT-SERS.

  • The Structure Dissection of Compacted CeO2/La2O3 Laminates by Spatially Offset Raman Spectroscopy

    by Yi Hu, Jun Chen, Xinai Liu, Hang Zhong, Jingsong Xu

    To tackle the challenge of non‐destructively analyzing complex oxide layers formed by atmospheric corrosion on active metals, we investigate the potential of inverse spatially offset Raman spectroscopy (inverse‐SORS) to detect corrosion products and elucidate how the spectroscopic features of SORS vary. This study explores the utilization of inverse‐SORS technology for longitudinal structural analysis of opaque CeO2/La2O3 laminates, which serve as a proxy for corrosion products. Through a combination of experimental measurements and Monte Carlo simulation, it demonstrates the feasibility of inverse‐SORS in non‐destructively elucidating the layered structure of these laminates. With increasing the spatial offset of this technology, the Raman intensity ratio of La2O3‐to‐CeO2 increases from 0.23 to 3.2 and then decreases to 0.27 for the CeO2/La2O3 sample with a 34‐μm‐thick CeO2 layer under 532‐nm excitation, whereas the bottom La2O3 layer is hardly detected when the thickness of the upper La2O3 layer increases to 225 μm. The results reveal that a thinner CeO2 layer facilitates the escape and detection of Raman signals originating from the bottom La2O3 layer, leading to an enhanced La2O3‐to‐CeO2 signal ratio and a reduced offset at the characteristic peak. The research also sheds light on the intricate interplay among multiple variables, such as spatial offset, laser wavelength, the corresponding absorption factor, the thickness of the oxide layer, and the compactness. These insights suggest that SORS is a valuable and non‐destructive approach for dissecting the structures of highly turbid composites of metallic compounds and semi‐quantitatively deducing their thickness.

  • Optimization of the in-plane activity of MoS2 monolayer by Pd-S bonds for hydrogen evolution reaction

    by Xinai Liu, Jun Chen, Yi Hu, Qifa Pan, Hang Zhong, Rongguang Zeng, Tao Shao, Ziting He, Jinfan Chen


  • Activating Titanium Metal with H2 Plasma for the Hydrogen Evolution Reaction

    by Tianzhu Zhang, Jiliang Wu, Jinfan Chen, Qifa Pan, Xuefeng Wang, Hang Zhong, Ran Tao, Jun Yan, Yi Hu, Xiaoqiu Ye, et al.

    Developing a high-performance nonprecious metal electrocatalyst for water splitting is a strong demand for the large-scale application of electrochemical H2 production. In this work, we design a facile and scalable strategy to activate titanium metal for the hydrogen evolution reaction (HER) in alkaline media through incorporating hydrogen into the α-Ti crystal lattice by H2 plasma bombardment. Benefiting from the accelerated charge transfer and enlarged electrochemical surface area after H2 plasma treatment, the H-incorporated Ti shows remarkably enhanced HER activity with a much lower overpotential at −10 mA cm–2 by 276 mV when compared to the pristine Ti. It is revealed that the retention of the incorporated H(D) atoms in the Ti crystal lattice during HER accounts for the durable feature of the catalyst. Density functional theory calculations demonstrate the effectiveness of hydrogen incorporation in tuning the adsorption energy of reaction species via charge redistribution. Our work offers a novel route to activate titanium or other metals by H incorporation through a controllable H2 plasma treatment to tune the electronic structure for water splitting reactions.


  • Plasmon catalytic PATP coupling reaction on Ag-NPs/graphite studied via in situ electrochemical surface-enhanced Raman spectroscopy

    by Hang Zhong, Jun Chen, Jinfan Chen, Ran Tao, Jiaolai Jiang, Yi Hu, Jingsong Xu, Tianzhu Zhang, Junsheng Liao

    The p-aminothiophenol (PATP) coupling reaction on plasmon substrates such as Ag and Au nanoparticles has received extensive attention since the catalytic effect of the surface plasmon was found. Currently, in situ kinetic studies of this reaction are rare, especially those focusing on the specific role of the hot electron–hole carriers. Here, in situ electrochemical surface-enhanced Raman spectroscopy (SERS) is developed to study the plasmon catalytic reaction of PATP in a controlled aqueous environment involving the factors of O2, electron and hole carriers, and solution pH. Ag nanoparticles supported on graphite serve as a SERS substrate, which could separate hot electron–hole pairs effectively and is beneficial to study the effects of hot carriers on plasmon-driven reactions. In situ electrochemical SERS measurements reveal two reaction paths for the PATP coupling reaction. One is that plasmon-induced hot holes activate the dehydrogenation of PATP and then the radical coupling reaction to form p,p′-dimercaptoazobenzene (DMAB) under O2-free conditions. Another is likely to be that the surface Ag2O/AgOH, which is generated from Ag and 1O2/O2 −, catalyzes the oxidation of PATP and then the coupling process under O2-rich conditions. Benefitting from the potential/atmosphere controlled measurements in situ, the intermediate species of PATP(NH)/PATP(N) are observed with vibrational bands at around 1056, 1202, 1253, 1395, 1514 and 1540 cm−1.


  • Underpotential Deposition of Copper Clusters on Sulfur and Nitrogen Co‐Doped Graphite Foam for the Oxygen Reduction Reaction

    by Jingsong Xu, Rui Li, Rongguang Zeng, Yingru Li, Qifa Pan, Hang Zhong, Jun Chen

    In this study, we successfully fabricated approximately 1 nm copper clusters on sulfur and nitrogen co‐doped graphite foam (SNGF) by using an electrodeposition method. The introduction of sulfur dopants enhances the metal‐support interaction and, thus, allows the application of the underpotential deposition (UPD) technique on graphite foam. Furthermore, the strong S−Cu binding leads to the preferential formation and firm anchoring of Cu nuclei on monodispersed S sites. The controllable growth of Cu nuclei into Cu clusters is achieved by controlling the deposition amount by adjusting the electrochemical parameters. As an example, the supported Cu clusters were utilized towards oxygen reduction reaction catalysis, exhibiting a high catalytic activity and a long‐term durability. Remarkably, this strategy is promising for developing a general method to prepare other metal clusters (e. g. Ag clusters).


  • [Effect on time of temporarily-closed wound drainage on blood loss of primary total knee arthroplasty after intravenous and intra-articular injection of tranexamic acid].

    by Ruibo Li, Shijiu Yin, Hang Zhong, Ping Mu, Jing Yang

    To investigate the effect and safety of time of temporarily-closed wound drainage on blood loss of primary total knee arthroplasty (TKA) after intravenous and intra-articular injection of tranexamic acid (TXA). Eighty female patients were selected from 102 patients who underwent primary TKA between September 2015 and July 2016, who were randomly divided into 4 groups: control group (group A), 30 minutes group (group B), 60 minutes group (group C), and 90 minutes group (group D), 20 patients each group. No significant difference was found in age, body mass index, side, pathogen, duration, and preoperative hemoglobin, albumin, and hematocrit between 4 groups ( P>0.05). All the patients received intravenous injection of 1 g TXA at 10 minutes before removing the tourniquet. The patients in group A were injected with 60 mL normal saline into the articular cavity and closed drainage after surgery, while the patients in groups B, C, and D were injected with 60 mL TXA into the articular cavity and closed drainage for 30, 60, and 90 minutes respectively. The volume of drainage at 24 hours after operation, the total blood loss, the postoperative hemoglobin level, maximum hemoglobin loss, albumin loss, the volume and frequency of blood transfusion, venous thrombo embolism rate, and pulmonary embolism rate were recorded and compared between groups. The volume of drainage and total blood loss in groups B, C, and D were less than those of group A, showing significant difference between groups C, D and group A ( P0.05). The volume of drainage at 24 hours after operation in group B was higher than that in groups C and D, showing significant difference between groups B and D ( P0.05). There was no significant difference in the total blood loss between groups B, C, and D ( P>0.05). The hemoglobin loss and albumin loss gradually decreased from groups A to D, but no significant difference was found between groups ( P>0.05). No venous thrombo embolism and pulmonary embolism occurred. The hemoglobin value decreased to 28 g/L at 3 days after operation in 1 patient of group D, who received venous transfusion of 20 g human albumin. Intravenous and topical application of TXA in TKA can significantly decrease postoperative bleeding. Topical TXA combined with 60 minutes temporarily-closed wound drainage may reduce postoperative blood loss to the greatest extent without increasing the risk of venous thrombo and pulmonary embolism event after TKA..