Ilya Kolmanovsky
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ilya Kolmanovsky has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Jing Sun
Department of Naval Architecture and Marine Engineering, University of Michigan, Ann Arbor, MI, USA
5 shared publications - Alberto Bemporad
Dipartimento di Ingegneria dell'Informazione, Università di Siena, Italy
4 shared publications - Davor Hrovat
Research and Innovation Center
3 shared publications - Reza Ghaemi
Department of Electrical Engineering and Computer Science, Department of Naval Architecture and Marine Engineering, University of Michigan, Ann Arbor, MI 48109
3 shared publications - Diana Yanakiev
Powertrain Control R&A, Ford Motor Company
2 shared publications Irina F. Sivergina
Department of Science and Mathematics, Kettering University, Flint, MI 48504-4898
2 shared publications
Latest Publications
- 1 January 2010
- Published by Springer Nature
- p. 183-194
Model Predictive Powertrain Control: An Application to Idle Speed Regulation
- 1 January 2010
- Published by Springer Nature
- p. 183-194
Model Predictive Powertrain Control: An Application to Idle Speed Regulation
- 28 January 2009
- Published by Springer Nature
- p. 55-92
Developments in Control of Time-Delay Systems for Automotive Powertrain Applications
- 28 January 2009
- Published by Springer Nature
- p. 55-92
Developments in Control of Time-Delay Systems for Automotive Powertrain Applications
- 1 January 2009
- Published by Elsevier in IFAC Proceedings Volumes
- Vol. 42 (14) , 90-95
Model predictive control for automotive time-delay processes: An application to air-to-fuel ratio control*
- 1 January 2009
- Published by Elsevier in IFAC Proceedings Volumes
- Vol. 42 (14) , 90-95
Model predictive control for automotive time-delay processes: An application to air-to-fuel ratio control*
- 22 October 2008
- Published by Wiley in Asian Journal of Control
- Vol. 8 (3) , 199-209
An Integrated Software Environment For Powertrain Feasibility Assessment Using Optimization And Optimal Control
- 22 October 2008
- Published by Wiley in Asian Journal of Control
- Vol. 8 (3) , 199-209
An Integrated Software Environment For Powertrain Feasibility Assessment Using Optimization And Optimal Control
- 1 January 2008
- Published by Elsevier in IFAC Proceedings Volumes
- Vol. 41 (2) , 1454-1459
Overcoming Singularity and Degeneracy in Neighboring Extremal Solutions of Discrete-Time Optimal Control Problem with Mixed Input-State Constraints
- 1 January 2008
- Published by Elsevier in IFAC Proceedings Volumes
- Vol. 41 (2) , 1454-1459
Overcoming Singularity and Degeneracy in Neighboring Extremal Solutions of Discrete-Time Optimal Control Problem with Mixed Input-State Constraints
- 1 December 2007
- Published by Elsevier in Automatica
- Vol. 43 (12) , 2060-2069
On-line identification of SISO linear time-invariant delay systems from output measurements
- 1 December 2007
- Published by Elsevier in Automatica
- Vol. 43 (12) , 2060-2069
On-line identification of SISO linear time-invariant delay systems from output measurements
- 1 October 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 19 (10851992) , 1388-1393
Sensitivity Equations Based Experiment Design and Adaptive Compensation of Transient Fuel Dynamics in Port-Fuel Injection Engines
In this paper we consider and address two topics relevant to calibration of parameters in transient fuel compensation algorithms. The first topic concerns the optimal selection of transient trajectories over which data are collected and identification of parameters in transient fuel model, the inverse of which constitutes a transient fuel compensation algorithm, is performed. We show that this problem can be formulated as an optimal control problem, and that this optimal control problem can berobust solved numerically. Even with the optimal transient trajectories, our results highlight a difficulty in identifying parameters in a transient fuel model if parameters in the model of exhaust gas mixing and in the model of the universal exhaust gas oxygen (UEGO) sensor are uncertain. The second topic addresses this difficulty through the use of adaptation to adjust parameters in a transient fuel compensation algorithm, until the deviation of measured fuel-to-air ratio from the commanded fuel-to-air ratio is sufficiently reduced. Our adaptation approach is shown to be robust to uncertainties in UEGO sensor and exhaust mixing dynamics. The theme common to both developments is the use of differential sensitivity equations.
- 1 October 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 19 (10851992) , 1388-1393
Sensitivity Equations Based Experiment Design and Adaptive Compensation of Transient Fuel Dynamics in Port-Fuel Injection Engines
In this paper we consider and address two topics relevant to calibration of parameters in transient fuel compensation algorithms. The first topic concerns the optimal selection of transient trajectories over which data are collected and identification of parameters in transient fuel model, the inverse of which constitutes a transient fuel compensation algorithm, is performed. We show that this problem can be formulated as an optimal control problem, and that this optimal control problem can berobust solved numerically. Even with the optimal transient trajectories, our results highlight a difficulty in identifying parameters in a transient fuel model if parameters in the model of exhaust gas mixing and in the model of the universal exhaust gas oxygen (UEGO) sensor are uncertain. The second topic addresses this difficulty through the use of adaptation to adjust parameters in a transient fuel compensation algorithm, until the deviation of measured fuel-to-air ratio from the commanded fuel-to-air ratio is sufficiently reduced. Our adaptation approach is shown to be robust to uncertainties in UEGO sensor and exhaust mixing dynamics. The theme common to both developments is the use of differential sensitivity equations.
- 1 July 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in American Control Conference (ACC)
- No. 07431619,p. 3700-3705
Adaptive Idle Speed Control for Internal Combustion Engines
The paper presents an application of a recently developed adaptive posicast controller for time-delay systems to the idle speed control (ISC) problem in internal combustion (IC) engines. The objective is to regulate the engine speed at a prescribed set-point in the presence of accessory load torque disturbances such as air conditioning and power steering. The adaptive controller, integrated with the existing proportional spark controller, is used to drive the electronic throttle as an actuator. We present both simulation and experimental results which demonstrate the potential of the adaptive controller to improve the performance. In addition, the reduction in calibration time and effort which can be achieved with our approach is discussed.
- 1 July 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in American Control Conference (ACC)
- No. 07431619,p. 3700-3705
Adaptive Idle Speed Control for Internal Combustion Engines
The paper presents an application of a recently developed adaptive posicast controller for time-delay systems to the idle speed control (ISC) problem in internal combustion (IC) engines. The objective is to regulate the engine speed at a prescribed set-point in the presence of accessory load torque disturbances such as air conditioning and power steering. The adaptive controller, integrated with the existing proportional spark controller, is used to drive the electronic throttle as an actuator. We present both simulation and experimental results which demonstrate the potential of the adaptive controller to improve the performance. In addition, the reduction in calibration time and effort which can be achieved with our approach is discussed.
- 1 July 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in American Control Conference (ACC)
- No. 07431619,p. 1377-1382
Optimal Control of Switched Homogeneous Systems
In this paper, we present a method for designing discrete-time state-feedback controllers for a class of continuous-time switched homogeneous systems which includes switched linear systems as a special case. A discrete-time approximate value iteration over a quantization of the unit sphere is used to compute an approximation of the continuous-time value function over the entire unbounded state space. Properties of the value function and its approximations are elicited and used to provide conditions under which state- feedback controllers with provable guarantees in stability and performance can be constructed. To illustrate the results, the methodology is applied to an example switched system possessing two unstable modes, one of which is nonlinear.
- 1 July 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE) in American Control Conference (ACC)
- No. 07431619,p. 1377-1382
Optimal Control of Switched Homogeneous Systems
In this paper, we present a method for designing discrete-time state-feedback controllers for a class of continuous-time switched homogeneous systems which includes switched linear systems as a special case. A discrete-time approximate value iteration over a quantization of the unit sphere is used to compute an approximation of the continuous-time value function over the entire unbounded state space. Properties of the value function and its approximations are elicited and used to provide conditions under which state- feedback controllers with provable guarantees in stability and performance can be constructed. To illustrate the results, the methodology is applied to an example switched system possessing two unstable modes, one of which is nonlinear.
- 1 July 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 07431619,p. 3757-3762
Model Predictive Control for Constrained Discrete Time Systems: An Optimal Perturbation Analysis Approach
In the paper we consider a model predictive control (MPC) strategy based on approximating the MPC optimal control solution by a nominal solution (either pre-computed in advance on-line or computed off-line) and a perturbation solution, which is easily computable and corrects the nominal solution. Unlike similar approaches in prior literature (see e.g., (A.E. Bryson and Y. Ho, 1975), (F.L. Lewis, 1986)), our approach is capable of enforcing piecewise state and control constraints. We describe how the basic approach can be integrated within the framework of forecasting MPC (FMPC) and illustrate its effectiveness by means of an example.
- 1 July 2007
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 07431619,p. 3757-3762
Model Predictive Control for Constrained Discrete Time Systems: An Optimal Perturbation Analysis Approach
In the paper we consider a model predictive control (MPC) strategy based on approximating the MPC optimal control solution by a nominal solution (either pre-computed in advance on-line or computed off-line) and a perturbation solution, which is easily computable and corrects the nominal solution. Unlike similar approaches in prior literature (see e.g., (A.E. Bryson and Y. Ho, 1975), (F.L. Lewis, 1986)), our approach is capable of enforcing piecewise state and control constraints. We describe how the basic approach can be integrated within the framework of forecasting MPC (FMPC) and illustrate its effectiveness by means of an example.