LPLuca Parmesan

Luca Parmesan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Luca Parmesan has a total of 39 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Fully Integrated Quantum Random Number Generator for Cryptographic Application

    by Nicola Massari, Luca Parmesan, Alessandro Tontini, Sonia Mazzucchi, Miloš Grujić, Ingrid Verbauwhede, Andreas Brenneis, Dayo Oshinubi, Ingo Herrmann, Thomas Strohm

    A compact quantum random number generator (QRNG) based on an array of Single Photon Avalanche Diodes (SPADs) is presented here. The main feature of the proposed chip is the capability to generate random numbers without the use of any external source of light. In this view, SPADs are configured to be used in two ways: 1) as a controlled light emitter and 2) as a detector. An embedded logic is able to distinguish dark events against detected emitted photon in such a way to make the system sensitive only to the presence of light. The extracted random bits show a uniform distribution and the QRNG, thanks to an integrated conditioning block maximizing the output entropy, eventually passes all AIS31 tests. The average raw bit rate in the default device configuration (one enabled column) is measured equal to 800 kbps.

  • Open Access

    Particam: a fully digital sensor for sub micron resolution

    by G. Casse, E. Ejopu, M. Gottardi, J. Hammerich, N. Massari, L. Parmesan

    While silicon industry advances to smaller and smaller feature sizes, silicon particle detectors struggle to follow that miniaturisation. One of the main bottlenecks are the relatively large transistors required for the optimal performance of the analogue frontend. Particam instead uses a digital-only approach which is focused on digital storage cells switching due to transient radiation (Single Event Upset (SEU)). Typically, great effort is expended to prevent SEUs from affecting the registers of any ASIC, but designs can also be optimised in the opposite way. With a pixel being little more than a memory cell it can be designed with close to minimum feature size with very few transistors allowing pixel pitches of a few microns. A proof-of-principle demonstrator with different pixel flavours with pitches ranging from 6.5 µm to 2 µm has been produced in the UMC 65 nm process. Test pulse measurements show the circuits work as intended, however the charge collection was found to be insufficient for most types of ionising radiation besides alpha particles. Results of this prototype are presented. Plans for further developments and possible applications are discussed.

  • A 500 × 500 Pixel Image Sensor With Multiple Regions of Interest for Center of Mass-Based Event Detection

    by Massimo Gottardi, Luca Parmesan, Pietro Tosato, Evgeny Demenev, Michela Lecca, Enrico Manuzzato, Leonardo Gasparini

    This manuscript reports on a 500 x 500 pixel CMOS vision sensor allowing multiple Regions of Interest (RoI) per frame with programmable and arbitrary number, size and shape, aimed at minimising the delivered data and at reducing the required amount of off-chip computation. In the proposed application, the Center of Mass (CoM) terms of the RoIs, computed by the sensor, are used to monitor the activity in some zones of the scene to switch the sensor to a pixel delivering mode, enabling high-level image processing upon request through an external processing platform. Anomalies are detected as changes in the x-y position of the CoM. The embedded CoM Processor (CoMP) extracts the centroid terms of the selected sub-windows, managing a maximum RoI size of 128 x 128 pixels. The parameters of each RoI are uploaded row-wise through a serial interface. The sensor with 8 μm pixel pitch is manufactured in a 110 nm 1P4M CMOS technology and occupies 25 mm 2 . The chip, operating in standard Imaging Mode (IM), consumes 4.9 mW at 20 fps.


  • A 500 × 500 Pixel Image Sensor with Arbitrary Number of RoIs per Frame and Image Filtering for Center of Mass Estimation

    by Massimo Gottardi, Luca Parmesan, Pietro Tosato, Evgeny Demenev, Enrico Manuzzato, Leonardo Gasparini

    This paper reports on a 500 x 500 pixel CMOS image sensor allowing multiple Regions of Interest (RoI) per frame with programmable number and size, aimed at minimizing the amount of data to be delivered off-chip and at reducing its power consumption. The proposed sensor architecture offers large flexibility to face different use case scenarios and it is suitable to any pixel array. The sensor embeds image background subtraction capability and integrates a computing layer which pre-filters the pixels to estimate the Center of Mass (CoM) of the RoIs up to a maximum size of 128 x 128 pixels. The 8 $\mu \mathrm{m}$ pixel sensor is manufactured in a 110 nm 1P4M CMOS technology and occupies 25 $\mathrm{m}\mathrm{m}^{2}$. The chip, operating in standard imaging mode, consumes 4.9 mW at 30 fps.


  • A novel fully digital particle detector with high spatial resolution

    by Matthiew Franks, Massari Nicola, Luca Parmesan, Gianluigi Casse

    In the presented paper we describe an innovative pixel topology designed for particle tracking. The proposed approach is based on a fully digital concept. When ionising particles traverse detector material, charges collected by the pixel are converted to a single bit to obtain a binary image. This digital approach allows a simplified pixel schematic to be used, reducing the pixel size to 2.5 μm × 2.5 μm and optimises the power consumption and the speed of the readout. An array of 256×256 pixels have been fabricated in a 65 nm standard CMOS technology as a proof of concept. Preliminary results on pixel performance are reported, demonstrating the potential of the approach.

  • Luximos: A 768×64 900-fps Tileable Pipelined X-Ray CMOS Image Sensor for Dental Imaging With 2.6 LSB/nGy Sensitivity

    by Nicola Massari, Hesong Xu, Alessandro Tarolli, Luca Parmesan, Daniele Perenzoni, Sabrina Colpo, Nicola Fronza, David Stoppa, Matteo Perenzoni, Alfredo Maglione

    In this paper a stitched array of 768x64 pixels for X-ray dental imaging is presented. The sensor architecture allows to increase the frame rate up to 900 fps thanks to a pipeline approach that minimizes the deadtime between consecutive frames. A column-based ADC converts pixel values in digital form while an external FPGA performs the operation of TDI accumulation, thus increasing the SNR. Internal programmable gain allows to achieve a maximum sensitivity of 2.6 LSB/nGy and, at the same time, to extend the dynamic range of the sensor in case of high intensity. The final system consists of two sensors each one having a size of 74.5x9 mm, assembled in a PCB and coupled with a high sensitive columnar thallium-doped cesium iodide (CsI(Tl)) scintillator for X-ray conversion. The sensor, fabricated in a standard CMOS 0.15 μm technology with stitching approach, shows a pixel size of 97 μm.


  • A 32 × 32-Pixel CMOS Imager for Quantum Optics With Per-SPAD TDC, 19.48% Fill-Factor in a 44.64-μm Pitch Reaching 1-MHz Observation Rate

    by Majid Zarghami, Leonardo Gasparini, Luca Parmesan, Manuel Moreno-Garcia, Andre Stefanov, Banz Bessire, Manuel Unternahrer, Matteo Perenzoni

    This article reports the design and characterization of a 32 x 32 single-photon avalanche diode (SPAD) time-resolved image sensor for quantum imaging applications fabricated in a 150-nm CMOS standard technology. A per-SPAD time-to-digital converter (TDC) records the spatial cross correlation functions of a flux of entangled photons. Each 44.64-μm pixel with 19.48% fill-factor features a 210.2-ps resolution, 50-ns (8-bit) range TDC with 1.28-LSB differential and 1.92-LSB integral nonlinearity (DNL/INL). The sensor achieves an observation rate of up to 1 MHz through a current-based mechanism that avoids reading empty frames when the photon rates are low. A row-skipping mechanism detects the absence of SPAD activity in a row to increase the duty cycle. These two features require only three transistors in each pixel. The sensor functionality is demonstrated in a quantum imaging experiment that achieves super-resolution.


  • Open Access

    A Simulation Model for Digital Silicon Photomultipliers

    by Salvatore Gnecchi, Neale A. W. Dutton, Luca Parmesan, Bruce R. Rae, Stuart J. McLeod, Sara Pellegrini, Lindsay A. Grant, Robert K. Henderson

    We propose a simulator model to estimate the performance of digital Silicon Photomultipliers (dSiPM) based on Single Photon Avalanche Diodes (SPADs) in terms of detection rate of photons incident on the sensor. The work provides guidelines for efficient array structure depending on: the number of SPADs, fill factor, area of both SPADs and array. A comparison of the main techniques present in the literature to digitally combine multiple outputs into single channel is included with simulated results showing promising higher detection rates for XOR-based dSiPMs. Mathematical expressions are derived to estimate dSiPM parameters such as maximum detection rate and detector dead time as functions of the mentioned design parameters.