Jiwajyoti Mahanta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jiwajyoti Mahanta has a total of 45 co-authors. Here are the top co-authors by number of shared publications:
- Dipankar Bandyopadhyay
Indian Institute of Technology Guwahati
8 shared publications - Prathu Raja Parmar
Indian Institute of Technology Guwahati
5 shared publications - Saurabh Dubey
Indian Institute of Technology Guwahati
3 shared publications Tapas Kumar Mandal
Department of Chemical Engineering, Indian Institute of Technology Guwahati, Guwahati 781039, India
3 shared publications- Yeshudan Bora
Department of Chemical Engineering Carnegie Mellon University Pittsburgh Pennsylvania USA
3 shared publications - Arindam Dutta
Department of Chemical Engineering, Indian Institute of Technology Guwahati, Guwahati, Assam 781039, India
2 shared publications
Latest Publications
- 11 August 2026
- Published by Wiley in Advanced Materials Technologies
- Vol. 11 (22)
Aerophobic Nanoscaffold‐Catalysts for Process‐Intensified Hydrogen Production in a Membraneless µ‐Fluidic Electrolyzer
NiFe‐LDH catalyst has been coated on NF using a simple room‐temperature electrodeposition method. Subsequently, a network of MWCNTs are dispersed on the surface of NiFe‐LDH to form an “aerophobic/hydrophillic” hybrid electrode NiFe‐LDH@CNT/NF, suitable for rapid synthesis as well as ejection of hydrogen bubbles inside a membraneless microfluidic electrolyzer. Electron microscopy and spectroscopic analysis demonstrate that interconnected nanosheets of NiFe‐LDH form uniformly over the entire substrate and that CNTs are uniformly distributed. The hybrid structure aids in improving the catalytic performance of the NiFe‐LDH/NF system, also enhancing electrical conductivity for better ion transport, hydrophilicity for better electrode–electrolyte contact and aerophobicity for faster hydrogen bubble ejection. These enhance the rate of detachment of hydrogen bubbles from the electrode. This combination ultimately yields improved kinetic behavior associated with ionic transport, faster evolution and increased hydrogen productivity. Detailed CV, XPS, and XRD analyses confirm the long‐term stability of Ni 2+ /Fe 3+ of such electrodes during hydrogen synthesis. Further, the electrolytic measurements on the electrodes indicate low overpotential, low charge transfer resistance (∼3 Ω), high current density and high Faradaic efficiency (∼90.02%). The proposed electrodes also attain much higher hydrogen production rate of ∼20 mmol h −1 cm −2 , demonstrating excellent kinetic behavior while showing extended durability.
- 11 August 2026
- Published by Wiley in Advanced Materials Technologies
- Vol. 11 (22)
Aerophobic Nanoscaffold‐Catalysts for Process‐Intensified Hydrogen Production in a Membraneless µ‐Fluidic Electrolyzer
NiFe‐LDH catalyst has been coated on NF using a simple room‐temperature electrodeposition method. Subsequently, a network of MWCNTs are dispersed on the surface of NiFe‐LDH to form an “aerophobic/hydrophillic” hybrid electrode NiFe‐LDH@CNT/NF, suitable for rapid synthesis as well as ejection of hydrogen bubbles inside a membraneless microfluidic electrolyzer. Electron microscopy and spectroscopic analysis demonstrate that interconnected nanosheets of NiFe‐LDH form uniformly over the entire substrate and that CNTs are uniformly distributed. The hybrid structure aids in improving the catalytic performance of the NiFe‐LDH/NF system, also enhancing electrical conductivity for better ion transport, hydrophilicity for better electrode–electrolyte contact and aerophobicity for faster hydrogen bubble ejection. These enhance the rate of detachment of hydrogen bubbles from the electrode. This combination ultimately yields improved kinetic behavior associated with ionic transport, faster evolution and increased hydrogen productivity. Detailed CV, XPS, and XRD analyses confirm the long‐term stability of Ni 2+ /Fe 3+ of such electrodes during hydrogen synthesis. Further, the electrolytic measurements on the electrodes indicate low overpotential, low charge transfer resistance (∼3 Ω), high current density and high Faradaic efficiency (∼90.02%). The proposed electrodes also attain much higher hydrogen production rate of ∼20 mmol h −1 cm −2 , demonstrating excellent kinetic behavior while showing extended durability.
- 9 February 2026
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 216
Nanostructured photoelectrodes for membraneless μ-fluidic H2 production
- 9 February 2026
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 216
Nanostructured photoelectrodes for membraneless μ-fluidic H2 production
- 20 November 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 7 (23) , 10539-10552
High-Performance Microdroplet Tribogenerator Stimulated by Coupled Photonic and Phononic Excitations
- 20 November 2025
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 7 (23) , 10539-10552
High-Performance Microdroplet Tribogenerator Stimulated by Coupled Photonic and Phononic Excitations
- 17 November 2025
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 49 (45) , 19843-19854
Hardwood-derived lignin as a tribo-positive filler in electrospun PVDF nanofibers for efficient triboelectric energy harvesting
Schematic illustration depicting the working mechanism of the hardwood-derived lignin as tribo-positive filler in electrospun PLNF-TENG for efficient triboelectric energy harvesting.
- 17 November 2025
- Published by Royal Society of Chemistry (RSC) in New Journal of Chemistry
- Vol. 49 (45) , 19843-19854
Hardwood-derived lignin as a tribo-positive filler in electrospun PVDF nanofibers for efficient triboelectric energy harvesting
Schematic illustration depicting the working mechanism of the hardwood-derived lignin as tribo-positive filler in electrospun PLNF-TENG for efficient triboelectric energy harvesting.
- 9 October 2025
- Published by IOP Publishing in Flexible and Printed Electronics
- Vol. 10 (4) , 045003
Nanofiber-based humidity sensor for non-invasive real-time breath analysis
We report the development of an ultrafast internet of things (IoT)-enabled humidity sensor using a nanofibrillar surface composed of cellulose and graphene oxide nanocomposite embedded with polyaniline and gold nanorods (Au NRs). The results uncover that, as compared to the conventional flat surface sensors, the usage of the physiochemically heterogeneous nanofiber surface embedded with Au NRs and conducting polymers elucidate excellent sensing linearity, fast response time, marginal hysteresis, and repeatability. In particular, the usage of the nanofibers escalates the surface to volume ratio of the sensor significantly to exhibit a remarkable sensitivity across a wide range of humidity levels leading to a variation in the voltage output progressively increasing from the ∼26 mV to ∼73 mV in the range of relative humidity (RH) from a very low (∼11%) to a very high (∼96%). With an optimal loading of Au NRs and conducting polymer, the nanofibrillar composite has also demonstrated the ability to monitor humidity in real-time within the 11%–96% range, with a response time of 45 s and a recovery time of 136 s. The results showed a linear range of 11%–96% RH, a sensitivity of 0.687 mV/%RH, and a limit of detection of 11% RH. Remarkably, during the experiments performed for the measurements of multiple humidity cycles in real-time, the sensor shows a very low relative standard deviation (∼1%). Integration of the IoT platform in the form of a WiFi module (ESP8266) with the proposed humidity-sensing unit enables real-time monitoring of the humidity levels, which can be suitable for point-of-care applications.
- 9 October 2025
- Published by IOP Publishing in Flexible and Printed Electronics
- Vol. 10 (4) , 045003
Nanofiber-based humidity sensor for non-invasive real-time breath analysis
We report the development of an ultrafast internet of things (IoT)-enabled humidity sensor using a nanofibrillar surface composed of cellulose and graphene oxide nanocomposite embedded with polyaniline and gold nanorods (Au NRs). The results uncover that, as compared to the conventional flat surface sensors, the usage of the physiochemically heterogeneous nanofiber surface embedded with Au NRs and conducting polymers elucidate excellent sensing linearity, fast response time, marginal hysteresis, and repeatability. In particular, the usage of the nanofibers escalates the surface to volume ratio of the sensor significantly to exhibit a remarkable sensitivity across a wide range of humidity levels leading to a variation in the voltage output progressively increasing from the ∼26 mV to ∼73 mV in the range of relative humidity (RH) from a very low (∼11%) to a very high (∼96%). With an optimal loading of Au NRs and conducting polymer, the nanofibrillar composite has also demonstrated the ability to monitor humidity in real-time within the 11%–96% range, with a response time of 45 s and a recovery time of 136 s. The results showed a linear range of 11%–96% RH, a sensitivity of 0.687 mV/%RH, and a limit of detection of 11% RH. Remarkably, during the experiments performed for the measurements of multiple humidity cycles in real-time, the sensor shows a very low relative standard deviation (∼1%). Integration of the IoT platform in the form of a WiFi module (ESP8266) with the proposed humidity-sensing unit enables real-time monitoring of the humidity levels, which can be suitable for point-of-care applications.
- 15 September 2025
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 8 (38) , 18604-18613
Lipase Detection Using a Nanostructured Graphitic-Carbon Nitride-Based Flexible Organic Field Effect Transistor
- 15 September 2025
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 8 (38) , 18604-18613
Lipase Detection Using a Nanostructured Graphitic-Carbon Nitride-Based Flexible Organic Field Effect Transistor
- 16 August 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (34) , 16242-16253
Sustainable Hydrogen Production via Plasmon-Enhanced Electro-oxidation: A Comparative Analysis of Ethanol and Methanol in a Solar-Assisted Microfluidic System
- 16 August 2025
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 39 (34) , 16242-16253
Sustainable Hydrogen Production via Plasmon-Enhanced Electro-oxidation: A Comparative Analysis of Ethanol and Methanol in a Solar-Assisted Microfluidic System
- 24 July 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (16) , 15701-15713
Nanoplasmonic Microfluidic Electrolyzer for Membraneless Hydrogen Production
- 24 July 2024
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 38 (16) , 15701-15713
Nanoplasmonic Microfluidic Electrolyzer for Membraneless Hydrogen Production
- 24 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Flexible Electronics
- Vol. 2 (6) , 457-463
Microdroplet Sensor for Point-of-Care-Testing of Glycemic Index Using Gold-Amylase Nanocomposite
Biosynthesis of gold-amylase nanocomposites (Au-Am-NC) has been achieved wherein the cysteine residues with thiol groups of α-amylase enzyme reduce the gold ions to engender metal-enzyme link. The Au-Am-NC, thus synthesized (~30 nm) could easily degrade the starch iodine (SI) complex generated, which eventually is translated into a prototype for the determination of the glycemic index (GI) of a starch source. In a way, in-situ hydrolysis of SI complex is achieved inside the droplet with the help of the Au-Am-NC, which breaks the α-1, 4 glycosidic bonds of the starch molecules to liberate iodine from helical SI complexes. Experiments uncover that the color intensity of the microdroplets decreases as the enzymatic activity of the nanocomposite increase. The variation in color intensity of droplet is correlated to the GI of various starch sources. Interestingly, an SI droplet of soluble starch shows more fading than wheat, corn, and waxy corn starch. The high branch density of waxy corn starch reduces the hydrolysis rate, showing less SI droplet color fading. The methodology has shown the potential to be translated into a biomedical device to determine the GI of various edible starch sources.
- 24 July 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Flexible Electronics
- Vol. 2 (6) , 457-463
Microdroplet Sensor for Point-of-Care-Testing of Glycemic Index Using Gold-Amylase Nanocomposite
Biosynthesis of gold-amylase nanocomposites (Au-Am-NC) has been achieved wherein the cysteine residues with thiol groups of α-amylase enzyme reduce the gold ions to engender metal-enzyme link. The Au-Am-NC, thus synthesized (~30 nm) could easily degrade the starch iodine (SI) complex generated, which eventually is translated into a prototype for the determination of the glycemic index (GI) of a starch source. In a way, in-situ hydrolysis of SI complex is achieved inside the droplet with the help of the Au-Am-NC, which breaks the α-1, 4 glycosidic bonds of the starch molecules to liberate iodine from helical SI complexes. Experiments uncover that the color intensity of the microdroplets decreases as the enzymatic activity of the nanocomposite increase. The variation in color intensity of droplet is correlated to the GI of various starch sources. Interestingly, an SI droplet of soluble starch shows more fading than wheat, corn, and waxy corn starch. The high branch density of waxy corn starch reduces the hydrolysis rate, showing less SI droplet color fading. The methodology has shown the potential to be translated into a biomedical device to determine the GI of various edible starch sources.
- 3 July 2023
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (28) , 10509-10519
Real-Time Monitoring of Glycemic Starch Using Biosynthesized Gold Nanoparticle–Amylase Composites
- 3 July 2023
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (28) , 10509-10519
Real-Time Monitoring of Glycemic Starch Using Biosynthesized Gold Nanoparticle–Amylase Composites