MGMarcel R. A. van Gent

Marcel R. A. van Gent

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Marcel R. A. van Gent has a total of 62 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Wave Energy Transfer in Shallow Water: Numerical Investigation of Slope and Offshore Wave Condition Effects

    by M. P. de Ridder, P. Mares‐Nasarre, M. R. A. van Gent

    This study advances the understanding of nonlinear wave interactions in shallow water by numerically quantifying how foreshore slope and offshore conditions influence energy transfer and wave evolution over a broad range of conditions. Two non‐hydrostatic models, SWASH and XBeach, are validated against physical experiments and applied across a wide range of conditions. The two‐layer SWASH model accurately reproduces wave parameters, third‐order statistics, and nonlinear energy transfer. Results show that the relative water depth , the offshore wave steepness and the Iribarren number are key parameters for describing the interaction strength and biphase behavior. The slope mainly affects high‐frequency biphase behavior, whereas for the other nonlinear interactions it primarily alters the magnitude of the energy transfer. For smaller than 0.2, low‐frequency energy is redistributed toward higher frequencies within the surf zone, while low‐frequencies at steeper slopes only receive energy. In shallow water , energy transfer to higher and lower frequencies is not dominated solely by primary wave interactions. Triads involving two high‐frequency components and one low‐frequency component play a major role, alongside interactions of one low‐frequency component with two primary components. Consequently, milder slopes increase low‐frequency wave height contributions up to 60%, whereas steeper slopes result in 20%–40% for the studied conditions. High‐frequency contributions remain relatively stable across profiles and offshore conditions, accounting for approximately 60%–70% of total wave height in shallow water.


  • Open Access

    Maximum influence of wind on wave overtopping at rubble mound breakwaters under oblique wave attack

    by Maria Sklia, Marcel R.A. Van Gent

    Especially for coastal structures with a protruding crest wall, wind affects wave overtopping because the crest wall can cause a vertical wave motion above the crest that is susceptible to wind. Earlier studies indicate that wind can increase wave overtopping discharges up to about a factor 5 for coastal structures under perpendicular wave attack. This study investigates the maximum influence of wind on wave overtopping at rubble mound structures under oblique wave attack. To analyse the influence of the wave angle on the maximum influence of wind on wave overtopping, physical model tests in a wave basin have been performed. The maximum influence of wind is determined by the assumption that all water that exceeds the top of the crest wall would be blown over the crest by onshore wind. The ratio of the total overtopping volume with onshore wind and the total overtopping volume for the same wave condition without wind, provides the maximum influence factor of wind. To obtain the volume of water that exceeds the top of the crest wall, a rotating paddle wheel is employed that transports all water reaching the top of the crest wall to the leeside of the structure. In addition to earlier studies on the influence of wind on wave overtopping not only the effect of oblique waves on wave overtopping discharges is investigated, also the effect of wind on overtopping volumes in individual overtopping events is analysed.Results show that also for oblique wave incidence, the effect of onshore wind can increase the amount of overtopping significantly. It is confirmed that the influence of wind is more pronounced in conditions with low overtopping discharges. This trend has shown to be accurate for the description not only of the mean overtopping discharge, but also of individual overtopping events.Based on the present tests, the method to account for the maximum influence of wind on wave overtopping discharges has been extended by incorporating the effects of oblique waves. Using this in combination with existing methods to estimate wave overtopping in absence of wind, enables estimates of the actual wave overtopping in real life situations.

  • Open Access

    Influence of IG waves on rock armour stability in shallow water

    by Giulio Scaravaglione, Marcel Van Gent, Jeffrey A. Melby, Amir Etemad-Shahidi, Alessandra Saponieri

    Rock armour stability of rubble mound breakwaters in shallow water is strongly influenced by depth-limited wave breaking and spectral transformations over the foreshore. In very and extremely shallow conditions, substantial infragravity wave energy exists that significantly affects spectral wave period (e.g., Tm-1,0) and wave steepness. This study investigates the sensitivity of stability predictions to spectral cutoff frequency based on 33 physical model tests spanning intermediate to extremely shallow water regimes. High-pass filters defined as fractions of the offshore peak frequency are applied, and several shallow water stability formulations are evaluated, including refitting of empirical coefficients and steepness exponents. Results show that excluding IG energy does not improve predictive performance. Instead, spectral truncation introduces depth-dependent bias and increased scatter under strongly depth-limited conditions. Findings demonstrate that IG waves contribute to the effective hydraulic loading acting on the armour layer. For design applications in shallow water, full-spectrum wave parameters should therefore be retained to ensure consistency with the underlying physical processes.

  • Open Access

    Guidelines on wave overtopping discharges at rubble mound breakwaters including slope angle effects

    by Marcel R.A. Van Gent, Jaap Van Marrewijk, Patricia Mares-Nasarre

    Mean wave overtopping discharges at rubble mound breakwaters were measured in a wave flume for various rock-armoured slopes. In the physical model tests, the structure slope was varied: 1:1.5, 1:2, 1:4, 1:6 and 1:8 slopes were studied. The mean wave overtopping discharges appeared to be strongly dependent on the structure slope for both “breaking waves” and for “non-breaking waves”. Existing expressions that also account for friction, a berm (if present), a protruding crest wall (if present), and the angle of wave attack, were extended by incorporating both the slope angle and the wave steepness of the incident waves at the toe. The match between the empirical equations and the data (new and earlier tests) is good. The guidelines to estimate wave overtopping discharges as presented here perform much better than existing guidelines since most existing guidelines for rubble mound breakwaters ignore the explicit influence of the structure slope and the wave steepness. Both for “breaking waves” and for “non-breaking waves”, the structure slope and the wave steepness clearly affect wave overtopping discharges, and therefore expressions that ignore these effects should not be used if accurate estimates of mean wave overtopping discharges are required.

  • Open Access

    WIND EFFECTS ON WAVE OVERTOPPING DISCHARGES AT DIKES AND BREAKWATERS WITH A CREST WALL

    by Marcel R.A. van Gent, Ruben J. van der Bijl, Sam J. Dijkstra, Lars F. van Vliet, Davide Wüthrich

    Estimates of wave overtopping generally determine the required crest level of coastal structures. Wind affects wave overtopping, especially for coastal structures with crest walls because these can cause a vertical wave motion above the crest that is susceptible to wind. Within the relevant range of overtopping discharges, the expected wave overtopping discharge at coastal structures with a crest wall can be up to 5 times larger than for situations without wind. For smaller discharges the influence factor for wind can be significantly larger. In the present study based on physical model tests the maximum influence of wind on wave overtopping discharges has been studied for (impermeable) dikes and (permeable) rubble mound breakwaters with crest walls. The influence of wind on wave overtopping is mainly determined by the magnitude of the overtopping discharge itself and by the height of the crest wall. The result of the study is a guideline to estimate the maximum influence of wind on wave overtopping at dikes and rubble mound breakwaters with a crest wall.


  • Open Access

    STABILITY OF HIGH DENSITY CUBES ON BREAKWATER ROUNDHEADS

    by Yalcin Yuksel, Esin Cevik, Marcel van Gent, Cihan Sahin, Mehmet Ozturk, Anil Ari Guner, Baran Polat, Burak Rehber, Chingiz Mustafazade, Umutcan İnAl, et al.

    Due to the three-dimensional flow field formed by the diffraction and refraction effects of waves in breakwaters, the stability of the armour layer of roundheads is more critical than the trunk sections. For this reason, roundheads require heavier units or a gentler slope. In this research, the stability of breakwater roundheads consisting of high-density cube blocks in a single layer under the influence of wind and swell waves was examined.

  • Open Access

    Structural and hydraulic response of emerged low-crested cube-armoured breakwaters

    by Yalcin Yuksel, Esin Cevik, Cihan Sahin, Marcel R.A. van Gent, Serhat Gumus, Duygu Issever, Umutcan Inal, Mehmet Utku Ogur


  • Open Access

    Overtopping Reduction By Artificial Reefs

    by Vera M. VAN Bergeijk, Alex Capel, Florine Speth, Marcel R.A. VAN Gent

    Artificial or Engineered reefs are primarily developed for enhancing the ecological system. In Guidelines for the Placement of Artificial Reefs (UNEP, 2009) they are described as "An artificial reef is a submerged structure deliberately constructed or placed on the seabed to emulate some functions of a natural reef such as protecting, regenerating, concentrating, and/or enhancing populations of living marine resources." Often these artificial reefs have either a complex shape inspired by biomimicry (e.g. Coastruction) or a more regular shape, designed to function as modular blocks that can be easily placed on top of each other (e.g. Reefy). In many parts of the world, application of these engineered elements on top of existing shallow reefs may be a solution to not only enhance the ecosystem but also to increase the safety level of the hinterland. Also, in light of climate change and further increasing water levels, the artificial reefs may be a valuable alternative to reduce wave overtopping and prevent the land for extreme flooding. To quantify the possible effect of such artificial reefs in more shallower areas, physical model testing have been performed in which both overtopping was measured with and without the use of engineered elements. Shallow water depths have been chosen here, since the reef should induce wave breaking, resulting in the wave energy to decrease. The performance of these engineered elements in relation to its submergence has been investigated and a reduction coefficient has been developed.

  • Open Access

    Submerged low-crested structures in front of coastal structures

    by Marcel R.A. Van Gent

    Climate adaptation of coastal structures has become more important due to climate change, resulting in sea level rise and increased wave loading on coastal structures with depth-limited wave conditions. One of the climate adaptation measures to ensure that existing coastal structures continue to perform their function after unforeseen sea level rise, is to reduce the wave loading before the waves reach the existing coastal structure. This can be achieved by constructing a low-crested structure in front of the existing structure. Between the two structures, structure-induced wave set-up occurs. This structure-induced wave set-up has been studied based on wave flume tests. The effects of structure-induced wave set-up on wave transmission at the low-crested structures and the effects on wave overtopping at the emerged coastal structures were also measured and analyzed.The structure-induced wave set-up depends on the freeboard, wave steepness, and permeability of the low-crested structure. For configurations with impermeable low-crested structures, this wave-set-up does not depend on the distance between the two structures. Empirical expressions to estimate structure-induced wave set-up are derived for impermeable and permeable low-crested structures.The measurements indicate that the effect of structure-induced wave set-up on the wave transmission coefficients is negligibly small.The structure-induced wave set-up increases the wave overtopping discharges at the emerged coastal structure. This effect can be taken into account in wave overtopping estimates by reducing the freeboard with the structure-induced wave set-up.