Dmitry Oshmarin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Dmitry Oshmarin has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Filippo Capolino
University of California
4 shared publications - Mohamed A. K. Othman
SLAC National Accelerator Laboratory, Stanford University , Menlo Park, California 94025, USA
2 shared publications - Ahmad T. Almutawa
Department of Electrical Engineering and Computer Science, University of California, Irvine, California 92697, USA
1 shared publication - Ahmed Abdelshafy Abdelshafy
Department of Electrical Engineering and Computer Science, University of California, Irvine, CA, USA
1 shared publication - Alireza Nikzamir
Department of Electrical Engineering and Computer Science, University of California, Irvine, California 92697, USA
1 shared publication Farshad Yazdi
Department of Electrical Engineering and Computer Science University of California Irvine CA 92697 USA
1 shared publication
Latest Publications
- 27 June 2022
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 17 (6) , 064049
Sixth-Order Degenerate Band Edge in Coupled Microstrip Waveguides
We show the physical realization and experimental demonstration of an exceptional point of sixth-order degeneracy in a triple-ladder (or three-way) microwave waveguide realized using three coupled microstrips on a grounded dielectric substrate. This three-way waveguide supports six Bloch eigenmodes, and all coalesce into a degenerate single eigenmode at a given frequency. The three-way waveguide is gainless, and this exceptional point is associated with a vanishing-group velocity and its multiple derivatives. Indeed, the dispersion diagram that we call the sixth-order degenerate band edge (6DBE) has six coalescing branches. We provide experimental verification of a sixth-order exceptional point by evaluating the degenerate wave number–frequency-dispersion diagram from the measurement of scattering parameters of a six-port unit cell. We also show the resonant behavior of a cavity made of the three-way waveguide with finite length. The unique properties of 6DBE can be exploited to design innovative high-Q resonators, oscillators, filters, and pulse-shaping devices.- 27 June 2022
- Published by American Physical Society (APS) in Physical Review Applied
- Vol. 17 (6) , 064049
Sixth-Order Degenerate Band Edge in Coupled Microstrip Waveguides
We show the physical realization and experimental demonstration of an exceptional point of sixth-order degeneracy in a triple-ladder (or three-way) microwave waveguide realized using three coupled microstrips on a grounded dielectric substrate. This three-way waveguide supports six Bloch eigenmodes, and all coalesce into a degenerate single eigenmode at a given frequency. The three-way waveguide is gainless, and this exceptional point is associated with a vanishing-group velocity and its multiple derivatives. Indeed, the dispersion diagram that we call the sixth-order degenerate band edge (6DBE) has six coalescing branches. We provide experimental verification of a sixth-order exceptional point by evaluating the degenerate wave number–frequency-dispersion diagram from the measurement of scattering parameters of a six-port unit cell. We also show the resonant behavior of a cavity made of the three-way waveguide with finite length. The unique properties of 6DBE can be exploited to design innovative high-Q resonators, oscillators, filters, and pulse-shaping devices.- 17 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 69 (1) , 35-39
Low Phase Noise Oscillator Design Using Degenerate Band Edge Ladder Architectures
A new approach based on a strong degeneracy state to design oscillators that exhibit low phase noise and low power consumption is presented. A 100-MHz oscillator is designed using a periodic structure based on a degenerate band edge that is augmented with an NMOS cross-coupled pair. The analysis and simulation results show 16 dB phase noise improvement compared to oscillators based on a conventional single-ladder periodic structure. It is also shown that this oscillator dissipates less power than a conventional LC oscillator that requires a buffer to drive a 50Ω load.
- 17 June 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 69 (1) , 35-39
Low Phase Noise Oscillator Design Using Degenerate Band Edge Ladder Architectures
A new approach based on a strong degeneracy state to design oscillators that exhibit low phase noise and low power consumption is presented. A 100-MHz oscillator is designed using a periodic structure based on a degenerate band edge that is augmented with an NMOS cross-coupled pair. The analysis and simulation results show 16 dB phase noise improvement compared to oscillators based on a conventional single-ladder periodic structure. It is also shown that this oscillator dissipates less power than a conventional LC oscillator that requires a buffer to drive a 50Ω load.
- 1 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1181-1182
Pulse Generation using a Degenerate Band Edge Structure
We propose a pulse generation scheme based on a fourth-order degeneracy in the dispersion relation. We take advantage of the loaded quality factor enhancement and the ultra-sensitivity to external perturbations due to the high order degeneracy in such a structure. The proposed scheme is able to produce a train of nanosecond pulses with several watts of output power. Such a design offers a flexibility that allows to conceive either high output power pulses or high frequency train of pulses.
- 1 July 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1181-1182
Pulse Generation using a Degenerate Band Edge Structure
We propose a pulse generation scheme based on a fourth-order degeneracy in the dispersion relation. We take advantage of the loaded quality factor enhancement and the ultra-sensitivity to external perturbations due to the high order degeneracy in such a structure. The proposed scheme is able to produce a train of nanosecond pulses with several watts of output power. Such a design offers a flexibility that allows to conceive either high output power pulses or high frequency train of pulses.
- Open Access
- 1 July 2019
- Published by Institution of Engineering and Technology (IET) in IET Circuits, Devices & Systems
- Vol. 13 (7) , 950-957
New oscillator concept based on band edge degeneracy in lumped double‐ladder circuits
An oscillator scheme based on the degenerate band edge (DBE) in a periodic, double‐ladder resonant circuit made of lumped elements is proposed for the first time. The circuit exhibits a DBE in the dispersion diagram of its phase‐frequency eigenstates and possesses unique resonance features associated with a high loaded Q ‐factor resonance, compared to a single‐ladder circuit. This oscillator is shown to have an oscillation threshold that is half that of a single LC ladder circuit having the same total quality factor, and thus is more robust than an LC oscillator in the presence of losses. Moreover, the double‐ladder oscillators have a unique mode selection scheme that leads to stable single‐frequency oscillations even when the load is varied. It is also shown that the output amplitude of the double‐ladder oscillator is much less sensitive to the output loading compared to single‐ladder oscillators. The authors show the analysis and design of such oscillators that potentially lead to enhancing the efficiency of RF components and sources.
- 1 July 2019
- Published by Institution of Engineering and Technology (IET) in IET Circuits, Devices & Systems
- Vol. 13 (7) , 950-957
Open AccessNew oscillator concept based on band edge degeneracy in lumped double‐ladder circuits
An oscillator scheme based on the degenerate band edge (DBE) in a periodic, double‐ladder resonant circuit made of lumped elements is proposed for the first time. The circuit exhibits a DBE in the dispersion diagram of its phase‐frequency eigenstates and possesses unique resonance features associated with a high loaded Q ‐factor resonance, compared to a single‐ladder circuit. This oscillator is shown to have an oscillation threshold that is half that of a single LC ladder circuit having the same total quality factor, and thus is more robust than an LC oscillator in the presence of losses. Moreover, the double‐ladder oscillators have a unique mode selection scheme that leads to stable single‐frequency oscillations even when the load is varied. It is also shown that the output amplitude of the double‐ladder oscillator is much less sensitive to the output loading compared to single‐ladder oscillators. The authors show the analysis and design of such oscillators that potentially lead to enhancing the efficiency of RF components and sources.