MFMaria Teresa Ferrandez-Garcia

Maria Teresa Ferrandez-Garcia

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Maria Teresa Ferrandez-Garcia has a total of 30 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Properties of Binderless Insulating Boards Made from Canary Island Date Palm and Cork Particles

    by Berta Elena Ferrandez-Garcia, Teresa Garcia-Ortuño, Manuel Ferrandez-Villena, Maria Teresa Ferrandez-Garcia

    Agglomerated cork is a natural cork that has gone through a process of crushing and pressing using heat and binders. One of its applications is thermal insulator in construction. The design of these materials is becoming an essential part of building. The raw materials currently used to make insulators consume a large amount of energy, which has created the need to increase the use of renewable and ecological resources such as plant fibers to reduce the environmental problems generated. The objective of this study was to determine the different properties of experimental particleboard panels made from cork and Canary Island date palms without using any binder at minimum energy consumption. The produced cork–palm boards (density of 850 kg/m3, reached a MOR 8.83 N/mm2, MOE 794.5 N/mm2, and IB 0.38 N/mm2) are higher values than the traditional cork particleboards with UF made from cork. The thermal conductivity values obtained 0.069 to 0.096 W/m·K are higher than cork boards with UF. Ecological boards that can be used as rigid thermal insulators in the construction industry have been achieved to improve the mechanical properties of the traditional agglomerated cork.


  • Open Access

    Evaluation of the Properties and Reaction-to-Fire Performance of Binderless Particleboards Made from Canary Island Palm Trunks

    by Berta Elena Ferrandez-Garcia, Teresa Garcia-Ortuño, Manuel Ferrandez-Villena, Maria Teresa Ferrandez-Garcia

    Repurposing agricultural and forestry by-products not only is beneficial for the environment but also follows the principles of the circular economy. In southeastern Spain, the Canary Island palm tree (Phoenix canariensis W.) is widely used in urban landscapes. Plantations affected by the red weevil, a pest, generate an abundance of plant waste that must be crushed and transferred to authorized landfills. The aim of this study was to manufacture boards using particles from trunks of the Canary Island palm tree without adding any binders in order to obtain an ecological and fire-resistant product. In order to manufacture the boards, three particle sizes (2, MOE of 2589.8 N/mm2, and IB of 0.74 N/mm2). Therefore, these manufactured particleboards could be used as a flame-retardant material for the interior enclosures of buildings (vertical and horizontal) without the need for coatings.


  • Open Access

    Assessment of the Properties of Giant Reed Particleboards Agglomerated with Gypsum Plaster and Starch

    by Maria Teresa Ferrandez-Garcia, Antonio Ferrandez-Garcia, Teresa Garcia-Ortuño, Manuel Ferrandez-Villena

    This paper analyzes the properties of composite particleboards made from a mix of giant reed with gypsum plaster and starch as binders. Experimental boards were manufactured with a 10:2 weight ratio of giant reed/gypsum plaster particles and different amounts of starch. Giant reed particles used were ≤0.25 mm. The mix was pressed at a temperature of 110 °C with a pressure of 2.6 MPa for 1, 2, and 3 h. The results showed that the boards manufactured with longer times in the press and with 10 wt.% starch achieved the best physical and mechanical properties, obtaining a modulus of rupture (MOR) of 17.5 N/mm2, a modulus of elasticity (MOE) of 3196 N/mm2, and an internal bounding strength (IB) of 0.62 N/mm2. Thickness swelling (TS) at 24 h of the panels was reduced from 36.16% to 28.37% when 10 wt.% starch was added. These results showed that giant reed–gypsum–starch particleboards can be manufactured with physical and mechanical properties that comply with European standards for use in building construction.


  • Open Access

    Acoustic and Thermal Properties of Particleboards Made from Mulberry Wood (Morus alba L.) Pruning Residues

    by Manuel Ferrandez-Villena, Antonio Ferrandez-Garcia, Teresa Garcia-Ortuño, Maria Teresa Ferrandez-Garcia

    The aim of this study was to determine the acoustic and thermal properties of particleboards made from mulberry wood pruning waste using urea formaldehyde resin (UF) as a binder. The investigation focused on the evaluation of the thermal conductivity and the acoustic absorption of the boards and the assessment of their feasibility for use in the construction sector. The mean thermal conductivity values of the particleboards (0.065–0.068 W/mK) were lower than those obtained in wood and similar to those in cork panels. The samples were tested with frequencies from 50 to 6300 Hz. In all cases, the results allowed us to conclude that they were better sound absorbers than commercial wood and plywood panels of the same average density for low frequencies, and with similar values for medium and high frequencies. The mechanical results reached the minimum requirement to be considered as boards for general use and, specifically with particles from 0.25 to 1.00 mm, for furniture according to European standards. The particle size of the particleboards was the variable that influenced all the acoustic properties, but did not affect the thermal conductivity. The experimental results indicated that the thermal and acoustic properties of these particleboards were promising for their application in commercial uses.


  • Open Access

    Influence of the Density in Binderless Particleboards Made from Sorghum

    by Antonio Ferrandez-Garcia, Maria Teresa Ferrandez-Garcia, Teresa Garcia-Ortuño, Manuel Ferrandez-Villena

    In order to fight climate change and decouple economic growth from material use, valorization of waste will be fundamental. Sorghum is one of the most important summer crops in the world. The non-edible parts of the plant, the stalks and leaves are left over and must be disposed of. This work proposes to use sorghum waste particles as a raw material to manufacture boards and analyze the influence of its density. Particles were sprayed with 10% wt of water and placed in a hot press at 2.1 MPa and 110 °C for 30 min. Eight types of panels were produced with densities ranging from 950 kg/m3 to 1250 kg/m3. The results indicated that the water absorption (WA), modulus of rupture (MOR), modulus of elasticity (MOE) and internal bounding strength (IB) depended on the density. With higher densities, the particleboards showed better physical and mechanical behavior. This study demonstrates that it is technically possible to manufacture adhesive-free particleboards from sorghum residues that comply with European standards and can be used as boards for general applications. The use of these particleboards could be beneficial in fighting climate change and in minimizing the use of natural wood.


  • Open Access

    Analysis of the Manufacturing Variables of Binderless Panels Made of Leaves of Olive Tree (Olea europaea L.) Pruning Waste

    by Antonio Ferrandez-Garcia, Maria Teresa Ferrandez-Garcia, Teresa Garcia Ortuño, Francisco Mata-Cabrera, Manuel Ferrandez-Villena

    While the construction industry consumes more raw materials than any other industrial sector, agriculture generates a large amount of waste that is not managed properly. The olive industry produces more than 7.5 million tons of waste that could be recovered. This paper presents a new method to valorize the leaves of olive tree pruning waste consisting of the manufacture of ecologic boards without adhesives by hot pressing. In order to analyze their influence, three manufacturing variables were varied to obtain the boards: leaf type (shredded and whole leaves), temperature (130, 140 and 150 °C) and time (4, and 12 min). Twenty-four boards were made and were then tested for their mechanical, physical and thermal properties according to the EN standards. The boards showed good results of thickness swelling (TS), water absorption (WA) and of thermal conductivity and can be used as an alternative for manufacturing thermal insulation boards. With a smaller particle size of shredded leaves, longer pressing times and higher pressing temperatures, the mechanical behavior of the boards could improve. The olive leaves are a low-cost renewable resource, and manufacturing products with a long, useful life can be beneficial to the environment.


  • Open Access

    Evaluation of Particleboards Made from Giant Reed (Arundo donax L.) Bonded with Cement and Potato Starch

    by Aranzazu Alejandra Ferrandez-García, Teresa Garcia Ortuño, Manuel Ferrandez-Villena, Antonio Ferrandez-Garcia, Maria Teresa Ferrandez-García

    There is a general concern about the rationalization of resources and the management of waste. Plant residues can contribute to the development of new non-polluting construction materials. The objective of this study was to valorize a plant residue such as the giant reed and obtain a particleboard with cement using potato starch as a plasticizer in a manufacturing process involving compression and heat. The influence of cement and starch in different proportions and its stability over time were analyzed. Finally, their physical and mechanical properties were evaluated and compared to European Standards. High-quality sustainable particleboards (boards with high structural performance) were obtained and can be classified as P6 according to European Standards. Mechanical properties were improved by increasing the starch content and pressing time, whereas greater resistance to water was obtained by increasing the cement content. Giant reed particles seem to tolerate the alkalinity of the cement since there was no sign of degradation of its fibers. The use of these residues in the manufacture of construction materials offers a very attractive alternative in terms of price, technology and sustainability.


  • Open Access

    Properties of Wood Particleboards Containing Giant Reed (Arundo donax L.) Particles

    by Manuel Ferrandez-Villena, Antonio Ferrandez-Garcia, Teresa Garcia-Ortuño, Clara Eugenia Ferrandez-Garcia, Maria Teresa Ferrandez Garcia

    Agriculture is responsible for generating large amounts of waste that are not adequately managed in terms of their environmental treatment and economic administration. This work uses giant reed, which was traditionally used as a construction material in eastern areas of Spain. Nowadays, it is no longer used, which has led to its rapid, autonomous, uncontrolled proliferation on river banks, making it a serious environmental hazard because this plant causes significant blockages of bridges and other infrastructure when uprooted by the strong currents that occur as rivers flood. The aim of this work is to develop wood and giant reed particleboards, which help to counter the high dependence on wood in industrial manufacturing by using an easily renewable resource. It will thereby be possible to achieve two general objectives: controlling the growth of a weed and obtaining a product (particleboards) from a waste material. Particleboards containing 9% urea formaldehyde composed of different proportions of sawmill wood and giant reed (0, 50, 70 and 100%) have been manufactured by applying two different pressures (2.1 and 2.6 MPa) and a temperature of 120 °C for 4 min in a hot plate press. Density, thickness swelling (TS) and water absorption (WA) after immersion in water, modulus of elasticity (MOE), modulus of rupture (MOR), internal bonding strength (IB) and screw holding strength (SH) have been tested according to european norms (EN) for wood boards. With the addition of 70% reed particles, the density, MOR and TS decrease and the MOE, IB and SH increase; therefore, adding giant reed particles to wood boards can improve their properties, bringing about considerable industrial and environmental benefits.


  • Open Access

    Assessment of the Physical, Mechanical and Acoustic Properties of Arundo donax L. Biomass in Low Pressure and Temperature Particleboards

    by Maria Teresa Ferrandez-García, Antonio Ferrandez-Garcia, Teresa Garcia-Ortuño, Clara Eugenia Ferrandez-Garcia, Manuel Ferrandez-Villena

    Traditionally, plant fibres have been used as a raw material for manufacturing construction materials; however, in the last century, they have been replaced by new mineral and synthetic materials with manufacturing processes that consume a large amount of energy. The objective of this study was to determine the mechanical, physical and acoustic properties of panels made from giant reed residues. The article focuses on evaluating the acoustic absorption of the boards for use in buildings. The materials used were reed particles and urea–formaldehyde was used as an adhesive. The panels were produced with three particle sizes and the influence that this parameter had on the properties of the board was evaluated. To determine the absorption coefficient, samples were tested at frequencies ranging from 50 to 6300 Hz. The results showed that the boards had a medium absorption coefficient for the low and high frequency range, with significant differences depending on the particle size. The boards with 2–4 mm particles could be classified as Class D sound absorbers, while boards with particle sizes of 0.25–1 mm showed the greatest sound transmission loss. Unlike the acoustic properties, the smaller the particle size used, the better the mechanical properties of the boards. The results showed that this may be an appropriate sound insulation material for commercial use.


  • Open Access

    Influence of Particle Size on the Properties of Boards Made from Washingtonia Palm Rachis with Citric Acid

    by Maria Teresa Ferrandez-Garcia, Antonio Ferrandez-Garcia, Teresa Garcia-Ortuño, Clara Eugenia Ferrandez-Garcia, Manuel Ferrandez-Villena

    The manufacture of technical materials of mineral and synthetic origin currently used for thermal insulation in buildings consumes a large amount of energy and they are not biodegradable. In order to reduce the environmental problems generated by their manufacture, an increasing amount of research is being carried out on the use of renewable and ecological resources. Consequently, the use of plant fibers and natural adhesives in the development of new thermal insulating products is increasing worldwide. Palm trees were used as a replacement for wood in some traditional constructions in places with scarce wood resources. This paper discusses the use of palm pruning waste in the manufacture of particleboards, using citric acid as a natural binder. Five particle sizes of Washingtonia palm rachis were used as the raw material for manufacturing the boards and the citric acid content was set at 10% by weight, in relation to the weight of the rachis particles. Single-layer agglomerated panels were made, applying a pressure of 2.6 MPa and a temperature of 150 °C for 7 min. Twenty panels were produced and their density, thickness swelling, water absorption, modulus of rupture, internal bonding strength and thermal conductivity properties were studied. Smaller particle size resulted in better mechanical properties. The boards had an average thermal conductivity of 0.084 W/m·K, meaning that these boards could be used for thermal insulation in buildings.