Yi Hu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Yi Hu has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Hang Zhong
Science and Technology on Surface Physics and Chemistry Laboratory, Jiangyou 621908, China
5 shared publications - Jun Chen
Science and Technology on Surface Physics and Chemistry Laboratory, Jiangyou 621908, China
4 shared publications - Tao Shao
Science and Technology on Surface Physics and Chemistry Laboratory, Jiangyou 621908, China
3 shared publications - Jinfan Chen
Institute of Materials, China Academy of Engineering Physics, Mianyang 621907, China
2 shared publications - Jingsong Xu
Science and Technology on Surface Physics and Chemistry Laboratory 621908 Jiangyou China
2 shared publications - Qifa Pan
Science and Technology on Surface Physics and Chemistry Laboratory, Jiangyou, China
2 shared publications
Latest Publications
- 14 May 2025
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 27 (29) , 15314-15320
Probing photoreactions of individual suspended carbonaceous aerosols by multi-wavelength OT-SERS
The photoreactions of suspended particles (4-MBA/AgNPs/C) under 473, 589 and 671 nm laser irradiation were monitored in situ by OT-SERS.
- 14 May 2025
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 27 (29) , 15314-15320
Probing photoreactions of individual suspended carbonaceous aerosols by multi-wavelength OT-SERS
The photoreactions of suspended particles (4-MBA/AgNPs/C) under 473, 589 and 671 nm laser irradiation were monitored in situ by OT-SERS.
- 30 October 2024
- Published by Wiley in Journal of Raman Spectroscopy
- Vol. 56 (1) , 12-24
The Structure Dissection of Compacted CeO2/La2O3 Laminates by Spatially Offset Raman Spectroscopy
To tackle the challenge of non‐destructively analyzing complex oxide layers formed by atmospheric corrosion on active metals, we investigate the potential of inverse spatially offset Raman spectroscopy (inverse‐SORS) to detect corrosion products and elucidate how the spectroscopic features of SORS vary. This study explores the utilization of inverse‐SORS technology for longitudinal structural analysis of opaque CeO2/La2O3 laminates, which serve as a proxy for corrosion products. Through a combination of experimental measurements and Monte Carlo simulation, it demonstrates the feasibility of inverse‐SORS in non‐destructively elucidating the layered structure of these laminates. With increasing the spatial offset of this technology, the Raman intensity ratio of La2O3‐to‐CeO2 increases from 0.23 to 3.2 and then decreases to 0.27 for the CeO2/La2O3 sample with a 34‐μm‐thick CeO2 layer under 532‐nm excitation, whereas the bottom La2O3 layer is hardly detected when the thickness of the upper La2O3 layer increases to 225 μm. The results reveal that a thinner CeO2 layer facilitates the escape and detection of Raman signals originating from the bottom La2O3 layer, leading to an enhanced La2O3‐to‐CeO2 signal ratio and a reduced offset at the characteristic peak. The research also sheds light on the intricate interplay among multiple variables, such as spatial offset, laser wavelength, the corresponding absorption factor, the thickness of the oxide layer, and the compactness. These insights suggest that SORS is a valuable and non‐destructive approach for dissecting the structures of highly turbid composites of metallic compounds and semi‐quantitatively deducing their thickness.
- 30 October 2024
- Published by Wiley in Journal of Raman Spectroscopy
- Vol. 56 (1) , 12-24
The Structure Dissection of Compacted CeO2/La2O3 Laminates by Spatially Offset Raman Spectroscopy
To tackle the challenge of non‐destructively analyzing complex oxide layers formed by atmospheric corrosion on active metals, we investigate the potential of inverse spatially offset Raman spectroscopy (inverse‐SORS) to detect corrosion products and elucidate how the spectroscopic features of SORS vary. This study explores the utilization of inverse‐SORS technology for longitudinal structural analysis of opaque CeO2/La2O3 laminates, which serve as a proxy for corrosion products. Through a combination of experimental measurements and Monte Carlo simulation, it demonstrates the feasibility of inverse‐SORS in non‐destructively elucidating the layered structure of these laminates. With increasing the spatial offset of this technology, the Raman intensity ratio of La2O3‐to‐CeO2 increases from 0.23 to 3.2 and then decreases to 0.27 for the CeO2/La2O3 sample with a 34‐μm‐thick CeO2 layer under 532‐nm excitation, whereas the bottom La2O3 layer is hardly detected when the thickness of the upper La2O3 layer increases to 225 μm. The results reveal that a thinner CeO2 layer facilitates the escape and detection of Raman signals originating from the bottom La2O3 layer, leading to an enhanced La2O3‐to‐CeO2 signal ratio and a reduced offset at the characteristic peak. The research also sheds light on the intricate interplay among multiple variables, such as spatial offset, laser wavelength, the corresponding absorption factor, the thickness of the oxide layer, and the compactness. These insights suggest that SORS is a valuable and non‐destructive approach for dissecting the structures of highly turbid composites of metallic compounds and semi‐quantitatively deducing their thickness.
- 27 September 2023
- Published by Elsevier in Applied Surface Science
- Vol. 642
Optimization of the in-plane activity of MoS2 monolayer by Pd-S bonds for hydrogen evolution reaction
- 27 September 2023
- Published by Elsevier in Applied Surface Science
- Vol. 642
Optimization of the in-plane activity of MoS2 monolayer by Pd-S bonds for hydrogen evolution reaction
- 19 May 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (21) , 24682-24691
Activating Titanium Metal with H2 Plasma for the Hydrogen Evolution Reaction
Developing a high-performance nonprecious metal electrocatalyst for water splitting is a strong demand for the large-scale application of electrochemical H2 production. In this work, we design a facile and scalable strategy to activate titanium metal for the hydrogen evolution reaction (HER) in alkaline media through incorporating hydrogen into the α-Ti crystal lattice by H2 plasma bombardment. Benefiting from the accelerated charge transfer and enlarged electrochemical surface area after H2 plasma treatment, the H-incorporated Ti shows remarkably enhanced HER activity with a much lower overpotential at −10 mA cm–2 by 276 mV when compared to the pristine Ti. It is revealed that the retention of the incorporated H(D) atoms in the Ti crystal lattice during HER accounts for the durable feature of the catalyst. Density functional theory calculations demonstrate the effectiveness of hydrogen incorporation in tuning the adsorption energy of reaction species via charge redistribution. Our work offers a novel route to activate titanium or other metals by H incorporation through a controllable H2 plasma treatment to tune the electronic structure for water splitting reactions.
- 19 May 2021
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 13 (21) , 24682-24691
Activating Titanium Metal with H2 Plasma for the Hydrogen Evolution Reaction
Developing a high-performance nonprecious metal electrocatalyst for water splitting is a strong demand for the large-scale application of electrochemical H2 production. In this work, we design a facile and scalable strategy to activate titanium metal for the hydrogen evolution reaction (HER) in alkaline media through incorporating hydrogen into the α-Ti crystal lattice by H2 plasma bombardment. Benefiting from the accelerated charge transfer and enlarged electrochemical surface area after H2 plasma treatment, the H-incorporated Ti shows remarkably enhanced HER activity with a much lower overpotential at −10 mA cm–2 by 276 mV when compared to the pristine Ti. It is revealed that the retention of the incorporated H(D) atoms in the Ti crystal lattice during HER accounts for the durable feature of the catalyst. Density functional theory calculations demonstrate the effectiveness of hydrogen incorporation in tuning the adsorption energy of reaction species via charge redistribution. Our work offers a novel route to activate titanium or other metals by H incorporation through a controllable H2 plasma treatment to tune the electronic structure for water splitting reactions.