Haifeng Zhao has a total of 11 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Design of a Photoelectric Measuring Robot for Straightness of Deep/Blind Hole with Automatic Centering Function

    by Haifeng Zhao

    In order to quickly measure the straightness parameters of the deep hole/blind hole axis, a robot for measuring the straightness of the deep hole/blind hole axis based on the photoelectric prin-ciple is designed. Using the linearity of the las...


  • Open Access

    Simulation Analysis of Equibiaxial Tension Tests for Rubber-like Materials

    by Huaan Luo, Yinlong Zhu, Haifeng Zhao, Luqiang Ma, Jingjing Zhang

    For rubber-like materials, there are three popular methods of equibiaxial tension available: inflation tension, equibiaxial planar tension, and radial tension. However, no studies have addressed the accuracy and comparability of these tests. In this work, we model the tension tests for a hyperelastic electroactive polymer (EAP) membrane material using finite element method (FEM) and investigate their experimental accuracy. This study also analyzes the impact of apparatus structure parameters and specimen dimensions on experimental performances. Additionally, a tensile efficiency is proposed to assess non-uniform deformation in equibiaxial planar tension and radial tension tests. The sample points for calculating deformation in inflation tensions should be taken near the top of the inflated balloon to obtain a more accurate characteristic curve; the deformation simulation range will be constrained by the material model and its parameters within a specific limit (λ ≈ 1.9); if the inflation hole size is halved, the required air pressure must be doubled to maintain equivalent stress and strain values, resulting in a reduction in half in inflation height and decreased accuracy. The equibiaxial planar tension test can enhance uniform deformation and reduce stress errors to as low as 2.1% (at λ = 4) with single-corner-point tension. For circular diaphragm specimens in radial tension tests, increasing the number of cuts and using larger punched holes results in more uniform deformation and less stress error, with a minimum value of 3.83% achieved for a specimen with 24 cuts and a 5 mm punched hole. In terms of tensile efficiency, increasing the number of tensile points in the equibiaxial planar tension test can improve it; under radial tension, increasing the number of cuts and decreasing the diameter of the punched hole on the specimen has a hedging effect. The findings of this study are valuable for accurately evaluating various equibiaxial tension methods and analyzing their precision, as well as providing sound guidance for the effective design of testing apparatus and test plans.


  • Open Access

    Equibiaxial Planar Tension Test Method and the Simulation Analysis for Hyperelastic EAP Membrane

    by Huaan Luo, Yinlong Zhu, Haifeng Zhao, Luqiang Ma, Jingjing Zhang

    The equibiaxial planar tension test is an important method for determining the mechanical properties of hyperplastic membranes, and it is also critical to designing an effective equibiaxial tension test rig to meet experimental accuracy requirements. However, any analysis addressing the accuracy of this test is not reported in the literature. In this paper, an equibiaxial planar tension apparatus is proposed for conducting single-corner-point tension tests on hyperelastic electroactive polymer (EAP) membranes. The experimental data were compared with those obtained from two-corner-point-fixed tension tests and fitted with nonlinear material models, and the model’s parameters were also evaluated. Finally, the widely-used finite element software ABAQUS was employed to simulate equibiaxial planar tension methods and investigate the impact of clamping mode and point number on test accuracy as well as the uniformity of overall deformation. The test results indicate that the stress-strain curves for the two tensions remain consistent across small stretch ratios. However, as the stretch ratio increases (about ) in two-corner-point-fixed tension, stress shielding may lead to a degradation of strain uniformity and result in greater stresses than single-corner-point tension. Additionally, both the three-parameter Yeoh model and the four-parameter Ogden model can provide an accurate description of the EAP membrane material. The simulation results indicate that the axial strain variation amplitudes remain below 5% within a region spanning approximately 80% of the specimen’s overall length from its center to edge and even below 1% within a region spanning 85% in the single-corner-point tension; stress inaccuracies increase with stretch ratio, while the calculated error is about 2.1% when in the single-corner-point tension test, which has the smallest stress error among the tests; when the number of tension points is increased, the overall deformation becomes more sufficient, and the test accuracy improves as well. The conclusions drawn from this paper will be beneficial in designing equibiaxial planar tension test rigs and analyzing their accuracy and uniformity of deformation.


  • THE MAIN DIRECTIONS OF ENSURING THE ENVIRONMENTAL SAFETY OF WATER BODIES IN TRANSBOUNDARY BASINS

    by Zhatkanbaeva Ayzhan, Jangabulova Arаilym, Aydarkhanova Kulyash, Baimakhanova Dina, Zhao Haifeng

    The article is devoted to the analysis of priority areas of international cooperation in the field of ensuring environmental safety of transboundary water bodies. The authors of the article indicated such areas of environmental safety as: Water-energy problem of the Central Asian countries; impact of climate change on water; Aral ecological crisis and its consequences for the natural environment of the Central Asian region. The authors of the article made recommendations on eliminating the environmental problems of transboundary water bodies. It is proposed to sign fundamental documents on legal issues of water allocation and protection of transboundary rivers on the basis of international law and bring the problem of transboundary rivers to the level of the SCO and tripartite negotiations (Russia, Kazakhstan, China). The necessity of building joint hydropower facilities on transboundary rivers is substantiated. The authors propose to expand, improve and modernize the control network (gauging stations, etc.) in all river basins of Kazakhstan and China.

  • Open Access

    Анализ опыта Финляндии по вовлечению молодежи в политические вопросы

    by A.A. Tasbulatova, E.B. Zhatkanbayev, S.K. Atakhanova, Zhao Haifeng

    Казахстан является страной, которая взяла на себя обязательства по реализации норм Конвенции по защите прав человека. Сегодня проводится большой комплекс мероприятий по защите прав детей и обеспечению прав молодежи. Вместе с тем, по мнению автора и иных исследователей, многие вопросы не получили должной закрепления в законодательстве Казахстана и соответственно не реализованы должным образом. По мнению автора, именно в вопросах вовлечения молодежи в политическую жизнь страны Казахстану следует сделать большой шаг вперед. Анализ современного состояния молодежной политики показывает, что вся она, главным образом, направлена на решение социальных проблем молодежи. Однако, современное состояние дел, и прежде всего, в интересах государства, требует активно привлекать молодежь в решение вопросов регионального и национального уровня. В этой связи, авторы считают, что необходимо использовать опыт стран, наиболее продвинутых в исследуемом направлении. Финляндия является страной, заложившей основы постоянного диалога государства и молодежи. В статье проводится достаточно подробный анализ созданного механизма взаимодействия общества, государства и отдельно взятой личности. Исследование проведено посредством анализа законодательства Финляндии, которое обязывает образовательные учреждения, муниципалитеты и государственные органы воспринимать и учитывать мнения детей и молодежи при принятии решений. Проведено исследование выстроенного механизма взаимодействия, который охватывает все стадии роста детей и взросления молодежи. Данный опыт может быть использован для совершенствования молодежной политики Казахстана, которая требует серьезной доработки. Ключевые слова: дети, молодежь, права детей, политические права детей, молодежная политика.