XXXiwang Xu

Xiwang Xu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Xiwang Xu has a total of 42 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Experimental investigation on the influence of herringbone riblets on the incident shock/turbulent boundary layer interactions

    by Xiwang Xu, Zihao Ye, Juncan Lin, Lin He

    Shock/turbulent boundary layer interactions (STBLIs) seriously affect the structural safety and aerodynamic performance of supersonic/hypersonic engine inlets. Herringbone riblet (HR) is a promising passive flow control device, yet its influence on the incident STBLI remains unclear. In this paper, the influences are experimentally investigated in a Mach 3.4 wind tunnel. The results indicate that under the incident shock-induced adverse pressure gradient, HRs disrupt the smooth separation structure, yielding spanwise-varying separation zones. At the convergence line, the separation zone enlarges and shifts upstream, accompanied by an intensified near-wall recirculation within it and enhanced downward flow above its rear half. At the divergence line, sunken HRs reduce the size of the separation zone, whereas the protruding HRs slightly expand it. These topological changes within and downstream of the separation zone impart spanwise variations to the local compression waves, which in turn yields the separation shock with both spanwise variations and heightened unsteadiness. Compared with the sunken configuration, protruding HRs induce stronger spanwise variations in the boundary layer and shock-induced separation zone, along with greater dispersion of the separation shock. Furthermore, spectral proper orthogonal decomposition results suggest that without shock incidence, both HR configurations shift the pulsating energy of the turbulent boundary layer from low to high frequencies. With shock incidence, protruding HRs sustain low-frequency pulsations, whereas sunken HRs lead to a more uniform energy distribution. In both cases, the HRs extract energy from the mean flow and channel it into specific modal ranges depending on the background flow conditions.

  • Experimental investigation on the hypersonic boundary layer transition induced by side-by-side cylinders

    by Xiwang Xu, Zihao Ye, Shihe Yi, Yufa Hu, Lican Wang

    The flow-field structure and heat-flux distribution around the isolated cylinder and side-by-side cylinders on the flat-plate at different angles-of-attack (AoA) and free stream conditions are investigated in a Mach 6 low noise wind tunnel, using nano-tracer-based planar laser scattering (NPLS) techniques and the temperature sensitive paint techniques. The results indicate that the interaction of the bow-shaped shock waves between adjacent cylinders generates an “X”-shaped high-heat-flux region, but this high-heat-flux region only appears near the intersection of the shock waves. Downstream of the shock wave intersection, due to the formation of low-density vortices structures between adjacent cylinders, a low-heat-flux region appears. Further downstream, the boundary layer reattaches, resulting in reattachment shock waves and high-heat-flux strips appearing on the wall surface. The NPLS results show that the horseshoe vortices/bow shock wave interaction between parallel cylinders will cause the position of the shock wave formed after the intersection to move forward and increase the thickness of the boundary layer and the number of low-density vortices structures, but the position of the reattached shock wave hardly changes. As the AoA decreases, the length of the low-heat-flux region between adjacent cylinders increases, and the reattachment position of the boundary layer shifts backward. Notably, the mutual influence between parallel cylinders mainly occurs in the outer horseshoe vortices region, while having a relatively small impact on the streamwise vortices directly behind the cylinders.

  • Influences of herringbone riblets on shock-wave/turbulent boundary layer interactions in supersonic compression-ramp flow

    by Zihao Ye, Xiwang Xu, Shihe Yi, Jiarui Liu, Zhen Zhang, Ruitong Zeng

    The influences of the herringbone riblets (HRs) on shock wave/turbulent boundary layer interactions in supersonic compression-ramp flow are investigated in a Mach 3.4 wind tunnel using high-speed schlieren, temperature-sensitive paint, oil-flow visualization, and nano-tracer planar laser scattering techniques. An array of protruding HRs and two arrays of different lengths sunken HRs are applied upstream of the interaction zone, respectively. It is revealed that all three HRs reduce the separation zone (by about 32.5% for the longest sunken HRs and 21.8% for protruding HRs) and make the separation/reattachment lines wavy, with their crests and troughs located downstream of HRs' convergent/divergent lines, respectively. Additionally, the protruding HRs enhance near-wall momentum stratification and achieve better flow separation control efficacy compared to the sunken HRs of equal length. Furthermore, the spectral proper orthogonal decomposition results suggest that protruding HRs amplify the energy peak of mode 1, while sunken HRs reduce it and modify its spectral distribution, with peak values decreasing as the sunken HRs get longer.


  • Influences of steps on hypersonic boundary layer instability over a cone at small angle of attack

    by Xiwang Xu, Shihe Yi, Yufa Hu, Zihao Ye, Lin He

    The influences of the forward-facing step (FFS) and backward-facing step (BFS) on the 7° half-angle cone's boundary layer instability at different meridians are investigated at Mach 6, with step heights of 0.6 mm, and a 1° angle of attack (AoA) in a hypersonic quiet wind tunnel using the Nano-tracer-based Planar Laser Scattering techniques, and high-frequency pressure sensors. The results show that at AoA = 1°, the instability that dominates conical boundary layer transition is the second-mode wave. At a given streamwise location, as the position approaches the centerline of the leeward side, the frequency of the second-mode wave decreases while its amplitude increases, resulting in a more unstable boundary layer. Moreover, the development of the second-mode waves in the BFS model progresses faster than that in the FFS model, at different meridians. Notably, on the leeward side, the FFS stabilizes the second-mode waves, whereas the BFS model destabilizes them.


  • Experimental study on influences of steps on hypersonic boundary layer transition at different angles-of-attack

    by Xiwang Xu, Zihao Ye, Shihe Yi, Yifei Xue, Zhi Chen

    The influences of the forward-facing step (FFS) and backward-facing step (BFS) on the 7° half-angle conical boundary layer instability and transition are investigated at different angles-of-attack (AoAs) in a hypersonic quiet wind tunnel using the Nano-tracer-based Planar Laser Scattering techniques, Temperature-Sensitive Paints, and high-frequency pressure sensors. The results show that the FFS stabilizes the second mode instability but strongly destabilizes the crossflow instability. Conversely, the BFS destabilizes both the second mode and crossflow instabilities, yet its impact on crossflow instability is weaker compared to that of an FFS with an identical height. At a small AoA (AoA < 3° in this paper), the boundary layer transition is dominated by the second mode instability. For sharp cones, the transition is delayed on the windward side but promoted on the leeward side, resulting in a monotonically inclined transition front. In contrast, blunt cones exhibit localized depressions in the transition front on the leeward side. At large AoA, the transition process is dominated by the crossflow instability, resulting in heat flux stripes on the leeward side, making the transition front distribution more complex. Therefore, at small AoAs, the promotion effect of the BFS on the conical boundary layer transition is stronger than that of the FFS with the same height. Moreover, the FFS with a small height even exhibits a suppressive effect on the transition. However, as the AoA increases, low-frequency instability modes, such as crossflow instability, gradually become dominant. Consequently, the promoting effect of the FFS surpasses that of the BFS.


  • Experimental Investigation of the Hypersonic Boundary-Layer Transition Induced by the Wall-Mounted Cylinder

    by Haoxi Xiong, Xiwang Xu, Shihe Yi, Liang Nie, Yu Li

    The flowfield structure, heat flux distribution, and pressure fluctuations of the wall-mounted cylinder-induced hypersonic boundary-layer transition are investigated at a 10 deg angle of attack. Experiments are conducted in a Mach 6 low-noise wind tunnel using the nanotracer-based planar laser scattering (NPLS) technique, temperature-sensitive paints (TSP), and high-frequency pressure sensors. First, the streamwise and spanwise NPLS images, TSP results, and power spectral density results of isolated cylinders at different heights show that with the increase of the cylinder height [ ], the size of the separated region and the spanwise width of the horseshoe vortex increase, and the transition moves forward. Second, the flowfield structure and wall heat flux distribution around the streamwise cylinder arrays are investigated. The results demonstrate that the downstream cylinder will destroy the development of the hairpin vortex in the upstream cylinder wake but will expand the horseshoe vortex to both sides, increasing the influence area of the cylinder.


  • Influence of RVGA’s height on suppressing the aero-optical effects induced by a supersonic mixing layer

    by Zi Hao Xia, Haolin Ding, Xi Wang Xu, Shihe Yi

    The supersonic mixing layer formed on the surface of hypersonic/supersonic flight vehicles’ optical windows is the main structure that induces aero-optical effects (AOEs), which may cause severe imaging degradation. Previous research has found that the ramp vortex generator array (RVGA) with a height of 1 mm can suppress the AOE of a M c = 0.17 supersonic mixing layer. In this paper, three RVGAs with different heights are considered. The nano-tracer-based planar laser scattering technique and ray tracing method are applied to do the aero-optical analysis. The root mean square of the optical path difference ( O P D r m s ), Strehl ratio (SR), imaging displacement (ID), and angle deviation (AD) are taken as evaluation parameters. It is found that a smaller aperture size ( A D ) corresponds to a better SR in the aperture size range of 5 m m ∼ 100 m m . Then a beam with an incident angle α = 15 ∘ and a 15 mm A D is used to study the influence of RVGA’s height on suppressing the AOE. When the RVGA is applied, the I D ¯ and A D ¯ (overline means time-averaged results) in different sections of the supersonic mixing layer are significantly normalized, which can simplify the AOE’s correction procedure. The higher the RVGA is, the more the O P D r m s ¯ is reduced and the weaker the AOE is. RVGA1 ( h = 1.2 m m ) has the best performance in suppression of the AOE because it introduces much more disturbance than RVGA2 ( h = 1.0 m m ) and RVGA3 ( h = 0.5 m m ) and achieves better inhibition of the formation and development of the K-H vortices and more reduction of the whole thickness of the supersonic mixing layer.