Mohammad Zare
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Mohammad Zare has a total of 18 co-authors. Here are the top co-authors by number of shared publications:
- Fahime Arabi Aliabad
Department of Arid Lands Management, Faculty of Natural Resources and Desert Studies, Yazd University, Yazd, Iran
4 shared publications - Atefeh Jebali
Faculty of Natural Resource and Desert Studies, Yazd University, Yazd, Iran
2 shared publications - Ebrahim Ghaderpour
Department of Earth Sciences & CERI Research Centre, Sapienza University of Rome, P.le Aldo Moro, 5, 00185 Rome, Italy
2 shared publications - Hamid Reza Ghafarian Malamiri
Department of Geography, Yazd University, Yazd, Iran
2 shared publications Hamidreza Ghafarian Malamiri
Department of Remote Sensing, Yazd University, Yazd, Iran
2 shared publications- Negin Behnia
Department of Arid Lands Management, Faculty of Natural Resources, Yazd University, Yazd, Iran
2 shared publications
Latest Publications
- 8 July 2025
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 22 (13) , 12231-12244
Application of machine learning approach in zoning of desert geomorphological facies
- 8 July 2025
- Published by Springer Nature in International Journal of Environmental Science and Technology
- Vol. 22 (13) , 12231-12244
Application of machine learning approach in zoning of desert geomorphological facies
- Open Access
- 25 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 44858-44872
A Comparative Study of Estimating Hourly Images of MODIS Land Surface Temperature Using Diurnal Temperature Cycle Models in Arid Regions
Thermal monitoring of different regions is usually limited to meteorological data in ground stations. Meteorological networks are limited in arid and semi-arid areas, where monitoring climatic conditions is not possible. The aim of this study is to estimate the land surface temperature (LST) hourly for Yazd-Ardakan plain by modeling the diurnal temperature cycle (DTC) using LST imagery of moderate resolution imaging spectroradiometer (MODIS). First, MODIS imagery are reconstructed using the multi-channel singular spectrum analysis, and the complete time series without missing values are created. Then, six DTC models are compared. The accuracy of DTC models is examined by ground LST measurements, air temperature, humidity, and wind speed. In addition, the results of examining the root mean square error (RMSE) images obtained from cross-validation based on MODIS LST imagery show that DTC2 has the highest error, where 73% of the area has RMSE greater than 3°C. In DTC1 and DTC2, 64% and 5.8% of the study region has RMSE less than 2°C. In general, DTC1, DTC6, DTC5, DTC4, DTC3, and DTC2 models have shown the highest to lowest accuracy in modeling the LST diurnal cycle. In addition, the difference between LST in mountain and plain lands is greater at the time of maximum temperature than at other hours of the day and night. The findings of this research are crucial in studies concerning climate change and land environmental monitoring in arid/semi-arid regions.
- 25 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 44858-44872
Open AccessA Comparative Study of Estimating Hourly Images of MODIS Land Surface Temperature Using Diurnal Temperature Cycle Models in Arid Regions
Thermal monitoring of different regions is usually limited to meteorological data in ground stations. Meteorological networks are limited in arid and semi-arid areas, where monitoring climatic conditions is not possible. The aim of this study is to estimate the land surface temperature (LST) hourly for Yazd-Ardakan plain by modeling the diurnal temperature cycle (DTC) using LST imagery of moderate resolution imaging spectroradiometer (MODIS). First, MODIS imagery are reconstructed using the multi-channel singular spectrum analysis, and the complete time series without missing values are created. Then, six DTC models are compared. The accuracy of DTC models is examined by ground LST measurements, air temperature, humidity, and wind speed. In addition, the results of examining the root mean square error (RMSE) images obtained from cross-validation based on MODIS LST imagery show that DTC2 has the highest error, where 73% of the area has RMSE greater than 3°C. In DTC1 and DTC2, 64% and 5.8% of the study region has RMSE less than 2°C. In general, DTC1, DTC6, DTC5, DTC4, DTC3, and DTC2 models have shown the highest to lowest accuracy in modeling the LST diurnal cycle. In addition, the difference between LST in mountain and plain lands is greater at the time of maximum temperature than at other hours of the day and night. The findings of this research are crucial in studies concerning climate change and land environmental monitoring in arid/semi-arid regions.
- Open Access
- 21 October 2023
- Published by MDPI AG in Atmosphere
- Vol. 14 (10) , 1589
Improving the Accuracy of Landsat 8 Land Surface Temperature in Arid Regions by MODIS Water Vapor Imagery
Land surface temperature (LST) is a significant environmental factor in many studies. LST estimation methods require various parameters, such as emissivity, temperature, atmospheric transmittance and water vapor. Uncertainty in these parameters can cause error in LST estimation. The present study shows how the moderate resolution imaging spectroradiometer (MODIS) water vapor imagery can improve the accuracy of Landsat 8 LST in different land covers of arid regions of Yazd province in Iran. For this purpose, water vapor variation is analyzed for different land covers within different seasons. Validation is performed using T-based and cross-validation methods. The image of atmospheric water vapor is estimated using the MODIS sensor, and its changes are investigated in different land covers. The bare lands and sparse vegetation show the highest and lowest accuracy levels for T-based validation, respectively. The root mean square error (RMSE) is also calculated as 0.57 °C and 1.41 °C for the improved and general split-window (SW) algorithms, respectively. The cross-validation results show that the use of the MODIS water vapor imagery in the SW algorithm leads to a reduction of about 2.2% in the area where the RMSE group is above 5 °C.
- 21 October 2023
- Published by MDPI AG in Atmosphere
- Vol. 14 (10) , 1589
Open AccessImproving the Accuracy of Landsat 8 Land Surface Temperature in Arid Regions by MODIS Water Vapor Imagery
Land surface temperature (LST) is a significant environmental factor in many studies. LST estimation methods require various parameters, such as emissivity, temperature, atmospheric transmittance and water vapor. Uncertainty in these parameters can cause error in LST estimation. The present study shows how the moderate resolution imaging spectroradiometer (MODIS) water vapor imagery can improve the accuracy of Landsat 8 LST in different land covers of arid regions of Yazd province in Iran. For this purpose, water vapor variation is analyzed for different land covers within different seasons. Validation is performed using T-based and cross-validation methods. The image of atmospheric water vapor is estimated using the MODIS sensor, and its changes are investigated in different land covers. The bare lands and sparse vegetation show the highest and lowest accuracy levels for T-based validation, respectively. The root mean square error (RMSE) is also calculated as 0.57 °C and 1.41 °C for the improved and general split-window (SW) algorithms, respectively. The cross-validation results show that the use of the MODIS water vapor imagery in the SW algorithm leads to a reduction of about 2.2% in the area where the RMSE group is above 5 °C.
- 31 January 2022
- Published by Springer Nature in Earth Science Informatics
- Vol. 15 (1) , 473-484
An inter-comparison of different PSO-optimized artificial intelligence algorithms for thermal-based soil moisture retrieval
- 31 January 2022
- Published by Springer Nature in Earth Science Informatics
- Vol. 15 (1) , 473-484
An inter-comparison of different PSO-optimized artificial intelligence algorithms for thermal-based soil moisture retrieval
- 13 October 2021
- Published by Taylor & Francis in GIScience & Remote Sensing
- Vol. 58 (8) , 1369-1394
A new threshold free dust storm detection index based on MODIS reflectance and thermal bands
Wind and soil confrontation under specific atmospheric conditions leads to the horrendous phenomenon of dust storms, particularly in arid lands. The negative impact of storms on the health and life of living beings is evident, resulting in many losses in the economic, social, and environmental sectors. Dust storm detection is the most important topic in dust studies, where many algorithms and indices have already been proposed using satellite imageries and remote sensing techniques. Despite the advantage of dust detection, these algorithms present drawbacks. This includes the need to determine different thresholds for different regional events or simply better respond to oceanic dust storms. The objective of this study is to develop a new Dust Storm Detection Index, called DSDI, without the need to determine different thresholds for each event. To establish the new index, it was necessary to distinguish the properties of dust, clouds, and land surfaces in the images of the MODIS sensors. These properties have been characterized by analyzing their spectral and thermal profiles at different wavelengths during dust storms from 2004 to 2009 in Yazd province, Central Iran, which is constantly coping with severe storms. Spectral and thermal ranges of 0.46, 0.56, 3.9, 1.4, 11, 12, and 13.6 μm were the most suitable discriminating bands of dust from the cloud and land surfaces. The brightness temperature difference of the thermal bands and the spectral ratio of reflectance bands, i.e. DSDI, has developed an appropriate relationship for separating land surfaces and clouds of dust particles. There was a significant correlation between DSDI and horizontal visibility (P-value= 0.05 & 0.01). It confirmed the success of this algorithm to detect storms in the study area, as an arid land.
- 13 October 2021
- Published by Taylor & Francis in GIScience & Remote Sensing
- Vol. 58 (8) , 1369-1394
A new threshold free dust storm detection index based on MODIS reflectance and thermal bands
Wind and soil confrontation under specific atmospheric conditions leads to the horrendous phenomenon of dust storms, particularly in arid lands. The negative impact of storms on the health and life of living beings is evident, resulting in many losses in the economic, social, and environmental sectors. Dust storm detection is the most important topic in dust studies, where many algorithms and indices have already been proposed using satellite imageries and remote sensing techniques. Despite the advantage of dust detection, these algorithms present drawbacks. This includes the need to determine different thresholds for different regional events or simply better respond to oceanic dust storms. The objective of this study is to develop a new Dust Storm Detection Index, called DSDI, without the need to determine different thresholds for each event. To establish the new index, it was necessary to distinguish the properties of dust, clouds, and land surfaces in the images of the MODIS sensors. These properties have been characterized by analyzing their spectral and thermal profiles at different wavelengths during dust storms from 2004 to 2009 in Yazd province, Central Iran, which is constantly coping with severe storms. Spectral and thermal ranges of 0.46, 0.56, 3.9, 1.4, 11, 12, and 13.6 μm were the most suitable discriminating bands of dust from the cloud and land surfaces. The brightness temperature difference of the thermal bands and the spectral ratio of reflectance bands, i.e. DSDI, has developed an appropriate relationship for separating land surfaces and clouds of dust particles. There was a significant correlation between DSDI and horizontal visibility (P-value= 0.05 & 0.01). It confirmed the success of this algorithm to detect storms in the study area, as an arid land.
- 11 April 2021
- Published by Springer Nature in Natural Hazards
- Vol. 108 (1) , 1221-1235
Detection of areas prone to wind erosion and air pollution using DSI and PDSI indices
- 11 April 2021
- Published by Springer Nature in Natural Hazards
- Vol. 108 (1) , 1221-1235
Detection of areas prone to wind erosion and air pollution using DSI and PDSI indices
- 21 October 2020
- Published by Springer Nature in Modeling Earth Systems and Environment
- Vol. 7 (4) , 2267-2281
A comparative assessment of the accuracies of split-window algorithms for retrieving of land surface temperature using Landsat 8 data
- 21 October 2020
- Published by Springer Nature in Modeling Earth Systems and Environment
- Vol. 7 (4) , 2267-2281
A comparative assessment of the accuracies of split-window algorithms for retrieving of land surface temperature using Landsat 8 data
- 28 October 2018
- Published by Springer Nature in Journal of the Indian Society of Remote Sensing
- Vol. 47 (1) , 45-52
Assessment of Land Cover Changes Using Taguchi-Based Optimized SVM Classification Approach
- 28 October 2018
- Published by Springer Nature in Journal of the Indian Society of Remote Sensing
- Vol. 47 (1) , 45-52
Assessment of Land Cover Changes Using Taguchi-Based Optimized SVM Classification Approach