Amr I. Eissa
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Amr I. Eissa has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Ian Galton
Electrical and Computer Engineering Department, University of California at San Diego, La Jolla, CA, USA
5 shared publications - Enrique Alvarez-Fontecilla
Analog Devices Inc., Santiago, Chile
4 shared publications - Eslam Helal
Department of Electrical and Computer Engineering, University of California at San Diego, La Jolla, CA, USA
4 shared publications Colin Weltin-Wu
Aeonsemi, Inc., Santa Clara, CA, USA
2 shared publications
Latest Publications
- 28 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (10) , 4524-4537
A Duty-Cycle-Error-Immune Reference Frequency Doubling Technique for Fractional-N Digital PLLs
Increasing a PLL’s reference frequency offers significant performance advantages, but doing so by increasing the PLL’s crystal oscillator frequency is not a viable option in many applications. Instead, a frequency doubler can be used to derive a reference signal with twice the frequency of the crystal oscillator, but conventional PLLs are highly sensitive to the crystal oscillator’s duty cycle error in such cases. Prior solutions to this problem involve calibration techniques which impose convergence speed versus accuracy tradeoffs. In contrast, this paper proposes a system modification which makes a PLL immune to such duty cycle errors without the need for calibration. The technique is presented and analyzed in the context of a delta-sigma frequency-to-digital converter ( $\Delta \Sigma $ -FDC) based PLL. Analysis and behavioral simulations with nonideal circuit parameters show that the worst-case convergence time is at least 10 times faster than that of the prior techniques. Additionally, the proposed $\Delta \Sigma $ -FDC includes other modifications which improve its performance relative to comparable prior $\Delta \Sigma $ -FDCs.
- 28 August 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 71 (10) , 4524-4537
A Duty-Cycle-Error-Immune Reference Frequency Doubling Technique for Fractional-N Digital PLLs
Increasing a PLL’s reference frequency offers significant performance advantages, but doing so by increasing the PLL’s crystal oscillator frequency is not a viable option in many applications. Instead, a frequency doubler can be used to derive a reference signal with twice the frequency of the crystal oscillator, but conventional PLLs are highly sensitive to the crystal oscillator’s duty cycle error in such cases. Prior solutions to this problem involve calibration techniques which impose convergence speed versus accuracy tradeoffs. In contrast, this paper proposes a system modification which makes a PLL immune to such duty cycle errors without the need for calibration. The technique is presented and analyzed in the context of a delta-sigma frequency-to-digital converter ( $\Delta \Sigma $ -FDC) based PLL. Analysis and behavioral simulations with nonideal circuit parameters show that the worst-case convergence time is at least 10 times faster than that of the prior techniques. Additionally, the proposed $\Delta \Sigma $ -FDC includes other modifications which improve its performance relative to comparable prior $\Delta \Sigma $ -FDCs.
- 15 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 69 (12) , 4993-5006
DTC Linearization via Mismatch-Noise Cancellation for Digital Fractional-N PLLs
Digital-to-time converter (DTC) based quantization noise cancellation (QNC) has recently been shown to enable excellent fractional- $N$ PLL performance, but it requires a highly-linear DTC. Known DTC linearization strategies include analog-domain techniques which involve performance tradeoffs and digital predistortion techniques which converge slowly relative to typical required PLL settling times. Alternatively, a DTC implemented as a cascade of 1-bit DTC stages can be made highly linear without special techniques, but such DTCs typically introduce excessive error from component mismatches which has so far hindered their use in low-jitter PLLs. This paper presents a background calibration technique that addresses this issue by adaptively canceling error from DTC component mismatches. The technique is entirely digital, is compatible with a large class of digital fractional- $N$ PLLs, and has at least an order of magnitude lower convergence time than the above-mentioned predistortion techniques. The paper presents a rigorous theoretical analysis closely supported by simulation results which quantifies the calibration technique’s convergence time and noise performance.
- 15 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 69 (12) , 4993-5006
DTC Linearization via Mismatch-Noise Cancellation for Digital Fractional-N PLLs
Digital-to-time converter (DTC) based quantization noise cancellation (QNC) has recently been shown to enable excellent fractional- $N$ PLL performance, but it requires a highly-linear DTC. Known DTC linearization strategies include analog-domain techniques which involve performance tradeoffs and digital predistortion techniques which converge slowly relative to typical required PLL settling times. Alternatively, a DTC implemented as a cascade of 1-bit DTC stages can be made highly linear without special techniques, but such DTCs typically introduce excessive error from component mismatches which has so far hindered their use in low-jitter PLLs. This paper presents a background calibration technique that addresses this issue by adaptively canceling error from DTC component mismatches. The technique is entirely digital, is compatible with a large class of digital fractional- $N$ PLLs, and has at least an order of magnitude lower convergence time than the above-mentioned predistortion techniques. The paper presents a rigorous theoretical analysis closely supported by simulation results which quantifies the calibration technique’s convergence time and noise performance.
- Open Access
- 12 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (10) , 3191-3201
Spectral Breathing and Its Mitigation in Digital Fractional-N PLLs
Although digital phase-locked loops (PLLs) offer several advantages over their analog counterparts, they suffer from a major disadvantage that is rarely mentioned in published articles. The disadvantage, known as spectral breathing, is caused by component mismatches among the frequency control elements within a PLL’s digitally controlled oscillator (DCO). The mismatches introduce DCO frequency modulation nonlinearity which fluctuates and, therefore, causes erratic variations in the PLL’s measured phase noise spectrum as the DCO’s free-running frequency drifts. The phenomenon is called spectral breathing because the measured phase noise spectrum tends to slowly swell and contract over time as if taking breaths of air. During these breaths, the PLL’s phase noise often becomes severely degraded. This article presents an experimental demonstration of the spectral breathing phenomenon and its solution in a digital fractional- $N$ PLL. The demonstrated solution is a multi-rate dynamic element matching technique and a mismatch-noise cancellation technique that together eliminate spectral breathing.
- 12 May 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (10) , 3191-3201
Open AccessSpectral Breathing and Its Mitigation in Digital Fractional-N PLLs
Although digital phase-locked loops (PLLs) offer several advantages over their analog counterparts, they suffer from a major disadvantage that is rarely mentioned in published articles. The disadvantage, known as spectral breathing, is caused by component mismatches among the frequency control elements within a PLL’s digitally controlled oscillator (DCO). The mismatches introduce DCO frequency modulation nonlinearity which fluctuates and, therefore, causes erratic variations in the PLL’s measured phase noise spectrum as the DCO’s free-running frequency drifts. The phenomenon is called spectral breathing because the measured phase noise spectrum tends to slowly swell and contract over time as if taking breaths of air. During these breaths, the PLL’s phase noise often becomes severely degraded. This article presents an experimental demonstration of the spectral breathing phenomenon and its solution in a digital fractional- $N$ PLL. The demonstrated solution is a multi-rate dynamic element matching technique and a mismatch-noise cancellation technique that together eliminate spectral breathing.
- 2 February 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (9) , 2711-2723
A Time Amplifier Assisted Frequency-to-Digital Converter Based Digital Fractional-N PLL
This article presents a wide input-range delay chain based time amplifier (TA) and its application to a 6.5-GHz digital fractional- N phase-locked loop (PLL). The TA includes a delay-averaging linearity enhancement technique and the PLL is based on an improved dual-mode ring oscillator (DMRO) delta-sigma (ΔΣ) frequency-to-digital converter (FDC). The TA mitigates contributions to the PLL's phase noise from DMRO flicker noise, which would otherwise degrade the PLL's in-band phase noise, and from ΔΣ FDC quantization error, which would otherwise degrade the PLL's phase noise at high bandwidth settings. This paper also presents a delay-free asynchronous DMRO phase sampling scheme, and the first experimental demonstration of a recently-proposed ΔΣ FDC digital gain calibration technique. The TA-assisted PLL achieves a random jitter of 145 fs rms , a total jitter that ranges from 151 to 270 fs rms as a result of fractional spurs, and a worst-case fractional spur of -49 dBc without requiring nonlinearity calibration.
- 2 February 2021
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 56 (9) , 2711-2723
A Time Amplifier Assisted Frequency-to-Digital Converter Based Digital Fractional-N PLL
This article presents a wide input-range delay chain based time amplifier (TA) and its application to a 6.5-GHz digital fractional- N phase-locked loop (PLL). The TA includes a delay-averaging linearity enhancement technique and the PLL is based on an improved dual-mode ring oscillator (DMRO) delta-sigma (ΔΣ) frequency-to-digital converter (FDC). The TA mitigates contributions to the PLL's phase noise from DMRO flicker noise, which would otherwise degrade the PLL's in-band phase noise, and from ΔΣ FDC quantization error, which would otherwise degrade the PLL's phase noise at high bandwidth settings. This paper also presents a delay-free asynchronous DMRO phase sampling scheme, and the first experimental demonstration of a recently-proposed ΔΣ FDC digital gain calibration technique. The TA-assisted PLL achieves a random jitter of 145 fs rms , a total jitter that ranges from 151 to 270 fs rms as a result of fractional spurs, and a worst-case fractional spur of -49 dBc without requiring nonlinearity calibration.
- 21 December 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 68 (3) , 965-974
Delta-Sigma FDC Enhancements for FDC-Based Digital Fractional-N PLLs
This paper describes all-digital enhancements for digital fractional-${N}$ phase-locked loops (PLLs) based on delta-sigma ($\Delta \Sigma $ ) frequency-to-digital converters (FDCs). The enhancements include an improved dual-mode ring oscillator (DMRO)-based$\Delta \Sigma $ FDC architecture and a digital background calibration technique that compensates for the$\Delta \Sigma $ FDC’s forward path gain error. The improved$\Delta \Sigma $ FDC has significantly relaxed timing constraints and a$3\times $ smaller phase-frequency detector output pulse-width span relative to the prior art, which make it simpler to implement and amenable to higher-frequency reference signals. The calibration technique compensates for non-ideal DMRO frequencies in the digital domain. It eliminates the need to tune the DMRO instantaneous frequencies as a function of the PLL output frequency, thereby simplifying the DMRO implementation, and it also improves the phase noise performance of PLLs with high loop bandwidths.- 21 December 2020
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 68 (3) , 965-974
Delta-Sigma FDC Enhancements for FDC-Based Digital Fractional-N PLLs
This paper describes all-digital enhancements for digital fractional-${N}$ phase-locked loops (PLLs) based on delta-sigma ($\Delta \Sigma $ ) frequency-to-digital converters (FDCs). The enhancements include an improved dual-mode ring oscillator (DMRO)-based$\Delta \Sigma $ FDC architecture and a digital background calibration technique that compensates for the$\Delta \Sigma $ FDC’s forward path gain error. The improved$\Delta \Sigma $ FDC has significantly relaxed timing constraints and a$3\times $ smaller phase-frequency detector output pulse-width span relative to the prior art, which make it simpler to implement and amenable to higher-frequency reference signals. The calibration technique compensates for non-ideal DMRO frequencies in the digital domain. It eliminates the need to tune the DMRO instantaneous frequencies as a function of the PLL output frequency, thereby simplifying the DMRO implementation, and it also improves the phase noise performance of PLLs with high loop bandwidths.