Tianwei Deng
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Tianwei Deng has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
Guoqing Luo
Institute of Antennas and Microwave Technology, School of Electronics and Information, Hangzhou Dianzi University, Hangzhou, China
1 shared publicationMiao-Jun Chua
Temasek Laboratories, National University of Singapore, Singapore
1 shared publication- Yufeng Yu
School of Information and Electrical Engineering, Hangzhou City University, Hangzhou, China
1 shared publication Zheng-Wen Li
Temasek Laboratories, National University of Singapore, Singapore
1 shared publication- Zhengwen Li
State Key Laboratory of Precision Measuring Technology & Instruments, Laboratory of Micro/Nano Manufacturing Technology, Tianjin University, Tianjin 300072, China
1 shared publication Zhi Ning Chen
Department of Electrical & Computer Engineering, National University of Singapore, 4 Engineering Drive 3, 117583 Singapore
1 shared publication
Latest Publications
- 1 September 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 65 (11) , 5886-5894
Ultrathin Broadband Absorber Using Frequency-Selective Surface and Frequency-Dispersive Magnetic Materials
The bandwidth of frequency-selective surface (FSS)-based absorber decreases when high permittivity material is used to reduce the thickness of the absorber. A solution of this thickness-bandwidth dilemma was presented by using resistive FSS layer and frequency-dispersive magnetic material (FDMM) in substrate. The FDMM was designed for certain profile of complex permeability, and the FDMM substrate has both high permeability and permittivity for thickness reduction and near frequency-non-dispersive input susceptance for bandwidth expanding at low frequencies. A 2.3mm-thick FSS-based FDMM absorber was designed and fabricated, which achieved a broad absorption band of 4~15 GHz (3.75:1) with -10dB reflectivity. In terms of the same bandwidth ratio, the thickness of FSS-based FDMM absorber is only 0.031 λL against the thickness of 0.114 λL of conventional FSS-based absorber.
- 1 September 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 65 (11) , 5886-5894
Ultrathin Broadband Absorber Using Frequency-Selective Surface and Frequency-Dispersive Magnetic Materials
The bandwidth of frequency-selective surface (FSS)-based absorber decreases when high permittivity material is used to reduce the thickness of the absorber. A solution of this thickness-bandwidth dilemma was presented by using resistive FSS layer and frequency-dispersive magnetic material (FDMM) in substrate. The FDMM was designed for certain profile of complex permeability, and the FDMM substrate has both high permeability and permittivity for thickness reduction and near frequency-non-dispersive input susceptance for bandwidth expanding at low frequencies. A 2.3mm-thick FSS-based FDMM absorber was designed and fabricated, which achieved a broad absorption band of 4~15 GHz (3.75:1) with -10dB reflectivity. In terms of the same bandwidth ratio, the thickness of FSS-based FDMM absorber is only 0.031 λL against the thickness of 0.114 λL of conventional FSS-based absorber.
- 7 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 65 (8) , 4363-4367
3-D Frequency-Selective Rasorber With Wide Upper Absorption Band
This communication presents a 3-D frequency-selective rasorber (FSR) that has a passband with a low insertion loss and two absorption bands at both sides of the passband. A lossless and two lossy resonators are employed in the unit cell of the periodic structure to produce the passband and the absorption bands, respectively. Utilizing the techniques of stepped impedance resonator and capacitor loading, the thickness of the resonators is reduced. Moreover, the capacitor loading also frees the tuning of each resonant frequency of the lossy resonator, which facilitates the FSR design. The multiresonances of the lossy resonators are also employed to obtain a wide upper absorption band. An equivalent circuit model is established for understanding the operating principle. A prototype of the proposed FSR is fabricated and measured. Good agreement between measured and simulated results validates our FSR design.
- 7 June 2017
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 65 (8) , 4363-4367
3-D Frequency-Selective Rasorber With Wide Upper Absorption Band
This communication presents a 3-D frequency-selective rasorber (FSR) that has a passband with a low insertion loss and two absorption bands at both sides of the passband. A lossless and two lossy resonators are employed in the unit cell of the periodic structure to produce the passband and the absorption bands, respectively. Utilizing the techniques of stepped impedance resonator and capacitor loading, the thickness of the resonators is reduced. Moreover, the capacitor loading also frees the tuning of each resonant frequency of the lossy resonator, which facilitates the FSR design. The multiresonances of the lossy resonators are also employed to obtain a wide upper absorption band. An equivalent circuit model is established for understanding the operating principle. A prototype of the proposed FSR is fabricated and measured. Good agreement between measured and simulated results validates our FSR design.
- 25 June 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 63 (9) , 4156-4160
Broadband and Ultrathin Frequency-Dispersive Metamaterial Screen for Reflectivity Reduction
A frequency-dispersive magnetic material substrate is proposed to achieve the broad bandwidth of metamaterial screens for microwave absorption. Resonance-like ferrites with frequency-dispersive properties at resonant frequencies are applied as substrate. By mixing the multiple types of resonance-like ferrites, the desired bandwidth of frequency-dispersive magnetic material is further broadened. Simulated and measured results show that the proposed metamaterial screen can operate from 7.9 to 14.6 GHz with the reflectivity of less than -10 dB with thickness of only 1.1 mm (0.029 λr,). A figure of merit (FoM) proposed to evaluate the absorption performance of the screen is 20.6 for the proposed screen.
- 25 June 2015
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 63 (9) , 4156-4160
Broadband and Ultrathin Frequency-Dispersive Metamaterial Screen for Reflectivity Reduction
A frequency-dispersive magnetic material substrate is proposed to achieve the broad bandwidth of metamaterial screens for microwave absorption. Resonance-like ferrites with frequency-dispersive properties at resonant frequencies are applied as substrate. By mixing the multiple types of resonance-like ferrites, the desired bandwidth of frequency-dispersive magnetic material is further broadened. Simulated and measured results show that the proposed metamaterial screen can operate from 7.9 to 14.6 GHz with the reflectivity of less than -10 dB with thickness of only 1.1 mm (0.029 λr,). A figure of merit (FoM) proposed to evaluate the absorption performance of the screen is 20.6 for the proposed screen.