Wendy A. Jonkers
Research Subjects
Wendy A. Jonkers has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Wiebe Matthijs de Vos
Department of Membrane Science and Technology, University of Twente, Enschede, Netherlands
7 shared publications - Esra Te Brinke
Department of Membrane Science and Technology, MESA+ institute for nanotechnology
3 shared publications Jurjen A. Regenspurg
2 shared publications- Alette A. M. Langenhoff
Environmental Technology Department, Wageningen University, P.O. Box 17, 6700 AA Wageningen, The Netherlands
1 shared publication - Anna M. C. Maan
Polymer Science, Zernike Institute for Advanced Materials, University of Groningen, Nijenborgh 4, 9747 AG Groningen, The Netherlands
1 shared publication - Antonius Josephus Bernardus Kemperman
Membrane Science & Technology, Mesa+ Institute for Nanotechnology, University of Twente, P.O. Box 217, 7500 AE Enschede, The Netherlands
1 shared publication
Latest Publications
- Open Access
- 27 March 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (14) , 21725-21735
Highly Selective Polyelectrolyte Multilayer Membranes Through Hydrophobic Interactions
Polyelectrolyte multilayer (PEM) membranes are highly promising for the removal of organic micropollutants (OMPs) from wastewater. However, for the removal of small OMPs, dense membranes with a low molecular weight cutoff (MWCO) are required. It has been recently demonstrated that MWCO correlates with PEM swelling by water. We therefore propose that dense membranes could be fabricated by enhancing hydrophobic interactions to decrease swelling. Controlled synthesis of hydrophobic polycations was achieved by quaternization of poly(4-vinylpiridine) (P4VP) with alkyl chains of varying length, which will also enhance its chemical stability. Optical reflectometry shows that multilayers can be successfully grown with the quaternized P4VPs (QP4VPs) and poly(styrenesulfonate) (PSS). Permeability and MWCO tests demonstrate that the membrane density can indeed be increased by increasing the length of the alkyl chain. Polycation terminated membranes are denser than polyanion membranes, likely due to the higher ratio of hydrophobic polycation. Propyl-QP4VP/PSS membranes have a MWCO as low as 230 Da. In line with the MWCO, OMP retention increases with increasing alkyl chain length. The QP4VP membranes studied here outperform commonly used poly(diallyldimethylammonium chloride) PDADMAC/PSS membranes in selectivity and are made with more chemically stable polyelectrolytes than other dense PEM membranes. The presented research confirms that PEM density correlates with hydrophobicity, and that PEM membranes can be densified through the addition of alkyl chains.
- 27 March 2025
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 17 (14) , 21725-21735
Open AccessHighly Selective Polyelectrolyte Multilayer Membranes Through Hydrophobic Interactions
Polyelectrolyte multilayer (PEM) membranes are highly promising for the removal of organic micropollutants (OMPs) from wastewater. However, for the removal of small OMPs, dense membranes with a low molecular weight cutoff (MWCO) are required. It has been recently demonstrated that MWCO correlates with PEM swelling by water. We therefore propose that dense membranes could be fabricated by enhancing hydrophobic interactions to decrease swelling. Controlled synthesis of hydrophobic polycations was achieved by quaternization of poly(4-vinylpiridine) (P4VP) with alkyl chains of varying length, which will also enhance its chemical stability. Optical reflectometry shows that multilayers can be successfully grown with the quaternized P4VPs (QP4VPs) and poly(styrenesulfonate) (PSS). Permeability and MWCO tests demonstrate that the membrane density can indeed be increased by increasing the length of the alkyl chain. Polycation terminated membranes are denser than polyanion membranes, likely due to the higher ratio of hydrophobic polycation. Propyl-QP4VP/PSS membranes have a MWCO as low as 230 Da. In line with the MWCO, OMP retention increases with increasing alkyl chain length. The QP4VP membranes studied here outperform commonly used poly(diallyldimethylammonium chloride) PDADMAC/PSS membranes in selectivity and are made with more chemically stable polyelectrolytes than other dense PEM membranes. The presented research confirms that PEM density correlates with hydrophobicity, and that PEM membranes can be densified through the addition of alkyl chains.
- Open Access
- 2 January 2025
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 5 (1) , 284-299
Membrane Concentrate Recirculation to Activated Sludge: Balancing Organic Micropollutant Removal and Salt Retention
- 2 January 2025
- Published by American Chemical Society (ACS) in ACS ES&T Water
- Vol. 5 (1) , 284-299
Open AccessMembrane Concentrate Recirculation to Activated Sludge: Balancing Organic Micropollutant Removal and Salt Retention
- Open Access
- 10 August 2024
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (16) , 9806-9816
From Brush to Barrier: Fine-Tuning Donnan Exclusion in Polyelectrolyte Multilayer Membranes with Polymer Brushes
- 10 August 2024
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 6 (16) , 9806-9816
Open AccessFrom Brush to Barrier: Fine-Tuning Donnan Exclusion in Polyelectrolyte Multilayer Membranes with Polymer Brushes
- Open Access
- 1 May 2024
- Published by Elsevier in Desalination
- Vol. 583, 117693
Polyelectrolyte multilayer membranes: An experimental review
- 1 May 2024
- Published by Elsevier in Desalination
- Vol. 583, 117693
Open AccessPolyelectrolyte multilayer membranes: An experimental review
- Open Access
- 24 February 2024
- Published by Elsevier in Journal of Membrane Science
- Vol. 698
Asymmetric polyelectrolyte multilayer membranes: Influence of bottom section polycation on layer growth and retention mechanisms
- 24 February 2024
- Published by Elsevier in Journal of Membrane Science
- Vol. 698
Open AccessAsymmetric polyelectrolyte multilayer membranes: Influence of bottom section polycation on layer growth and retention mechanisms
- Open Access
- 28 September 2023
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 5 (10) , 8547-8558
All-Lignin Polyelectrolyte Multilayers as Renewable and Biodegradable Nanofiltration Membranes
- 28 September 2023
- Published by American Chemical Society (ACS) in ACS Applied Polymer Materials
- Vol. 5 (10) , 8547-8558
Open AccessAll-Lignin Polyelectrolyte Multilayers as Renewable and Biodegradable Nanofiltration Membranes
- Open Access
- 10 December 2022
- Published by Elsevier in Journal of Membrane Science
- Vol. 669
Hollow fiber nanofiltration: From lab-scale research to full-scale applications
- 10 December 2022
- Published by Elsevier in Journal of Membrane Science
- Vol. 669
Open AccessHollow fiber nanofiltration: From lab-scale research to full-scale applications
- Open Access
- 30 July 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (48) , 27101-27110
Elucidating the mechanism behind the laccase-mediated modification of poly(ethersulfone)
Laccase-mediated oligomerisation of 4-hydroxybenzoic acid (4-HBA) derivatives and simultaneous in situ surface modification has proven to be a cost-effective, easily applicable and eco-friendly strategy for preventing biofouling of poly(ethersulfone) (PES) water filtration membranes. Modification of the membrane surface has previously been hypothesised to occur through covalent bonding of enzymatically generated phenolic radicals to the polymeric membrane. The current study shows, however, that in situ formation of soluble phenolic oligomers does not result in covalent membrane modification. We studied in situ laccase-mediated oligomerisation of custom-synthesised positively charged and commercially available negatively charged monomeric phenols, and demonstrated that their mode of binding to PES is not covalent. In addition, soluble, non-soluble and on-resin PES model compounds were synthesised and used in the laccase-mediated oligomerisation of 4-HBA. Covalent bond formation between these model compounds and (oligomeric) 4-HBA could not be observed either. Furthermore, extensive washing of PES membranes modified through laccase-mediated oligomerisation of 4-HBA resulted in substantial discolouration of the membrane surface, showing that the layer of oligomerised phenolics could easily be removed. Altogether, it was concluded that laccase-assisted modification of PES membranes resulted from strong physical adsorption of phenolic oligomers and polymers rather than from covalent bonding of those.
- 30 July 2018
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (48) , 27101-27110
Open AccessElucidating the mechanism behind the laccase-mediated modification of poly(ethersulfone)
Laccase-mediated oligomerisation of 4-hydroxybenzoic acid (4-HBA) derivatives and simultaneous in situ surface modification has proven to be a cost-effective, easily applicable and eco-friendly strategy for preventing biofouling of poly(ethersulfone) (PES) water filtration membranes. Modification of the membrane surface has previously been hypothesised to occur through covalent bonding of enzymatically generated phenolic radicals to the polymeric membrane. The current study shows, however, that in situ formation of soluble phenolic oligomers does not result in covalent membrane modification. We studied in situ laccase-mediated oligomerisation of custom-synthesised positively charged and commercially available negatively charged monomeric phenols, and demonstrated that their mode of binding to PES is not covalent. In addition, soluble, non-soluble and on-resin PES model compounds were synthesised and used in the laccase-mediated oligomerisation of 4-HBA. Covalent bond formation between these model compounds and (oligomeric) 4-HBA could not be observed either. Furthermore, extensive washing of PES membranes modified through laccase-mediated oligomerisation of 4-HBA resulted in substantial discolouration of the membrane surface, showing that the layer of oligomerised phenolics could easily be removed. Altogether, it was concluded that laccase-assisted modification of PES membranes resulted from strong physical adsorption of phenolic oligomers and polymers rather than from covalent bonding of those.