SLShu-Chen Lin

Shu-Chen Lin

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Shu-Chen Lin has a total of 9 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Wideband Pulse-Modulated Polar Transmitter With Low-Complexity Digital Predistortion

    by Shuo-Heng Xu, Chun-Wei Chang, Shu-Chen Lin, Jau-Horng Chen, Joseph Staudinger

    In this letter, a wide bandwidth power amplifier (PA) using pulse modulation is presented. Pulse modulation significantly reduces the amount of thermal memory. However, with a large signal bandwidth, significant matching-related memory effect exists. A compensation equalization filter is proposed to compensate the in-band gain/phase variation, such that simple memoryless digital predistortion (DPD) can still be utilized. A prototype transmitter system is constructed using a commercially available base station PA for validation. Measurements are performed using a 256-QAM fifth-generation new radio (5G NR) downlink multicarrier modulated signal at 3500 MHz with an instantaneous bandwidth of 100 MHz. Using memoryless DPD and the proposed filter, the overall system achieved passing the $-$ 45-dBc downlink spectral requirements for the 5G NR standard showing negligible thermal memory effect in PAs using pulse modulation.


  • Open Access

    A Digital Combining Applied to the Multilevel Pulse Modulated Polar Transmitter

    by Shuo-Heng Xu, Chun-Wei Chang, Yu-Chen Chang, Shu-Chen Lin, Jau-Horng Chen, Joseph Staudinger

    This paper presents a novel digital combining method to implement a multilevel pulse modulation polar transmitter (PMPT) for 5G NR base station applications. Using pulse-width modulation on switch mode power amplifiers (PAs) is a promising method for PA efficiency improvement. Whereas using the interleaved multilevel architecture can eliminate unwanted harmonics. Previous PMPT implementations used passive power combiners to combine multiple PA outputs, this paper proposes combining to be performed digitally prior to the PAs. It was shown the proposed method is no longer susceptible to PA mismatch and is highly suitable for Doherty power amplifiers (DPAs). A transmitter prototype was developed and evaluated with a 256-QAM 5G NR 20-MHz instantaneous bandwidth signal centered at 2140 MHz. The overall system achieved 39.4 dBm with a power-added efficiency of 39%. It passes the 5G NR adjacent channel leakage ratio (ACLR) downlink spectral requirement with only memoryless digital predistortion.


  • Efficient Interpolation Method for Wireless Communications and Signal Processing Applications

    by Shu-Chen Lin, Kevin Chuang, Chun-Wei Chang, Jau-Horng Chen

    Interpolation involves the process of estimating values at positions in between the adjacent samples, which has very fundamental and applied implications in signal processing and communication systems. In this work, a new method of cubic spline interpolation (CSI) is proposed and derived mathematically from the input samples respecting the time-domain boundary conditions, and the corresponding piecewise polynomials are optimized in the frequency domain to achieve good spectral properties. A comparative analysis of several prior arts, including arbitrary frequency response polynomial (AFRP) and basis spline (B-spline) is also presented, giving a clear overview of the advantages associated with the proposed technique in terms of implementation complexity, latency, and in-band and out-of-band spectral performance. The measurement results with three different radio frequency (RF) power amplifier (PA) prototypes using an input stimulus comprised of different instantaneous bandwidth (iBW) carrier aggregated 5G new radio (NR) waveform are demonstrated to highlight the improved performance in the context of digital predistortion (DPD) correction. Finally, the architecture of the proposed method is illustrated, which is suitable for real-time high-speed digital implementation.


  • A Pulse-Modulated Polar Transmitter Using Direct Digital Synthesis for 5G NR Mobile Applications

    by You-Huei Chen, Tzu-Han Wang, Shu-Chen Lin, Jau-Horng Chen, Yi-Jan Emery Chen

    This paper presents a pulse-modulated polar transmitter using direct digital synthesis (DDS) for 5G NR mobile phone applications. In contrast to the conventional radio-frequency transmitter that requires high-resolution digital-to-analog converters (DACs) to maintain signal fidelity, the proposed transmitter only needs high-speed but low-resolution DACs for DDS. A transmitter prototype was developed and tested with a 5G NR 20-MHz bandwidth signal at the carrier frequency of 836.5 MHz. The transmitter achieved the adjacent channel leakage ratio (ACLR) of -31.9 dBc using the 4 GS/s DACs with resolution of just 4 bits without the use of digital predistortion or other linearization techniques.