SPSatwik Priyadarshi

Satwik Priyadarshi

*This is an algorithmically generated author record based on publicly available information.

Satwik Priyadarshi has a total of 7 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Effects of Heat Treatment on the Surface Quality and Improvement in Formability of Deformation Machined Products of Al 6061

    by Ankit Kumar Gupta, Satwik Priyadarshi, Denis Pustovoytov, Manuele Dabala, Hailiang Yu, Alexander Pesin, Puneet Tandon

    Continuous efforts are being made to improve the technology and the process involved in part production to meet the demands of society. Advancements in machining, as well as incremental forming, resulted in the generation of a technology that is capable of manufacturing monolithic components in a single setup. Such hybrid technological development, called deformation machining (DM), has the milling process contributing to thin structure generation and single point incremental forming (SPIF) leading to the desired geometrical deformation. Machining a material block to produce thin structure results in unwanted residual stresses in the workpiece, which hinders the part’s formability during SPIF. In the current research, stress-relieve annealing of aluminum alloy (Al 6061) is done to compensate for these residual stresses. While doing so, the optimum temperature of reheating is identified, at which the strength of the selected material is not significantly compromised. For this, preliminary microstructural investigations are carried out on the machined components at different temperatures, followed by experimental investigations. The force measurement of different samples was done during the experiments for determining the effects of heat treatment. Geometrical observations suggest that heat treatment results in better forming depth and improved forming angle, however, an increase in surface roughness is observed on the heat-treated parts.


  • Comparative Study of Incremental Forming and Elevated Temperature Incremental Forming Through Experimental Investigations on AA 1050 Sheet

    by Swarit Anand Singh, Satwik Priyadarshi, Puneet Tandon

    Unlike conventional forming processes, incremental forming (IF) does not require any part-specific tooling. It is a flexible forming process that is suitable to form user-specific shapes and for low volume production. The IF process has been recognized as a promising manufacturing process over conventional forming for the materials having decent formability. However, it does not give reliable results while forming hard to form materials. A few investigations revealed that heat plays a vital role in enhancing the formability. On heating, the yield stress of the materials gets reduced, the ductility increases, and hence the formability improves. Thus, for the materials having poor formability, an advance IF technique, elevated temperature incremental forming (ET-IF), has been developed. ET-IF involves incremental forming of the sheets while being heated by an external heat supply. This research study focuses on the execution of the ET-IF process and its comparison with the conventional IF process. A radiation type heating device to perform the ET-IF process is designed and fabricated. The experimental investigations were carried out on 1 mm thick AA 1050 sheets by carrying out the IF process at room temperature and enhanced temperatures. Experimentation was initiated with performing straight grove tests, which were later extended to form a few more shapes. Experimental results confirm the delay in fracture and intensification of formability with the ET-IF process in comparison to that of the IF process at room temperature. The work overcomes the limitation and enlarges the scope of application of the IF process.